Question about 2007 Toyota Tacoma

Open Question

Where is knock sensor located on 2007 Toyota Tacoma 4cy? Thanks

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1861 Answers

SOURCE: Air Fuel Sensor on a 2001 Toyota tacoma

4 cylinder: one air-fuel sensor (on the pipe after the manifold) and one oxygen sensor after the catalytic converter

6 Cylinder: two air-fuel sensors (one for each manifold) and one oxygen sensor after the catalytic converter.

Posted on Dec 29, 2008

  • 1 Answer

SOURCE: toyota tacoma speedometer, odometer, tachometer not working

It is definitely the speed sensor assembly which hangs outside the transmission underneath the truck. Usually runs a little over $110

Posted on Jan 20, 2009

Toyota Guy
  • 42 Answers

SOURCE: Location of knock sensor on 1994 toyota 22vre engine

The Knock sensor on a 22re is located under the intake manifold on the engine block. to the upper left of the oil filter. With is the passenger side of the engine. I believe it is yellow in color. Not do be confused with the oil pressure sensor which is close by. The knock sensor has a larger electrical connector. Good luck it can be hard to get to.

Posted on May 06, 2009

superjorge1
  • 8 Answers

SOURCE: have p0130 and p0133 codes 98 toyota tacoma

check the mass air flow sensor there maybe dirt on the filiment inside the sensor causing false readings. cleaning or replacing it may make the codes go away.

Posted on Nov 18, 2009

  • 435 Answers

SOURCE: I need the location of the coolant temerature sensor on a 99 taco

Its at the rear of the engine, close to the firewall. Look at the intake part of the engine block for 2 wires that connect into the sensor plug. It is installed vertically.

Posted on Dec 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is iat sensor on 2006 toyota tacoma 4.ol 4door located ?


This is the 2001-2012 Toyota Tacoma wiring diagram, Toyota Tacoma IAT (Intake Air Temperature) Sensor Location and the Toyota Tacoma MAF (Mass Air Flow) Sensor Location, also included is a pinout of the sensor. You are likely installing a performance chip or a cold air intake kit for increased HP (Horsepower). You will want to be sure to disconnect the car battery before adding performance products.




Here is the Toyota Tacoma's Iat sensor diagram:




ab0b7213-0c7f-459c-b26e-77a685236e74.jpg

Apr 14, 2015 | 2006 Toyota Tacoma

1 Answer

Replace knock sensor in 1997 Toyota Tacoma 3.4l


is this a question formed as a statement?
i want to, ?
how to?
where is it.
why do you want to?

did the scan tool tell you its bad.
is the engine knocking or detonation or pinging?
is engine running lean (i sure can ping,but the knock sensor rolls back(via pcm) all spark timing, so that ping ends.

why not post symptoms first with a question,

someone broke mine
it unscrews.
so?

Jan 24, 2015 | 1997 Toyota Tacoma

1 Answer

Can you tell me where the knock sensor is located on a 1998 toyota tacoma


depends on engine - dealer will tell u by serial #1.
help on net. however one is located left [to firewall from oil filter.
# 2 could be drivers side under intake manifold in the valley.
So unless want a big job look near the oil filter. oil dender is ahead of the filter..on the block.. But as I sead ask the parts department at a dealer..Good luck.. I had the wire drop off on my 89 3 liter v6 .was of roading just by the oil filter.. stick I guess.
cowcamp

Sep 20, 2014 | 1998 Toyota Tacoma

1 Answer

Where is knock sensor on a 2003 toyota tacoma


On a 4 cylinder it's located on the side of the block, driver's side on a V-6 engine there are two and are located under the intake manifold, it has to be removed to get to them.

Jul 27, 2014 | 2003 Toyota Tacoma

1 Answer

2002 Toyota Camry oxygen sensor Bank 1 Sensor 2 location


go to manifold follow it till you find the downstream sensor there you go

Jul 21, 2012 | Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...