Question about Cars & Trucks
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
timing cover has marks on it,line it up with pulley,remove pulley and cover,check to see if any marks on camshaft.un do tensioner.to be sure make your own marks
Posted on Jan 02, 2010
The warning light has two states. A blinking light indicates a critical
problem with gaseous emissions from the engine that is likely to cause
permenant damage to the engine, exhaust sytem or catalytic converter. A
blinking light must be remedied immediately, and the car should not be
driven in this state, at the risk of causing serious and permenant
damage to the engine, exhaust and/or catalytic converter. Repairing or
replacing these parts can be extremely expensive. A reputable garage or
a Vauxall/Opel garage should be able to diagnose and repair the
A solid (unblinking) light indicates a non-critical fault in the emmisions exhaust system. Many faults are covered by this light including failures in emssions sensors, temperature sensors and a variety of other parts. This usually results in a higher than average amount of environmentally harmful pollutants being expelled from the car, loss of power and/or gradual damage to the engine, exhaust and catalytic converter. While the car can still be driven with a non-critical emmisions problem, it is highly recommended that the fault is diagnosed and repaired at a reputable garage or Vauxhall/Opel garage.
Posted on Jan 16, 2010
You can drain the cooling water from the bottom remove the black hoses attached to the cooling .
Posted on Nov 14, 2011
You can try to pull on the belt with the plastic trim piece removed the take a flat tipped screwdriver the release the arm or bar holding the belt in the lock position. Most of these have a spring on them. That spring can fall out. Or sometimes the bar or lock arm may be jammed and needs to be pried loose then lubricated to prevent this from repeating in the future.
Posted on Jun 04, 2012
Tips for a great answer:
Feb 14, 2017 | Cars & Trucks
Nov 11, 2016 | Holden Cars & Trucks
May 20, 2016 | Holden Cars & Trucks
Jan 01, 2015 | Holden Cars & Trucks
Sep 23, 2014 | Holden Cars & Trucks
Aug 12, 2014 | 1999 Holden Vectra
Jun 04, 2012 | Holden Vectra Cars & Trucks
Apr 30, 2012 | Holden Vectra Cars & Trucks
16 people viewed this question
Usually answered in minutes!