Question about Ford Cars & Trucks

1 Answer

2000 ford focus ztec Driving,shifting suddenly got difficult,then clutch pedal lost all tension although returns up after being depressed. car will start if pedal pushed to floor but no clutch tension

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 14,585 Answers

Master or slave cylinder blew out. Could be the pressure line also.

Posted on Dec 26, 2016

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No gears at allk


sounds like problem in the transmission shift top if it won't shift gears. If throwout bearing is not engaging pressure plate, it sounds like the pivot for the clutch acctuator is broken

Mar 05, 2014 | 2000 Ford Focus

1 Answer

2000 ford focus, manual, the stick stick flops around not engaged


There are three posibilities for this worn linkage on the gearbox the linkage under gear lever or a broken mounting on the bracket where the lever comes up through the floor as long as you can get all gears it will be exturnal linkage fault.

Mar 04, 2014 | 2000 Ford Focus

1 Answer

Yo I have a 1990 honda prelude si ,I have an issue with clutch pedal, my clutch pedal seems to stick when depressed it still has good pump pressure but I have to lift it up. Now I live in Idaho and it


The pedal return spring should be checked. Also the pedal bushings where pedal connects to the pedal support up under dash may be worn and not allowing free pedal movement. Work the pedal with your hand and watch the upper mounting of the pedal to see if you can see the problem. I would expect the bushings need replaced. You might try a little light oil where the clutch pedal attaches.

Jan 15, 2013 | 2000 Honda Prelude

1 Answer

Broken clitch cable on 2000 chevy impala...how do u replace it..the wires are broken


see this steps and fix it. God bless you
Clutch Cable Replacement The clutch cable provides a means to "break the drive" between the engine and the wheels. The engine spins constantly, but the wheels do not, so in order to stop a car's wheels without turning off the engine, the wheels have to disconnect from the engine. When the clutch pedal is pressed, the cable disengages the plates, allowing the driver to shift gears or coast without killing the engine.
A failing clutch cable may make the clutch pedal difficult to depress. If the clutch cable fails, the clutch pedal may remain on the floor and not return to its normal position.
To replace the clutch cable, disconnect it from the clutch pedal (usually inside the vehicle) and from the release mechanism or cable attachment that operates the clutch assembly (usually at the transmission beneath the vehicle). A new clutch cable is then installed and adjusted. (The specifics vary according to the vehicle and range from straightforward to very difficult.)

Oct 04, 2012 | Cars & Trucks

1 Answer

The clutch pedal on my 2000 Ford Focus ZTS broke. It seems the pedal itself is not connected to the clutch anymore. Only the pedal spring brings back up the pedal. I therefore cannot shift gears. The rest...


That car has a hydraulic actuated clutch so it could just be low on clutch fluid or one of the pipes going from the pedal to the clutch could be burst.

Feb 06, 2011 | 2000 Ford Focus

1 Answer

Had my clutch changed 4mths ago, everything was fine... pedal for clutch sometimes feels a bit sticky to floor, goes into gear ok and clutch seems fine, could this be air in in the pipe?


POSSIBLE AIR IN HYDRAUIC LINE BLEED THE VALVE KEEPING AN EYE ON FLUID IT HAS A VERY SMALL RESEVOIR. OR CHECK PEDAL RETURN SPRING MIGHT HAVE LOST TENSION.

Jan 27, 2011 | 2001 Ford Focus

2 Answers

Clutch pedel stuck on floor


The clutch master has blown out

Jan 19, 2010 | 1990 Ford F250

2 Answers

My '98 Escort ZX2 has 175,000 miles. I recently noticed a grinding or chattering with the clutch pedal depressed with the transmission in first gear. While stopped at a light the car suddenly began jumping...


Hi:
You need to check your clutch master cylinder reservour, not your brake cylinder. It is located approx in front of the clutch pedal, outboard of the brake cylinder. If it is low, you need to inspect for leaks around it, the lines connecting it to the clutch slave cylinder that is mounted on the transmission.

Dec 05, 2009 | Ford Escort Cars & Trucks

1 Answer

Clutch pedal fades after repeated clutching - 98 Forester


if the pedal got lot of play if its hydrolique air in the system or missing oil brake fluid goes in the reservoir pierre

Dec 13, 2008 | 1998 Subaru Forester

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...