Question about Chevrolet Impala

Open Question

Fuel relay switch 2005 Chevrolet Impala

Car hit post in yard. key switch will not turn on engine to start.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 146 Answers

SOURCE: NEED TO REPLACE A TAIL LIGHT BULB IN A 2005 CHEVROLET IMPALA

and Repair Notes TAIL LAMP REPLACEMENT REMOVAL PROCEDURE Open the rear compartment. Remove wingnut and pull back the rear compartment trim panel from the tail lamp. Remove the wingnuts from the tail lamp. Remove the tail lamp from the rear body panel. Disconnect the electrical connector from the tail lamp. Remove the tail lamp socket, turning counterclockwise. Remove the bulb from the tail lamp socket. Remove the sidemarker lamp socket, turning counterclockwise. Remove the bulb from the sidemarker lamp socket. INSTALLATION PROCEDURE Install the bulb to the tail lamp socket. Install the bulb to the sidemarker lamp socket. Install the sidemarker lamp socket, turning clockwise. Install the tail lamp socket, turning clockwise. Connect the electrical connector to the tail lamp. Install the tail lamp to the rear body panel. Install the wingnuts to the tail lamp. Pull back the rear compartment trim panel to the tail lamp and install the wingnut. Close the rear compartment.

Posted on Jun 08, 2009

Ad
adve1958
  • 246 Answers

SOURCE: 2005 Chevy Impala ignition switch stuck in off position

if it doesnt turn you have a worn out ignition cylinder, the only fix is to replace it, Code the ignition lock cylinder, if necessary

CAUTION:Perform the body control module (BCM) theft deterrent relearn procedure whenever you replace the ignition switch lock cylinder.

Posted on Sep 08, 2009

Zeevert
  • 373 Answers

SOURCE: 2003 Impala: HOW DO I CHANGE BATTERY 2005 CHEVROLET IMPALA...

The battery is under the hood, just behind the passenger headlight.
There is a black bar that crosses over the battery and goes back towards strut tower. Remove this bar and the three bolts; probably a 12 or 13mm socket.
Remove the negative (black) battery cable with an 8mm socket or wrench. A 5/16" should work also.
Then remove the positive (red) cable with same socket.
Remove the battery clamp and bolt. Probably a 12mm socket with extension.
It's tight, but the battery can be removed.
Reverse instructions for installing the battery. (That includes hooking up the red battery cable first, then the black cable.)

Posted on Jun 06, 2010

  • 226 Answers

SOURCE: where is the fuel pump relay located an which fuse

try to smack the gas tank with a rubber mallet with someone cranking the key .if it starts then the pump is no good .otherwise the relay should be on the pass side of the firewall.poss under a long black cover.the fuse will be in the fuse box under the hood on drivers side. var fctb_tool=null; function FCTB_Init_0b704873de9943d2aa9b1abbb4656a28(t) { fctb_tool=t; start(fctb_tool); } FCTB_Init_0b704873de9943d2aa9b1abbb4656a28(document['FCTB_Init_72d341bf61da4120a5167e6de35ebcf0']); delete document['FCTB_Init_72d341bf61da4120a5167e6de35ebcf0']

Posted on Feb 06, 2011

skychief2001
  • 21873 Answers

SOURCE: 99 Mercury Cougar won't start. I turned key to start, has current to relay. Jumped relay, will turn over. Spark to plugs but no fuel to injectors. Fuel pressure in fuel rail. No check engine

Have you checked the automatic shut down relay ?
It powers the injectors from a 20amp fuse number 5.

Posted on Aug 03, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Have a 2005 Chevrolet Avalanche it won't start we replaced alternator and had battery tested. The lights everything works just won't start


You have to be sure the battery has a full charge, if the battery is down, you can't do any testing. Use a digital multimeter across battery posts everything off, the generic spec for a full charge is around 12.6 volts, if it needs charging, get it charged.
Test the charging system? Even if the generator is new, if a problem on the wiring circuit, it may not work.

If starter motor won't even crank have to check starter motor wiring circuits. When testing make sure tranny is in park or neutral and parking is set. Safety is your responsibility.
If it cranks good but won't start, check spark--fuel--compression. What about your security system?

Oct 18, 2016 | 2005 Chevrolet Chevrolet Avalanche 1500 LS

2 Answers

3.5l V6 Auto. Why is there no power at the fuel pump?


Just answered a similar question. Does it turn over? Either way, I would look for blown fuse and then check (usually) under the hood for a relay. You can some times test by taking another relay for lights or something not needed to run and switch them IF THEY ARE EXACTLY the same. If the pu,p works you will know.

Oct 20, 2015 | Cars & Trucks

1 Answer

I just replace my fuel pump on a 2004 Chevrolet impala and it sill won't start. Can you tell me exactly where I can find the fuel pump reset switch?


There is no fuel pump reset switch ! You need to test the electrical circuit , there is a fuel pump RELAY that turns on the fuel pump an this is where you test for battery voltage an control of the relay ! THE PCM - ( engine computer ) provides a ground to pin 85 there by energizing the relay turning on the fuel pump ! Here check out this video . GM Fuel Pump Relay Testing

Aug 10, 2015 | Chevrolet Cars & Trucks

2 Answers

2002 chev impala will not start, will not crank over and lights will go out when i try and start it


Have the battery tested if no good replace. Check for power at the starter cable and then while someone holds the key in the crank position check for power at the trigger wire of the starter. If you have power but no crank or click then you may have a bid starter or the engine is seized. If no power on the tarter little wire which comes from the ignition switch make sure you fuses and relay is good and that your ignition switch is working. If the battery tests good have your alternator checked as well. The cluster may act erratic if battery is low or bad.

May 14, 2014 | 2002 Chevrolet Impala

1 Answer

Put on new fuel pump got pressuer but want stay cranked


Your post is lacking any detail. However, if you are stating that the engine starts after being cranked but dies out (wont stay running) there are 2 ways the fuel pump is activated. When the key is first turned on, there is a 5 second fuel pump run (the ECM energizes the fuel pump relay). After the engine starts, the fuel pump relay will only stay energized when the oil pressure switch closes keeping the fuel pump relay on (oil pressure is above 5-7 psi). If the oil pressure switch is faulty or there is no oil pressure, the engine will stall just after starting.

Apr 10, 2014 | 1999 Chevrolet Astro

1 Answer

2003 Chevy Impala, running hot. Changed fan shroud because cooling fan wouldn't turn on, switched out fan relays, no check engine light. Cooling fan still will not turn on.


Would turn the key on no need to start it and unplug the ect engine coolant temp sensor. If fans come on then suspect a faulty etc which may not turn on the engine light. Which engine is in the vehicle so I can help locate the ect which is usually by the thermostat housing.

Jun 12, 2011 | 2003 Chevrolet Impala

1 Answer

Have a 2005 chevy colorado, ran it out of gas and now after fueling it it won't start. when you turn the key i don't hear the fuel pump. is there a fuse or a switch to push to reset it?


I would start by replacing the fuel filter. And if that doesn't work ? listen for the fuel pump when you turn the key on. If you don't hear the fuel pump go on when the ignition is set to on (Just before turing the engine over) ? Check the relay or the fuse. Its not ever a good idea to run any vehicle low on fuel. Could cause a number of problems. but it sounds like fuel filter got clogged and sucked up all the junk at the bottom of the tank.

Jan 25, 2011 | 2005 Chevrolet Colorado

2 Answers

Tempature Gauge is not working on my 2001 Chevrolet Impala LS.


Sounds like a bad coolant temp sensor. Do you have a check engine light on?

Mar 24, 2009 | 2005 Chevrolet Impala

1 Answer

2005 impala switch key ingition


i went to a better web site. and it was free and worked

Nov 21, 2008 | 2005 Chevrolet Impala

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...