Question about Cars & Trucks

Open Question

I have a Goulds irrigation pump model C48C53A06 8F04, 1.5 HP, with a AO Smith motor J07858L, pressure is good but it makes a load noise from the bearings.

Please quote new bearing, seals, gaskets, and anything else to fix it gtood.

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1586 Answers

SOURCE: Front wheel bearing/break

Could be a wheel bearing that is starting to have trouble - you won't always hear it right as soon as it starts to fail. If it is a wheel bearing though, very soon you'll start to notice a rumbling noise.

Posted on Aug 10, 2008

  • 1 Answer

SOURCE: Toyota 1991 Pickup Truck V6 3.0 engine

i have a 92 with the same motor and 121k and it knocks too. so does my friends, i think they all dew. injector cleaner stopped his but then it started again

Posted on Nov 17, 2008

  • 60 Answers

SOURCE: 2002 Kia Rio rear wheel bearing passenger side

I'm from the United States, East coast.

Posted on Nov 24, 2008

  • 16 Answers

SOURCE: pwr steering pump failure GM truck

check to see if truck has a power steering pump cooler try to bypass cooler sounds like it has a blockage in the cooler not allowing fuild to circulate should fix problem

Posted on Nov 26, 2008

  • 4088 Answers

SOURCE: car make noise, look like is left wheel bearing or

Check the CV joint that the axle connects to. They make a clicking sound when turning a corner if badly worn. Both CV joints are commonly replaced when one of them goes out.

Posted on Sep 08, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

No oil to top of motor but 45lb at gauge rattels real loud

didnt specify yr-make -model-engine size engine but most engines like im saying most engines oil pump is at bottom of engine in the oil pan the oil pressure sensor may be sending out correct pressure but if sensor is down by filter/pump area thats where your going to get your reading ---the noise is your heads starving for oil problem can be sludge clogging oil from getting up to head ---oil filter collapse not correct oil for the vehicle or oil pump failing

Jul 25, 2015 | Cars & Trucks

1 Answer

Fuelpump making bad noise took inline filter off it stopped making noise and pumped good replaced filter it it still want run and pump is making noise

Noisy pumps are going bad. It probally pumps but it can't make enough pressure and flow under pressure. Fuel pumps are checked with fuel pressure gauge for pressure and checked for flow rate to manufactures specifications.

May 23, 2015 | Cars & Trucks

1 Answer

Gould water pump

I service all sorts of Goulds water pumps for a living but will need some more info to troubleshoot your problem. For starters would need to know what voltage feeds it, single or three phase, horsepower, type of controller (pressure switch, Variable Frequency Drive, Three phase across the line start etc.), what you are doing with it, pump model number, motor frame number, etc. etc.

May 12, 2013 | Cars & Trucks

1 Answer

I have a Sears Model 106.153881 air compressor that I bought new around 40 years ago and use frequently. The compressor is now making a loud rattling noise as the pressure rises above 80 psi and will

As with most good units there is the possibility that you forgot to monitor the oil in the sump of the compressor and do regular oil changes. Pull the compressor and check big end bearings. check rings for sharp edges (worn) and replace the poppet valves in the head It will also bhe a good idea to clean out the holes in the head and pipes as the oil from the sump over time will carbon up and block the system causing the pistons to over load.

Mar 31, 2013 | Cars & Trucks

1 Answer

Hi - I have a 1993 Subaru Legacy which is leaking water from somewhere. I suspect it to be the water pump. Your advice on how to remove the pump from the motor will be much appreciated. - Thanks. Kevin...

Go to Auto Zone and they well loan you a pressure pump you can attach to the radiator and pump up the pressure you can easily find the leak if it is external

Apr 04, 2011 | 1993 Subaru Legacy

1 Answer

2004 4.3L Chevy fuel noise

you will need to know if the fuel pump has more pressure than one for the 4.3

Feb 01, 2010 | 2004 Chevrolet S-10

2 Answers

I need a manual for a 83-84 ford f150 pick up, as i need to posibbly replace the fuel pump , where can i d/l a free manual ?

Ford Pick-Ups/Bronco 1976-1986 Repair Guide
Electric Fuel Pump - Removal & Installation

Two electric pumps are used on fuel injected models; a low pressure boost pump mounted in the fuel tank and a high pressure pump mounted on the vehicle frame. Some models equipped with the 8-460 (7.5L) carbureted engines use a single low pressure pump mounted in the fuel tank.On injected models the low pressure pump is used to provide pressurized fuel to the inlet of the high pressure pump and helps prevent noise and heating problems. The externally mounted high pressure pump is capable of supplying 15.9 gallons of fuel an hour. System pressure is controlled by a pressure regulator mounted on the engine.
With internal fuel tank mounted pumps tank removal is required when servicing the pump. Frame mounted models can be accessed from under the vehicle. Prior to servicing release system pressure (see Fuel Supply Manifold details). Disconnect the negative battery cable prior to pump removal.

More details can find in (free register); select the year, make, model and engine.

I hope help you with this (remember rated this help) Good luck.

Oct 16, 2009 | 1983 Ford F150

1 Answer

Makes a noise that can only be heard inside the car. It reminds me of a fan going on and off. It has gotten louder and happens more often

there is a load leveling motor that cycles on and off, it goes on to pump up pressure, this motor is often located in more rearward, in the car, but sounds closer than it actually is....

Oct 11, 2009 | 2004 Buick Rendezvous

1 Answer

Car turns over but wont start

I'm not sure what model make or year you have, but I think you are referring to the noise made by the fuel pump when the key is turned on... ?
The fuel pump sends and pressurizes fuel through the fuel line. If you do not hear this noise, your fuel pump may need to be replaced. On most later model cars and trucks, this envolves dropping the gas tank, as most modern make car's fuel pumps are located on and connected to the top of the tank.
Take the gas cap off and have a good set of ears listen to the tank inlet as someone turns the key to on position... just to make sure.
Good luck!

Sep 04, 2009 | 1996 Lincoln Town Car

2 Answers

Vibration/Whinning Noise while drivin

Check fuel pump pressure. sounds silly but my 1500 ram van did this 2 months . replaced a lot of parts then left me sitting on side the road. Cause was fuel filter and pump.

Apr 20, 2009 | Dodge Ram 1500 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides