Question about Peugeot 405

Open Question

I put fiat ignition module amplifier in my peugeot 405 mi16 2.0 phase2 That is normal starting and engine dont shake Is likely to be low engine power

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

chiquititas
  • 1010 Answers

SOURCE: peugeot 405 glx diesel saloon 1995

check your gear oil
if your having a hard time to switch in the gear then you will have to change the clutch

Posted on Jul 03, 2008

  • 110 Answers

SOURCE: Peugeot 405 td

The oil is probably milky or cloudy also .... I hope not.  If the oil is milky or cloudy too, it is likely you have 
blown head gasket cracked cylinder head warped cylinder head.
You could try something like Barr's stop leak radiator additive to plug up the place where oil and water are mixing, but I don't recommend this,  it will be temporary if it does anygood at all.
The car can continue to run for quite a while (months) like this, but will start losing coolant, and worse, you'll be sending coolant through the lubrication system, prematurely wearing out EVERYTHING inside the engine.
If you have coolant in the oil, this will be an expensive and time consuming repair. Fingers crossed there is not coolant in the oil.

Posted on Nov 01, 2008

  • 159 Answers

SOURCE: please,send me electrical diagram for peugeot 405 (2004)

Goto Amazon.co.uk

Search 'books' for Peugeot 405 (you will find the Haynes Manual). Make sure you choose the right one for your Year & type (Petrol/Diesel) = the wiring diagrams are in the back. Cost is about £20.

You can also borrow the Manual from your local Library for free ..

Posted on Feb 10, 2009

  • 8 Answers

SOURCE: Peugeot 405 1993 diesel estate

the alarm control unit is fitted under the drivers seat can be accessed from the rear foot well by putting seat fully forward .unscrew the two nuts holding the cover the relays are inside the unit.

this unit interfaces will tell the fuel stop solenoid to release (by applying 12 volts)

the fuel stop solinoid is on the main diesel pump under the bonnet - the exac location on the pump will depend on the make - but it should be cylindrical and have one wire connected to it - (i dont think peugeot were using multi wired coded soleniods in 93)

obivously if your car has the keypad immobilser you will know where this is - if it is the remote alarm immobilser the reciever is in the over head consol near the interior front light

Posted on Feb 13, 2009

  • 1 Answer

SOURCE: hi i have a peugeot 405 diesel and the speedo

I had a similar problem with my old peugeot 405 diesel, something electrical was shorting and actually sparking in the engine compartment which in my case the garage fixed very easily. Same symptoms, the speedo flickered at low speeds but stopped at higher speed.

Posted on Dec 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Greetings for All I need Peugeot 405 Alternator/Power Steering Drive Belt diagram


a serp belt layout is what you require
is this your vehicles engine... if so
the tensioner needs to be moved and held so you can get the belt on
26179957-343vouaw2fo2jhrbxrgaiaqu-5-0.jpg

Apr 29, 2016 | Peugeot Cars & Trucks

1 Answer

Peugeot 307 sw ignition switch fuse keeps popping????sometimes the car will start and work normally but other times the dash lights illuminate but nothing works and the car wont start. replace the ignition...


there are three likely problems.... check the battery of the vehicle if the battery is still ok, or the alternator is not supplying the right power and finally the fuse box has some burnt part in it internally...

Jan 31, 2010 | 2005 Peugeot 405

1 Answer

Hi i have a peugeot 405 diesel and the speedo


I had a similar problem with my old peugeot 405 diesel, something electrical was shorting and actually sparking in the engine compartment which in my case the garage fixed very easily. Same symptoms, the speedo flickered at low speeds but stopped at higher speed.

Sep 21, 2009 | Peugeot 405 Cars & Trucks

1 Answer

Engine management light on. car shaking when started.


i think its a common peugeot fault as my 2005 plate 206 and the wifes 2002 plate 307 both have the same problem.

Jul 25, 2009 | 2005 Peugeot 405

1 Answer

Peugeot 206 Engine Power Loss


Sounds like your Mass Air Flow sensor is in need of service/ cleaning.

Jul 07, 2009 | 2005 Peugeot 405

1 Answer

My Peugeot 206 has a rattle


Sound like pre-ignition problem. pre-ignition is caused by running too low an octan fuel in the engine. The way octane works is simply the lower the number the faster the burn. If the fuel burns before the piston gets to the proper position in the cylinder it can cause what is call in the industry a ping. The remedy is to use a highert slower buning octane fuel or change the ignition timing. Mind you some engines with higher compression may not like the lower octane fuel even after adjusting the timing.

May 05, 2009 | 2005 Peugeot 405

2 Answers

I have just bought a peugeot 206 Hdi and the coil light dosn't go


glow plug light should just flicker as not needed until -6 stop light stays on when off until started

Apr 04, 2009 | 2005 Peugeot 405

3 Answers

Oil coming out of exhaust and whistling turbo


it sounds like your turbo has packed in firstly the oil seal in your turbo has failed thats why ur seeing oil from exhaust & the whistling from turbo is the vanes in turbo breaking up so i would advise not to use car until new turbo is fitted & inter cooler pipes and inter cooler itself are checked & cleaned for swarf from turbo you can check turbo by disconnecting turbo pipe &inspecting turbo vanes (fins) to see if broken up or any damage to chamber.

Feb 14, 2009 | 1991 Peugeot 405

2 Answers

Peugeot 206 starter motor not turning


put your voltmeter on the little cable that goes to the starter and check the volts there will turning the key to the start position if you have power ...yes its the starter...if you dont then it could be the starter relay

Dec 30, 2008 | 2005 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Wahs Team

Level 2 Expert

205 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...