Question about 2005 Chrysler Pacifica

Open Question

2005 Chrysler pacifica thermostat replaced leaking still from bottom

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
MrScary66613
  • 1990 Answers

SOURCE: I need to replace the thermostat for a 2005 chrysler pacifica

Follow the Upper Radiator Hose to the Block. There is a Bell housing there that the Hose Connects to. Remove that Bellhousing and the Thermostat is Right Under it.

Posted on Jan 15, 2009

Ad
  • 2 Answers

SOURCE: Where are the spark plugs located in a 2005 Chrysler Pacifica?

Jay from Ma,
You have it backwards the rear three are accessable with the front three being under the intake. To remove the intake simply remove throttle body and aproxamently 15 other bolts.

Posted on May 08, 2009

localwonder
  • 6784 Answers

SOURCE: Chrysler Pacifica 2005

Sure, you can buy a new pulley and replace the original one but, you may have bad alternator bearings that is causing this noise you are hearing. i would check this out before buying a new pulley.

Posted on May 16, 2009

turo1000
  • 18 Answers

SOURCE: program instruction garage door opener in 2005 chrysler pacifica

if your garage motor have rolling codes you need to put your car inside garage near the motor leave ignition on go to the motor locate learn button press it then quickly go to the car and press and hold one of the buttons for approximately 30 sec or until it start blinking rapidly, if you have a regular motor take one hand held opener go inside car ignition on same time press open button on handheld remote and on the car button 30 sec and it should be programmed.

Posted on May 18, 2009

c17hydro
  • 2984 Answers

SOURCE: how do i replace front pads on 2005 chrysler

PLEASE DON'T FORGET TO RATE!!!!

Removal & Installation

  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:
    • Negative battery cable
    • Front wheels
  3. Place a C-clamp over the caliper as illustrated, place a screw drive head against the outboard pad and hook against the rear of the caliper. Slowly tighten the screw drive and retract the caliper pistons into their bores and breaking the outboard brake pad from the caliper fingers.
  4. Once the pad is free, slide the caliper in on the guides to provide clearance between the rotor and inboard pad.
  5. Place an appropriate prytool through the center opening in the top of the caliper behind the inboard pad between the pistons using care not to contact the piston boots. Pry the pad to free it from the pistons.
  6. Remove the two caliper guide pin bolts and position the caliper aside. Remove the brake pads.
24539c8.gif
Place a C-clamp over the caliper as illustrated

6ccd8b6.gif
View of the caliper guide pins and boots (1), anti-rattle clips (2), brake rotor (3), outboard pad (4), caliper adapter (5) and inboard pad (6)

To install:
  1. Completely compress the caliper pistons
  2. Install or connect the following:
    • Brake pads with anti-rattle clips onto the adapter
    • Caliper and align the guide pin bolt holes with the guide pins. Install the pin bolts and tighten to 32 ft. lbs. (43 Nm).
    • Banjo bolt with new washers on each side of the hose fitting and tighten to 35 ft. lbs. (47 Nm)
    • Wheels
    • Negative battery cable
  3. Check and adjust the brake system fluid level and road test the vehicle.

Posted on Nov 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oil leak Chrysler Pacifica 2005


I take it you are talking about the pulley on the crank shaft This will be a timing cover crank seal and can be replaced after removing the pulley. Not a big job if you are mechanically minded but other wise take it to a qualified mechanic or dealer.

Apr 01, 2013 | 2005 Chrysler Pacifica

1 Answer

It Started about 6 months ago on my 2005 chrysler Pacifica v6 3.8. my upper radiator hose colapses when i rev the engine up and it gets really hot. i can tell by the smell. i have replaced my thermostat...


REPLACE UPPER RADIATOR HOSE IT IS TOO SOFT WORN OUT CAUSE HOSE TO CLASP.I WOULD REMOVE THERMOSTAT FLUSH ENGINE BLOCK AND RADIATOR COOLANT SYSTEM NEED FLUSHING OUT.

Dec 14, 2010 | 2005 Chrysler Pacifica

1 Answer

My chrysler pacifica is leaking anti freeze on the


First find where the leak is coming from. Check the bottom of the radiator first for white corrosion. If the leak puddles in the fron and you see white corrosion on teh bottom (fins) of the radiator, chances are you just need to replace it.

Jul 29, 2010 | 2006 Chrysler Pacifica

1 Answer

Replace thermostat for 2005 pacifica


yes thats it The two or three bolts you need to take out and then the thermostat will be right under the cover you take off then replace in reverse procedure

Jan 15, 2009 | 2005 Chrysler Pacifica

1 Answer

I need to replace the thermostat for a 2005 chrysler pacifica


Follow the Upper Radiator Hose to the Block. There is a Bell housing there that the Hose Connects to. Remove that Bellhousing and the Thermostat is Right Under it.

Jan 15, 2009 | 2005 Chrysler Pacifica

Not finding what you are looking for?
2005 Chrysler Pacifica Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...