Question about Cars & Trucks

Open Question

It is battery operated and the wires to the chime have been pulled out

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer


Make the chime come on and find where it is and just pull it from the receptacle on the wiring harness. There may be a clip holding it in place you must depress or pull out. It wont hurt a thing by doing this. You better get another door key made to keep in your wallet though, for there's nothing to remind you that you're getting ready to lock your keys in the car.

Nov 12, 2017 | Cars & Trucks

1 Answer

Diagram for connecting a battery operated door chime to push button

IF you are going all elec,you need a door bell,bell transformer and of course the push button. This is all low voltage so phone wire will work.You are just using 1 pair of wires so pick a pair such as the blue pair.Wire from push button to transformer to door bell.It is not polarity senstive....simple to do

Mar 17, 2015 | Cars & Trucks

2 Answers

How do I disconnect the chime from automatic door .Had to cut cable as it jammed . Took out fuse but radio and clock now do not work .Can I disconnect wire from chimes .I knoe it comes from speakers .

try this
disconnect battery
undo the fuse box and look at the wires behind that fuse you pulled

check that only radio and clock wiring are fitted there

the chime may its own power source

i could be wrong
i thought chime was separate to sound system speakers
and comes from a small but loud sound device on the instrument panel circuit board ..much like a computer

May 28, 2014 | 2005 Buick Terraza

1 Answer

I have a 2001 pontiac grand am and once i plug in the stock stereo the door chime sounds but when i turn the car off and take the keys out of the ignition the door chime still sounds!! How do you fix

Chimes are generated by the radio. Unplugging the radio and then plugging it in can activate the security feature in the radio and is very unwise. You can try resetting it by disconnecting the negative battery wire, then plugging the radio in and reconnecting the battery wire. If that doesn't work, check with a dealer to see if they can reset it, but if the radio has been damaged by what you are doing, you may have to replace it.

Jul 14, 2017 | 2001 Pontiac Grand Am SE

3 Answers

Navigator Door Chime goes off when car off and I open the door. Radio system stays on & interior lights go off when door shuts.

All this comes from the GEM module,You will need to repair the driver door lamp switch located in the door lock assemble.

Mar 15, 2012 | 2003 Lincoln Navigator

1 Answer

How do we disable the door ajar chime? My driver side KIA Spectra 2002 door won't fully close following a recent collision and between now and repairs, I'd like to disable the annoying chime or...

You have to pull the door panel off. Then there are a couple of plugs that go to the door latch mounted on the jam. One of the plugs is for the chime. Pull it, but you might have to put a jumper wire in the plug. I work on a lot of different cars and seen them work both ways. So I am not entirely sure how yours works. Unplug it and if it goes off your done. if it doesn't, use a jumper wire in the plug.

Aug 22, 2011 | 2002 Kia Spectra

3 Answers

My door chime wont stop ringing when the driver side door is open and the keys are out of the ignition. how can i fix this?

I just found out that the problem on our 1998 windstar was the chime switch attached to the ignition switch. This chime switch when dislodged will short and act as if the keys are still on when the door is open ( thus sounding off the alarm). I had a hunch that the problem was close to the steering wheel because the alarm would stop if I change the angle of the steering wheel a couple of notches up or down. I guess when i did that the chime switch that i'm pertaining to get reset to the right position and stops the alarm. when i opened up the steering wheel housing around the ignition , the chime switch fell, it had a blk wire I think, and I saw that the clips on it were kind of melted thus not sticking to its right position. I just had to remove the ignition switch for a while and replaced the chime switch with the help of a zip tie wrapped around it. then I placed every part back together and no chimes... also I did this all while the battery was disconnected because i needed the ignition switch to be in the on position to get it off the steering wheel. Good luck guys!

Apr 30, 2010 | 1992 Honda Civic

2 Answers

Seat belt chime always on belts operate correctly how do I stop the chime? 1992 honda civic

Find the wire under the seat and disconnect it, or pull the fuse (just make sure the fuse is not operating anything else).

Jul 04, 2009 | 1991 Honda Accord

1 Answer

No door chime, radio won't turn off.

Did you have to splice any wires? Also could you have been sold the wrong harness, and chime modual?

Jul 01, 2009 | 2000 Chevrolet Cavalier

2 Answers

Chime Moduel

just plug it in

Jul 19, 2008 | 1998 Saturn SL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

77947 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14405 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides