Question about Cars & Trucks

Open Question

Trying get ahold of troubleshooters. 3614629177

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

95 jgc starts then stalls


Take it to a properly qualified and licensed mechanic you know and trust.

Nov 10, 2013 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Trying to get a fuel filter out of my 1998 Olds Cutlass 3.1 V-6. How? I have tried every tool on my garage to grab ahold of it. What do i need to use? I have already depressured it


your filter should have one side that uses two wrenches and the second side that has a white plastic retainer known as a quick disconnect pinch the two tabs and pull the line back. the tabs stay on the filter not the line.

Nov 05, 2013 | Cars & Trucks

1 Answer

Trying to release parking brake cable so i can remove rear drums


grap ahold of the cable where the inner cable is exposed and pull hard on it. Sometimes this will help if it's binding up. You may have a rusty lip on the outer part of the brake drums, and that's why they won't come off. In bad cases of this, I have cut the drums off with a small grinder and replaced them.

Feb 23, 2010 | Chevrolet Suburban 1500 Cars & Trucks

1 Answer

Driver door won't open from inside or out. All


most of the time when this happens you have something wrong with the door latch instide the door... the peice the hooks the post .
you will need to go inside the car with a thin rod bend the end into a sharp S shape try to get ahold of the green plastic clip and push or pull depending on the latch type... once you get the door open you will have to replace the latch unless the rods on the inside have just come loose, or most of the time the lock part to the latch is broken and you will have to get ahold of the lock part with your rod you made to get it to unlock... hope this helps you a bit.

Aug 18, 2009 | 1998 Ford Contour

1 Answer

Ignition mechanism was removed by someone trying to steal my vehicle how much is the repair going to cost


Normaly when these FOLKS Get Ahold of the IGN. they DESTROY the STEERING COLLUM & Components Beyond Repair, I Always REPLACE the Entire Collum to Insure No FAILURES Down the Road.

Aug 12, 2009 | 1997 Dodge Caravan

1 Answer

Spring loaded tie rods


quck way to test a tie rod is to jack up the vehicle.... grab ahold of the wheel and try to move it side to side.... any play there ... it's likely a tie rod... up and down play is a ball joint

Jan 02, 2009 | 2002 Ford Taurus

1 Answer

Trying to replace the serpentine belt on a 1995 gmc van


you will have to get ahold of a book for it or go to a junkyard and find one like yours and get the belt routing decal

Nov 12, 2008 | GMC Vandura Cars & Trucks

1 Answer

Service


wireset,distribuitor cap, distribuitor rotor, pcv valve,fuel filter, air filter

Oct 29, 2008 | 1993 Toyota Camry V6

1 Answer

Vacuum hose


if you get ahold of kragen they can help you with this

Aug 12, 2008 | 1991 Oldsmobile Cutlass Supreme

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...