Question about Cars & Trucks

Open Question

You tube getting waylon jennings won't come up on google. It always has in the past.

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the location of orifice tube on a Ford windstar limited? Th


i would think its a crank sensor fault they dont always show up, when engine is warm try to rev engine past 3500 revs if it starts to miss then thats your problem.

Jun 09, 2017 | Ford Windstar Cars & Trucks

1 Answer

2003 ford windstar pumping gas spits back


Assuming the spitting happens when the tank is NOT full, almost always it is caused by a blockage of some kind. Either the fill hose is kinked, or someone has stuck something down the filler tube. Check for blockage. One way to check, is to get about 4 feet of large (1/2" ?) clear plastic tubing and run it down the filler. Before you go too far past the neck opening, be sure you will be able to pull it out without getting stuck. Have a screw driver handy to release the trap door if necessary. You should be able to stuff at least two feet down. Though it is possible some filler hoses have a wire spiral trap device to keep things from getting into the tank, like siphon hoses, etc.

Sep 09, 2014 | 2003 Ford Windstar

1 Answer

How to change sparkplugs on 2008 jeep commmander 3.7 engine


Assuming you have ignition coils on top of them

Remove the coils then the spark plugs

Lots of You Tube Video to see what is needed

ALL Vehicle problems are found

1--using Google to ask the questions
2---always go to you tube video

Aug 12, 2014 | 2008 Jeep Commander

1 Answer

Where is the MAF/IAT sensor on a 2004 Chevrolet Silverado ?


You Tube Video--always go there,always

Google--always use that & read what is in print, for decades

In or on the intake plastic ducting between the air
filter box & the throttle body on ALL (98%) of vehicles
you can find the MAF,follow the wires

I would guess 90% have the IAT also inside & part of the maf

Jul 16, 2014 | 2004 Chevrolet Silverado SS

1 Answer

Where to get 1996 ford 4.6 v8 serpentine belt diagram?


On the internet

Google the question for a picture

Google & You Tube Video -that's what you use for
any & every subject

Always go with what is there on the net, verse
asking for anything & find several sources to
compare to what your vehicle needs

Jul 15, 2014 | 1999 Ford Windstar

1 Answer

Won shift overdrive po765


PO765--Shift Solenoid D
You can google any codes you get & use
You Tube Video to get any & all trans answers,
& see all the problems & watch the units being rebuilt
I would guess on a 2001 car that trans is coming
out & be rebuilt

Aug 08, 2013 | 2001 Ford Focus

1 Answer

Repairing Gas line filler tube


Simple, don't try to put gas in it. Actually you could get a siphon hose in past the filler tube and past the leak, putting gas in that way. Temporary? If at all possible to get a roll of tape around it where it's situated, I might try duct taping the **** out of it. I wouldn't waste my good Gorilla Tape on it, though. It won't really seal anything, might just stem the flow a little.
If it is cracked on one side, you could loosen the hose clamps, and see if you could turn the hose where the leak is on the upper side. That way it won't leak as much. I've dealt with this before. Nothing really works! Just wait for the new hose, preferably sooner. Keep your tank low with gas (1/4 full) and you be fine.

May 24, 2012 | 1999 Isuzu Rodeo

1 Answer

Were can i find the orifice tube on 1999 buick lesabre?


Always just before the evaporator inlet,in engine
compartment

Have to remove a/c hose to get to it

Don't do that

It won't have anything wrong with it

You will only polute the atmoshere
with refrigerent,then be totally lost

Need a repair shop

Jul 20, 2011 | 1998 Buick LeSabre

1 Answer

I have a sunpro after market tach. i need the color coded diagram to install it,can anyone help me?thanx


Tried going to sunpro online? paste this in and it should get you there:http://www.google.com/search?q=sunpro+tachometer+wiring&ie=utf-8&oe=utf-8&aq=t&rls=org.mozilla:en-US Ive always found that going to the source is better than getting it second-hand.

Apr 23, 2010 | Chevrolet Silverado Cars & Trucks

2 Answers

I got a 92 Ford F250 and I was recently changing filters on it (its got the 5.0) and I noticed that the crankcase breather located in the air box always falls apart (i have had several of these types of...


Your PCV valve is usually about a $2 part and is suppose to keep oil out of this tube. Follow the tube back to the valve cover and the PCV valve should be there.

Excessive blow by could also cause oil to get into this tube. The blow by is usually caused by worn piston rings or valve guides. The compressed air/fuel mixture or exhaust pushes past these areas and make it into the crank case. Usually if you have a lot of blow by, you'll see your dipstick tube popped out a bit too.

PCV valve is cheap and easy to change... I'd give it a try.

Mar 30, 2010 | 1992 Ford F250

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75842 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...