Question about Cars & Trucks

1 Answer

Horn comes on all by it self,stops when i turn off the lights

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 660 Answers

No car information always makes these questions fun.

Most likely it will be a combination switch or clockspring.

they control many functions from turn signals to horn.

Just go a google search with your cars year, make, model, and engine size and add in "clockspring"
The results will have you much closer to the issue and you will easily get enough information to know what is involved in the repair.

Posted on Dec 28, 2016


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Horn buttons works the radio

Suspect a short circuit in the steering column wiring

Jun 20, 2016 | Cars & Trucks

1 Answer

I have a 1998 Montecarlo when I try to blow the horn the head lights come on and the horn won't blow when I turn on my head lights the passanger side turn light stays onwhen on dim any thoughts?

it sounds like a short or a ground wire not connected start by checking the bulbs burned or shorted in the bulb it self and or corroded sockets

Nov 09, 2014 | 1998 Chevrolet Monte Carlo

2 Answers

How to fix Cruise Control

The most common problem on this vehicle is the sensor right on the master brake cylinder the seal goes out and brake fluid gets right in the sensor ruining it that is the most common problem lete no if it helps

Sep 22, 2014 | 2001 Ford Windstar

1 Answer

Horn blows when turning on turn signal on 2007 mazda 6

must have a short in the wiring loom to the steering column , have you had any work done in that area recently?if your going to have a look your self make sure you disconnect battery and wait at least 15 mins for all the power to drain down ,you don't want an air bag going off in your face!

Mar 30, 2014 | 2007 Mazda MAZDA6

1 Answer

I have a mitsubishi lancer 2002 , my horn started to sound uot of no where, and won't stop unless I turn on the lights, whenever the lights are on the horn stops, but when the lights are off the horn...

check the horn relay in the engine bay relay compartment .It might be sticking on. Maybe swap the relay and see if fault moves to other device.

Feb 28, 2018 | Cars & Trucks

1 Answer

Replacing horn

That must be the horn relay. Is it a white cube with 4 terminals? I would pull off the horn pad from the steering wheel and check the horn operation from there. Maybe a metal strip has come out of place or got bent and making horn work by itself.

Jun 17, 2013 | Dodge Omni Cars & Trucks

1 Answer

Fiat horn stopped working

activate the horn switch with a test light on both terminals of the horn.

IF the test light comes on then the horn is bad
IF the test list does not come on test the electrical connection

use the test light on the positive terminal and a known good ground
IF the light comes on, the ground on the horn was not connected properly
IF the light does not come on, there is an electrical issue with the switch, the wire grounding before the horn, or the fuse

Feb 23, 2013 | 2001 Fiat Punto

2 Answers

My 2005 Pontiac Sunfire horn stopped working. I've tried replacing the fuse, but that's not the problem. Any ideas?

Hello: It could be a failed horn. the best way to check is to get a test light and connect one end to the green wire at the horn connection and the other end to a good ground, have helper press horn. if test light lights up the horn has failed. also you might check the fuse box under the hood and see if there is a horn relay. if there is a horn relay then look to see if there another relay like it. if there is one swap the relays and see if the horn works.

Jan 26, 2011 | Pontiac Sunfire Cars & Trucks

3 Answers

Indicators not self cancelling & Horn not working

I had the same problem. Horn not working and indicators not self cancelling.
After removing the steering wheel I found that the central two pronged collet, that engages with the steering wheel and drives the horn contact slipring and indicator cancellation, had worn down its prongs. this had caused the horn wires to stop rotating and they had been snapped by the motion of the steering wheel.
the ideal solution would be to replace the collet and horn wires but I managed to repair both

Apr 11, 2009 | 2000 Renault 181

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

14479 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides