Question about 2008 Nissan Versa

Open Question

2008 versa sl hatchback. When I shut the car off I get a long audible beeping. After this beeping stops, I still a faint beeping inside the car. I cannot lock it unless I put the key in the door.

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 197 Answers


This sounds stupid but it does work sometimes! Get a tennis ball, cut it in half, with as clean a cut as you can get, put plenty of grease on the cut edge of the ball to give you a good seal, place the ball above the door lock as centrally as you can and hit the ball as hard as you dare not to damage the body work. It's an old trick, but it creates a vacume on the lock causing it to pop the lock open. The alarm will go off, but you will have your keys back to turn it off. It used to work for me in the same cases, it's either that, or get the police to open it with a slip stick, it will open ANY car, but you have to have all your documents with you to prove ownership. Best Wishes Dave.

Posted on Aug 02, 2009

  • 8404 Answers

SOURCE: need to reset auto lock function on 2009 versa

I think this is a feature that needs to be reset by a mechanic.

Posted on Jan 14, 2010

  • 6927 Answers

SOURCE: how do you open the locked doors of this car, keys

Need a door shimmie

Posted on Apr 21, 2010

  • 22306 Answers

SOURCE: my door is not locking

sorry havent a clue here ,these fancy remote things are a cause of great headaches for me ,but i often disconnect the car battery and try again as that seems to work with a lot of vehicles

Posted on Aug 12, 2010

  • 157 Answers

SOURCE: How do i change the

Hi there,

Inside the trunk/hatch area, directly behind the tail light assembly, are two plastic cover plates. Remove these with a flat tool (screwdriver will work) by prying in the small ****. They pop off. Inside one you will see a nut. This is a 10mm deep socket. NOTE: This nut is very easy to lose once loosened! If at all possible use a magnetic socket. If one is not available, loosen but don't remove completely. Use a magnet to remove. In the other compartment you will see wires on a plastic holder. This holder is snapped over the nut you need to remove (note you may see two, you want the one closest to the access opening). Use a flat (screwdriver) to slip the white cover with wires off the screw post. Use a 10mm wrench to loosen, then remove by hand. From the outside, pull the lamp assembly backwards. If necessary apply a little pressure on the interior screw posts. ACCESS TO LAMPS! Reverse procedure to reinstall. Note on the exterior there is a slot at the front of the lamp assembly when reinstalling. Good Luck!

I followed the advice above but have a few details to add. I used a stick (7/8" x 5/8" x 6") to push on the bottom post and then used a flat stick, actually a paint stirring stick, as a shim between the lens and the car body. With the shim in place I then used a flat nylon strap (a dog leash) which I placed around the tip of the lens, closest to the front of the car. I put both ends of the leash in one hand in order to pull on one side and then used my finger tips on the other hand to pull on the part of the lens closest to the bumper and applied even pressure straight back until the lens popped off allowing access to the light bulbs.

Hope this helps...

Posted on Jan 24, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Vehicle Speed Sensor location on Nissan Versa Hatchback 2007?

It will be located on your actual transmission case. You will need to jack the car up and slide underneath with a light to see it

Feb 28, 2015 | 2007 Nissan Versa 1.8 Sl Hatchback

1 Answer

Locked out,keys and flicker inside.....

only if the seat folds down and for this you have to be inside of the vehicle... So NO. call a locksmith

Nov 09, 2014 | 2007 Nissan Versa 1.8 Sl Hatchback

1 Answer

Nissan versa 2007 the fan and ac light stop?

No power passing through the switch to activate the fanin the heater box. First point is to check for a blown fuse. Next point is to see if the motor resistor are not burnt out

Jan 26, 2013 | 2008 Nissan Versa

1 Answer

The hatch back won't latch shut it just stopped 2007 s no keyless

The latch is probably stuck or bent somehow.
Best Reguards, Premium FixYa Support

Jul 15, 2011 | 2007 Nissan Versa 1.8 Sl Hatchback

1 Answer

My nissan versa hatchback standard shift has no reverse lights. I replaced the bulbs and checked the fuse.

you need to check the switching the switching usually comes from the park pawl asm which is found at the shifter rod on the gearbox. the terminals will be corroded inside

Oct 04, 2010 | 2007 Nissan Versa 1.8 Sl Hatchback

1 Answer

Replace tailight in 2007 nissan versa hatchback

Open the hatch and locate the 2 plastic covers, behind the tail light area on the inside panel. Remove these covers and the nut (8mm) behind them to access the light assembly. Pull lightly on the light assembly to remove, then replace the bulb.

Aug 11, 2009 | 2007 Nissan Versa 1.8 Sl Hatchback

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

77932 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides