Question about Cars & Trucks

1 Answer

Location of wiper motor on 2006 freestar sel - Cars & Trucks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 11,067 Answers

Do you see the wiper arms and blades ? The motor is under the plactic cowl below the wiper arms . may be a video on youtube showing how to get to it. How To Install Replace Windshield Wiper Motor 2002 09 Ford Focus

This isn't the same vehicle , mite be close ! It will give you a look at what has to done to get at the motor

Posted on Dec 25, 2016

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4369 Answers

SOURCE: Front Windsheild Wipers

I have 2007 only. please rate as solved if this is what you needed. good luck.

SECTION 501-16: Wipers and Washers 2007 Freestar/Monterey Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 04/27/2006
Wiper Motor — Windshield s7w~us~en~file=adobe.gif~gen~ref.gif Printable View (104 KB) Removal

  1. Remove the windshield wiper arms.
  1. NOTE: Disconnect the washer hose before removing the cowl panel grille.
    Remove the pushpin-type retainers and the cowl panel grille.
  1. Remove the washer hose grommet from the cowl panel and position aside the washer hose.
  1. If equipped, remove the A/C air inlet filter.
  1. Remove the 9 cowl panel bolts and position aside the cowl panel.
  1. Disconnect the windshield wiper motor electrical connector.
  1. Remove the cowl panel from the vehicle.
  1. Remove the 4 bolts and the windshield wiper motor.
    s7w~us~en~file=n0001518.gif~gen~ref.gif
Installation
  1. Position the wiper pivot arms on the windshield wiper motor and install the bolt.
    • Tighten to 15 Nm (11 lb-ft).
  1. Install the 3 windshield wiper-to-cowl panel bolts.
    • Tighten to 15 Nm (11 lb-ft).
  1. Position the cowl panel in the vehicle and connect the windshield wiper motor electrical connector.
  1. Install the washer hose and grommet in the cowl panel.
  1. Install the 9 cowl panel bolts.
    • Tighten to 6 Nm (53 lb-in).
  1. If equipped, install the A/C air inlet filter.
  1. Position the cowl panel grille in the vehicle and connect the washer hose.
  1. Install the pushpins.
  1. Install the windshield arms and nuts.
    • Tighten to 27 Nm (20 lb-ft).
  1. Cycle and park the windshield wipers to check for correct alignment.
3c6f4d5.gif
b8a2ebf.gif

Posted on Apr 10, 2009

  • 7 Answers

SOURCE: 2006 ford focas wiper motor works but the wipers

the arms going to the wipers are broken they are called the transmission arms see if there is a clip that holds them to the motor or maybe a bolt has worked its way loose if not replace the transmission for the wipers

Posted on Jun 14, 2010

SOURCE: ford 2006 freestar sel, violent

The job either wasn't done correctly or somehow the Wheel Sensor Harness, got involved in a way it shouldn't have.

Posted on Sep 28, 2010

oki9501
  • 45 Answers

SOURCE: How do i remove front wiper motor from 2005 ford freestar

It's actually no where near as bad as you may think. And only requires basic tools.

1st remove the wiper arms.
2nd remove the cowel cover. I suggest slowly pulling from the one corner then working your way to the center. When you replace the cover try to make sure everything is lined up as it can be a pain to put back on if the holding clamps are not ligned up.
3rd remove the lower deck/lid/cowel. Pretty simple again basic sockets, just make sure to keep all the bolts in order as you have short and long ones(bolts) maybe taking a colored marker, tape, what ever to mark which bolts are short or long.
4th unplug the wiper motor wiring harness.
5th remove the deck/lid

Once it's out you can remove the wiper motor.
I do suggest marking the arm positions though and doing and turning the new motor on prior to bolting everything back togethor so you can make sure the the 'wiper rods' are clear and won't hit against anything.

Bill

Posted on Dec 18, 2014

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 Freestar fuses for Instriment cluster. F2.16 (5A) and F2.8 (10A) Location ?


probable not fuse problem --look more like a speed sensor or abs wheel sensor

Aug 31, 2016 | 2004 Ford Freestar SEL

1 Answer

How to replace sliding door wire harness with chain fo 2006 ford freestar


ford sells parts at there parts counter brick and online
if you google there are 100s.
1st hit
i had to guess which of 8 submodels. SE , SEL, etc.
guess SES
right or left? guess, right.
wild guess, if this is wrong call them and ask for parts, they will find it and tell you, (any car made)
http://www.fordparts.com/Commerce/CatalogResults.aspx?y=2006&m=Ford&mo=Freestar#Search


base
http://www.fordparts.com/Commerce/CatalogResults.aspx?y=2006&m=Ford&mo=Freestar#Search

Jan 08, 2015 | Ford Cars & Trucks

1 Answer

Wheres the relay for the wipers on a 2006 dodge stratus


its in the engine compartment fuse panel.check for power and ground at the wiper motor

Oct 19, 2014 | 2006 Dodge Stratus

1 Answer

How can I fix the rear window wiper balde on my Freestar. When we turn it on, it goes down the door under the window and stays there.


All thats wrong is the 13 mm nut has come loose. Make sure the wiper is turned off, remove the cover of end of wiper. Remove arm, reset in place where it would be at rest (not moving). Reistall nut and tighten. You should be good as new

Apr 25, 2011 | 2006 Ford Freestar

1 Answer

Ford 2006 freestar sel, violent brake pedal pulsation in steering wheel when braking, replaced calipers, pads and rotors


The job either wasn't done correctly or somehow the Wheel Sensor Harness, got involved in a way it shouldn't have.

Sep 27, 2010 | Ford Freestar Cars & Trucks

2 Answers

Front Windsheild Wipers


I have 2007 only. please rate as solved if this is what you needed. good luck.

SECTION 501-16: Wipers and Washers 2007 Freestar/Monterey Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 04/27/2006
Wiper Motor — Windshield s7w~us~en~file=adobe.gif~gen~ref.gif Printable View (104 KB) Removal
  1. Remove the windshield wiper arms.
  1. NOTE: Disconnect the washer hose before removing the cowl panel grille.
    Remove the pushpin-type retainers and the cowl panel grille.
  1. Remove the washer hose grommet from the cowl panel and position aside the washer hose.
  1. If equipped, remove the A/C air inlet filter.
  1. Remove the 9 cowl panel bolts and position aside the cowl panel.
  1. Disconnect the windshield wiper motor electrical connector.
  1. Remove the cowl panel from the vehicle.
  1. Remove the 4 bolts and the windshield wiper motor.
    s7w~us~en~file=n0001518.gif~gen~ref.gif
Installation
  1. Position the wiper pivot arms on the windshield wiper motor and install the bolt.
    • Tighten to 15 Nm (11 lb-ft).
  1. Install the 3 windshield wiper-to-cowl panel bolts.
    • Tighten to 15 Nm (11 lb-ft).
  1. Position the cowl panel in the vehicle and connect the windshield wiper motor electrical connector.
  1. Install the washer hose and grommet in the cowl panel.
  1. Install the 9 cowl panel bolts.
    • Tighten to 6 Nm (53 lb-in).
  1. If equipped, install the A/C air inlet filter.
  1. Position the cowl panel grille in the vehicle and connect the washer hose.
  1. Install the pushpins.
  1. Install the windshield arms and nuts.
    • Tighten to 27 Nm (20 lb-ft).
  1. Cycle and park the windshield wipers to check for correct alignment.
3c6f4d5.gif
b8a2ebf.gif

Apr 09, 2009 | 2006 Ford Freestar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...