Question about Jeep Grand Cherokee

1 Answer

AC of my 2003, 2.7lt CRD, Jeep Grand Cherokee, has recently been re gassed, it cools ok initially but for 5 to 10 minutes only, error codes 22 and 52 indicated.

The compressor clutch doesn't appear to engage, I have checked the the AC fuse/relay it appears ok, as I interchanged it with similar ampage fuse and clutch did not engage.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 20,706 Answers

Its not one fuse, sorry, not at all
and you failed to scan the PCM, why skip this? it tells you whats UP.
only 2 things cause that (electronics logic)
1: The hi/low pressure switch tripped,
2: or the AMP the AC logic module (has bad inputs)
is this is USA car, ? seems not. but is it?
as non usa cars are different.
ill now answer, as if it was....
our cars have 2 HVAC systems (chapter 24 in Serv. manual.)
manual or AZC, no photos of your controls, so will toss coin on AZC auto zone controls (see Display there with graphics and temp, mine shows, 74F like the books shows. and 4 knobs not 3.?
The AXC system has operator self diagnostic mode,
need that, its in the manual, see last link below,a free book.

fuse JB20 run this controller. but only on gas engines.
as does, JB F21 and PDC fuse 21. (you 2 fuse both 21)
JB is cab box, PDC is hood fuse box next to clutch RELAY.
That logic resides, in the AZC and the PCM
the PCM runs the clutch relay directly
the diesel uses different wiring and fuses.
PDC Fuse 16 and F21 are diesel , fuse for the clutch.
i suspect you failed to check all fuses.
lets do the flow of logic, and you will see.
you have the A/C turn on via the AZC controls.
it sees its (guess) its too hot in the cab
the AZC then sends a MESSAGE down the network.
the PCM sees that and the BCM,
the PCM if the engine is not overheated and the hi/low switch is not tripped, (called by jeep pressure transducer A/C)
then the PCM energizes the clutch relay.
The BCM helps with directing traffic. (bcm prevent evap freeze up etc....)

so there are 3 things you can do.
1: this time check all fuses, not just the one, (RTM read the manual for our car in your country)
2: scan the PCM for A/C errors. (posted now over 1000 times)
3: run the AZC if opted day 1, self test, and the 50 errors possible there. chapter 24.

click WJ jeep, here, read chapter 24
then 8w wiring chapter on A/c
and keep in mind there are systems, manual and AZC
and they are NOT the same.

all free, USA only this is a USA forum not say Europe.

http://www.morris4x4center.com/knowledge-base/index.htm?utm_source=cj#service

Posted on Dec 28, 2016

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need new tail lights on crd 2008 Grand Cherokee, where can I buy them? and ship to Icelnad


did you all jeep:?
call them all and ask for international shipping.
they all have email. , all, google for Jeep dealer, click parts, click email.

Dec 16, 2013 | 2008 Jeep Grand Cherokee

1 Answer

Both malfunction indicator light and electronic throttle control warning light is burning after I had my 2006 jeep crd overland serviced. The car is losing power wile driving. What do I need to solve


have the fault codes read and replace the faulty units. Ask the service person if they pressure cleaned the engine as that quite often causes problems with water getting into the connections and shorting out

Apr 07, 2013 | 2007 Jeep Grand Cherokee Overland

1 Answer

Won't start..


First you need to have a diagnostic done before you troubleshoot further,else it will take forever to locate this fault..

Sep 05, 2009 | 2003 Jeep Grand Cherokee

1 Answer

Poor AC performance on 2004 Grand Cherokee - Sp Edition


I'm reluctant to say that the AC is low on charge since it has been poor since new.
Our Jeeps seem to do well when all is right.

Since we have a family 'fleet' of vehicles, I bought a refill kit from the local NAPA auto parts store (on line too) that has a gauge to let you know if the low-side pressure is OK. This is an indicator of charge.
It works well and the cost for the assembly was ~ $18.

That and a can of refrigerant restored the popsicle-making capability on our Subaru Outback in about 15 minutes.

Jul 15, 2008 | 2004 Jeep Grand Cherokee

1 Answer

94 jeep cherokee ac blows cool on medium only. recent recharge freon help cool more.


could be anything overcharging the system, freon leak faulty componets like compressor or clogged lines or orfice tube or dirty evap. coil check for 12 volts comming into the blower motor with ur switch on high if ur getting 12 volts at the plug then replace ur blower motor

Jun 21, 2008 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...