Question about Ford Ranger

Open Question

Where is the ignition relay on a 97 ford ranger. my ignition fuse keeps blowing. worried about driving truck with bad winters in wny

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: i need a 2002 ford ranger fuse box diagram and afuel pump relay switch diagram

Hi

go to www.motorcraftservice.com then click on the owner guide and put in your truck information
then choose the 1st owner manual printing and should be between page # 184 to 200.

Good luck and I hope this will awnser your question.

Posted on Nov 08, 2008

Ad
  • 1 Answer

SOURCE: ford ranger truck overheating

I have had this happen with my ranger. Changed everything I could to try to fix the over heating. It turned out that I had a small leak in my head gasket and it was allowing exsaust gas to go into the cooling system witch was over pressurizing it. Also the air from the exsaust will heat up much faster than liquid making your thermostat to read hot and will not be able to blow hot air in the cab because there is no liquid going to the heater core. This happened to me when my blet came off and I tryed to make it home. If you had it over heat for a long peirod of time it may have ripped the head gasket.

Posted on Feb 21, 2009

  • 82 Answers

SOURCE: 20 amp ignition fuse keeps blowing

I'm curious, does this vehicle have an alarm/remote starter? If so I expect the installer didn't wire it correctly ... it was an all too frequent issue, with inexperienced installers we had .... I would first suspect any add-on device first (if any) ... In answer to your question ... I know it does have a relay (Starter solenoid is a relay and built onto the starter) As far as it being a relay or the IGN switch ... I'm skeptical.

Posted on May 05, 2009

  • 5610 Answers

SOURCE: 1991 ford ranger 3.0 eec relay fuse keeps blowing fuel good no sp

I understand that there is a relay box under the hood with 3 relays. Which is which I don't know. However if you are blowing the fuse TO the ecc relay, then the relay must be bad. This relay controls the spark.

Posted on Jul 25, 2009

  • 1 Answer

SOURCE: ford f350 diesel truck 30 amp fuse keeps blowing.

It is the fuel heater, All you have to do is unplug it.a4c0d50.gif

Posted on Jan 06, 2010

Testimonial: "Thanks for the diagnosis. It's disappointing that our local Ford service will not advise to help get it running, even to make it in for service."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my fuse for fuel pump keep blowing on 1992 ford ranger even after i replaced relay thinking that was the part needed?


the power wire to your relay or pump is very weak or grounding take a reading with an ohm meter continuity one lead from fuse other on ground

Mar 26, 2012 | 1992 Ford Ranger

1 Answer

What would cause the 30amp ignition fuse on 95 ford ranger to blow?


WHEN A FUSE BLOWS YOU HAVE A SHORT OR SOMETHING SHORTING OUT IN THAT CIRCUIT.MANY THNGS CONTROLLED BY 30 AMP FUSE PCM POWER RELAY, POWER WINDOWS.LOOK ON FUSE DIAGRAM COVER FOR 30 AMP FUSE THAT BLOWING SEE WHAT CIRCUIT THAT FUSE CONTROL OR LOOK IN DASH OWNERS MANUAL SEE WHAT THE 30 AMP FUSE CONTROL SEE WHAT CAUSING IT TO BLOW.

Sep 11, 2011 | 1995 Ford Explorer

2 Answers

I keep blowing the 30 amp max fuse. I don't know if it is to the ignition or the fuel pump.


look under the top of the power distribution box it has a diagram.
The max fuse blowing means you have a serious short,a hot wire touching ground perhaps it's broken or pinched somewhere.

Aug 12, 2009 | 1996 Ford Ranger SuperCab

1 Answer

1991 ford ranger 3.0 eec relay fuse keeps blowing fuel good no spark.Changed the distribitor, changed the ignition module.


I understand that there is a relay box under the hood with 3 relays. Which is which I don't know. However if you are blowing the fuse TO the ecc relay, then the relay must be bad. This relay controls the spark.

Jul 25, 2009 | Ford Focus Cars & Trucks

3 Answers

95 FORD RANGER NO INST. PANEL LIGHTS AND PARKING LAMPS


you might have blowed blulbs check that also there might be what is called a fuse link in the wiring

Mar 15, 2009 | 1995 Ford Ranger Supercab

1 Answer

Fuse relay


you have grounded the white wire some where .

Oct 26, 2008 | 2005 Ford Ranger

2 Answers

Wiring Diagram for 2005 Ford Ranger XLT


I have wiring diagram. Respond with your email address or fax number and I will sent it to you.

Sep 18, 2008 | 2005 Ford Ranger

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

fordexpert

Level 3 Expert

5608 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...