Question about Dodge Cars & Trucks
If the security is set. It will turn 3 trys, then quit. Try locking it down. All doors and hood. Use the Key fob to open. No fob, open the drivers side first, try to start. no luck, lock it and open the passenger side. Still no luck, have the system scanned.
Posted on Dec 24, 2016
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: 2004 dakota won't start
sounds like a crankshaft position sensor..fairly common problem on these 3.7 engines..check for fault codes in engine controller..can mbe hard to get out of engine block..seize in..sometimes have to come out in pieces..it is located on passenger side rear of engine..1 bolt holds it in..3 wire connector..below exhaust manifold in side of block..fairly inexpensive part..recommend dealer part
Posted on May 21, 2009
could be Fuel Injectors, are bad ?
all you need is # 1 Fuel Injector, to go out that will not get Fire, and Fuel Mixture to Spark Plug.
Posted on Jun 03, 2009
Shouldn't really be necessary to do anything to reset it if the system is operating properly.
"The system will automatically update and the TPM warning lamp will extinguish once the updated tire pressures have been received. The vehicle may need to be driven for up to 10 minutes above 15 mph (25 km/h) to receive this information."
"A system fault can occur by any of the following scenarios:
1) Jamming due to electronic devices or driving next to facilities emitting the same Radio Frequencies as the TPM sensors.
2) Installing some form of aftermarket window tinting that affects radio wave signals.
3) Lots of snow or ice around the wheels or wheel housings.
4) Using tire chains on the vehicle.
5) Using wheels/tires not equipped with TPM sensors."
Also, if you have the premium TPM system, the spare tire being low could trigger it, or with either the base or premium system, if you have a flat and change to a spare, the original flat tire could keep it from re-setting. And of course, a faulty sensor could be the problem.
There is a re-setting tool, but that should only be needed if the tire positions are changed (like if you rotate your tires), and that's only so that it can accurately tell you which tire is low, as opposed to turning off a warning light.
Good luck and thank you for using Fixya.
Posted on Mar 08, 2010
Tips for a great answer:
Sep 12, 2015 | Dodge Cars & Trucks
Aug 09, 2014 | 2004 Dodge Durango
Dec 22, 2013 | 2004 Dodge Durango
Nov 01, 2013 | 2004 Dodge Durango
Dec 30, 2012 | 2004 Dodge Durango
Sep 25, 2012 | 2004 Dodge Durango
Dec 19, 2010 | 2006 Dodge Durango
Nov 19, 2009 | 2004 Dodge Durango
36 people viewed this question
Usually answered in minutes!