Question about 2008 Kia Spectra

1 Answer

2008/kia/ spectra/ticking noise in engine.put a stethoscope to the motor and the noise. was clear when touching the injectors

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 469 Answers
Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Car will start but put it in gear engine will die


engine starts with no problem; but, when I put in gear and ...

www.cargurus.com > Questions > Hyundai > Sonata

CarGurusNov 15, 2012 - The engine just fall dead when you step on the gas; it seems to jerk before ... My car does the same thing but i put it in neutral n it starts up. ... I have a 2004 kia optima it jerks when I go into reverse it was driving ... start and run fine butwhen I put it in drive or any other gear it dies! ... 2002 Hyundai Elantra GT.

Engine stalls when tranny put in Drive or Reverse - Kia Forum

www.kia-forums.com/kia-carnival...2002.../43407-engine-stalls-when-tr...

Feb 28, 2008 - 10 posts - ‎3 authors
Give it a little gas before putting in D or R and it will go. .... When I start the van cold and shift the tranny into drive or reverse.....the whole front ... won't run in forward gears - Kia Forum
10 posts
May 25, 2012
Intriguing problem - engine rough idle & hesitation ...
10 posts
Aug 31, 2011
2006 Kia Spectra engine stalls and bad idle, cleaning the ...
10 posts
Aug 30, 2010
2002 Kia Spectra Won't Go Out of Park - Kia Forum
3 posts
Oct 28, 2008
More results from www.kia-forums.com

Dec 17, 2015 | 2002 Kia Rio

2 Answers

92 isuzu trooper 3.2 LS Loud ticking .. Can't tell if drivers side rear valve cover or fuel injector area ?? Recent work (last 2weeks)... Cat replaced / hose for pressure test /ingnition coil /ignition...


Useca long thin screw driver and put it to the component that u think is making the noise and put ur war to the top of the screw driver the noise will transfer up so u can hear it .... alternatively buy a stethascope

May 29, 2014 | Cars & Trucks

1 Answer

Ticking noise in motor at first start up


what engine the V6
did you read the TSBs on chain noise of lifter noise.
how many miles on engine? 100k, 500K?
not changing oil frequently dooms most HLA lifters. they gum up and click (collapse)
same with chain
same with the tensioner,
a good tech, can find which part ticks with a $5 stethoscope.

Mar 18, 2014 | 2007 Suzuki XL-7

1 Answer

Engine problems


intake valves on the R side of cyl.head.exhaust valves on L side looking at engine from transmission end. need to perform a compression test on each cylinder making sure that the psi doesnt vary by more than a cpl. psi between cylinders.FUEL INJECTOR is very likely.AND injectors make a clicking noise when energized.a click each time injector is pulsed.(thats each time the cylinder is fired=alot of ticking or clicking)the higher the rpm the more rapid the noise.injectors are on the intake side of cylinder head. opposite side from exhaust manifold(the manifold that your tailpipe attaches) unplug injector on no.2 cyl(if thats where your misfire is) while the engine is running, if the engine runs the same without staggering or stalling there is your problem. good luck and happy motoring ___O^-o

Dec 22, 2013 | 2005 Kia Sorento

1 Answer

TRAILBLAZER 2008 ENGINE TICKING 4.2


most likely a loud fuel injector. if you start smelling gas from the engine compartment, get to the shop as soon as possible.

Aug 02, 2012 | 2008 Chevrolet Trailblazer

1 Answer

Enging ticking on top


it could possibly be worn valves or valve springs. sometimes worn cam bearings can cause this issue. try using 10w 30 motor oil on your next oil change to see if it helps. sometimes the oil you use can cause ticking because it is not thick enough to lubricate the engine properly. if 10w 30 doesn help the noise, it is possible this problem may be linked to worn parts inside the cylinder head. removing the valve cover will give you a better idea of what could be the source of the ticking.

Mar 05, 2011 | 2002 Kia Spectra

1 Answer

2000 Kia Spectra


http://www.kiatechinfo.com/index.asp

Good source for Kia its free to register NO STRINGS

May 16, 2009 | 2003 Kia Spectra

1 Answer

1989 Lebaron with a tapping noise.


I would replace the injector and see how that goes. It could be going bad or malfunctioning. You run the chance of it going bad and causing serious engine problems.

May 11, 2009 | 1991 Chrysler LeBaron

2 Answers

Hear tapping noise in engine when starting car


If the noise is coming from the side of the engine where the fuel injectors are, the faint tick from the injectors is normal. If that is not the location of the noise, a stethoscope from an auto parts store will come in handy. Check your oil level. If it is where it is supposed to be, then it is probably not your lifters. If the noise is coming from the lifters, run some motor flush through the engine and start using a better grade of oil (no house brand, Pennzoil, or Quaker State). If it is not from the lifters, then check along the edge of the oil pan with the stethoscope for clunking in the crank case. If it is coming from the crankcase, you probably need new main and rod bearings. Drop the pan, remove the bearing caps, and check the crank surfaces for abnormal wear. If the bearing surfaces look good, you can buy undersized bearings (such as 0.001" undersized) to install on the main and rod bearings.

Feb 23, 2009 | 2001 Chevrolet Cavalier

Not finding what you are looking for?
2008 Kia Spectra Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76132 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...