Question about 2006 Chrysler 300 C

1 Answer

2006 300C 5.7 hemi stalls at idle or when stopping at light. Starts up but takes a few seconds for trans to kick in. Keeping rpm over 800 rpm car does not stall

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 169 Answers

Check o2 sensor. may have a short or damage

Posted on Jan 02, 2017

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi, I recently been have a problem with my 1998 Honda, passport. While driving my Honda it would shut down then starts again on its own while rolling. At times it would not start again on its own you need...


sure, rolling in gear you mean. (same effect as push starting a car with M/T) what speed did it restart, 5mph or 50 or 85mph.?)
what transmission. A/T or M/T? BEG ERROR there !

shut down,?
you mean stalls,
and engine can do 3 things
run too slow (way below 800RPM idle , illegal idle speeds)
stalls (rpm goes to zero or you find zero power from the engine )
if you stop the car, and the engine stalls that is an engine stall.

or run perfectly.

does your model have a tachometer to you can see RPM?
and if idle controls work,
not posting the trans type, (non body does here) makes answers near impossible. infact most will just ignore you posts.

with a M?T car the engine immediately returns (hot ) to 800rpm
and is regulated very closely by the EFI brain (PCM)
if not you are seeing IDLE control failure.
with and A/T there is no MT clutch and when you stop
the autoclutch drags (wastes fuel like mad) and puts a huge load
on the engine, stopped say at a red light. the idle controls
on A/t are greatly taxed here.
so RPM can drop real low. fail. or stall. below 800
a stall happens at about 400 RPM.
the M/T can at any time be restarted on the fly (moving)
but just dumping the clutch. or just waiting as you coast in gear.
this is how push starting any M/T car works.
but on an A/T car , on the fly restarts take huge speeds.
and only works on A/T that have 2 oil pumps.
the A/T with no rear pump , the A/T can not be push starter
or coast restarted, if the front pump is dead(engine stalled)
im not looking up your tranny spec. because you never stated, it.


my engine stalls. (not tranny slip)
1: bad 12vdc power to any EFI system component.
2: never ever tuned up per the free operators guide in glove box.
3: lost engine compression. 1 or all cylinders.
4: lost spark. (or timed wrong, early cars have distributors)
5: bad fueling. too much or too little

when the engine runs , does the MIL, CEL glow running
btw the CEL also glows, at all stalls. the lamp only means.
I HAVE ELECT power, now.... only.

Sep 11, 2013 | Honda Cars & Trucks

2 Answers

2000 dodge stratus 2.4l dohc stalls at stops starts up with very light touch of gas pedal may or may not stall again for a coule stops but will again rpms go from around 800 at idle to 500 then 200 th


If it's fuel-injected, you may need to have the injectors cleaned, and also, any air filters should be changed at the same time along with gas filter/s. If it's carbureted, the same as above, but have someone clean the carburetor completely. Make sure all air hoses are attached correctly, securely and NOT broken. If broken, replace them.

Sep 19, 2012 | 2000 Dodge Stratus

1 Answer

My 2005 chevy cobalt rpm drops very low when coming to a stop. I changed the Oil and Plugs and it helped a little bit. PLEASE HELP


first check the throttle plate for carbon build up the look for the knock sensor harness rubbing onto the fan shroud

Jun 08, 2012 | 2005 Chevrolet Cobalt

1 Answer

Idle irratic


Here are some of the causes of surges, stalls at stops, slow idle speed, erratic idle speed, rough idle and engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake

Apr 11, 2009 | 2001 Chrysler PT Cruiser

1 Answer

Eclipse won't idle .


Throttle body, IAC or EGR valve.

Mar 12, 2017 | 2003 Mitsubishi Eclipse Coupe

1 Answer

Car idles low, stalls after start


Common issue at the shop (i'm a ford technician), here is what I do to correct it.
Here is the most common cause of surges and stalls at stops and low erratic idle speed and rough idle, it is the idle speed control air-bypass valve and throttle valve (IAC for short), they get full of gunk over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Mar 11, 2009 | 1999 Mercury Cougar

1 Answer

When i start my 92 geo tracker, it starts fine but about 5 seconds later, the idle drops significantly. enough so, that the car sometimes (usually) stalls and i have to restart it. it also stalls...


this is cause because the ISC is busted or can not open enough to keep idle at 800 rpm.

ISC , idle speed controller

but....
the car has a TPS switch on the throttle body.
if it fails to close at idle the ecu will never attempt to set idle.

or
car could be flooding. (too much gas)

you did not say if motor is 8valve or 16v and they are quite different EFI systems.


Feb 19, 2009 | 1992 Geo Tracker

1 Answer

Engine turns off when coming to a stop


I have used this procedure for years.
Here is the most common cause of surges and stalls and low idle rough idle, it is the idle speed control air-bypass valve and throttle valve (IAC for short), they get full of gunk over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Feb 10, 2009 | 1986 Pontiac Fiero

3 Answers

1990 celica 2.2 5s-fe wont idle, wont erach 1400rpm


your problem is in your throttle sensor that controls the idle it is located right behind your intake and it has two screws that mounts it i am almost positive that this is where your problem is comig from

Dec 31, 2008 | 1990 Toyota Celica

Not finding what you are looking for?
2006 Chrysler 300 C Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...