SOURCE: honda crv 2000 computer reset
Ok,
1. ensure ignition off
2 . bridge the 2 pin connector, Put a piece of wire across both terminals
3.switch ignition on
4. SRS lamp should illuminate for 6 seconds
5.disconnect the bridge wire within 4 seconds of the warning lamp extinguishing
6.SRS lamp should illuminate 2 times, Codes erased
7.switch ignition off
8 Wait 10 seconds. switch ignition on and check SRS warning lamp operation.
hope this helps
SOURCE: airbag light stays on after airbags deployed in crash
1. ck the fuse box for any bad fuses,
2. if the light was on when you bought it used..chances are the airbags are no longer there.
SOURCE: 2000 Chevrolet Malibu LS airbag problems
The passenger side airbag is a lot easier then driver side. Take the glove box out and you will see two 10mm bolts holding it in place. When you open the passenger side front door, remove the panel on the side of the dash and you will see yellow connectors.The 1 closest to the front is attached to the air bag, it is clipped into the frame. Just pull it loose and take it out and your done. For the Driver side, it takes a skinny T27 to remove the two star bolts, then just disconnect the horn red clip and ground and install new airbag. The module is located under the passenger seat, underneath the carpet. Kinda stupid but thats where its at. You also need to replace the front impact sensor located behind the grille on the back side of the metal bar to each side. Follow the hood latch down. Also just to make sure, you know to disconnect the battery before you do all this. You don't want new airbags to accidentally deploy.
SOURCE: 2005 honda crv airbag module location
Most of the time it's in the middle of the car under the center consol(consol with stereo) , SRS module usually mounted on the floor.
184 views
Usually answered in minutes!
×