Question about 2005 Chevrolet Astro

Open Question

Removing gas filter in very tight space of 2005 chevy astro van?

Fitting towards rear of van / difficult to get wrenches on /cause too close to gas tank

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

BLAZZ81
  • 281 Answers

SOURCE: chevy astro van turns over but wont start when

Check to see if the fuel pump is kicking in,
when you turn the key on without starting the van you should hear it kick on for about 2 seconds,

It could be...
A clogged fuel filter...
Blown fuse for the pump..or bad pump relay..
No gas
Bad fuel pump

Posted on Mar 07, 2009

  • 1 Answer

SOURCE: location Fuel Tank Pressure Sensor on a 2005 chevy express van

lOOK UNDER THE REAR OF THE VEHICLE ABOVE THE SPARE TIRE ON A CROSSMEMBER BETWEEN THE FRAME RAILS.

Posted on Apr 24, 2009

  • 87 Answers

SOURCE: 2005 Chevy astro van, 4.3L A/c, Blower motor,

It could be a bad blower motor - tap on the blower motor with the end of a hammer when you have the switch in the on position - if it comes on then it is a bad blower motor. If it doesn't come on I would check to make sure you are getting power and ground to the HVAC control head.

Posted on Aug 06, 2009

  • 3600 Answers

SOURCE: How do I remove the dashboard from my 2000 Chevy Astro Van?

Paul is right you can go to radio shack or autozone schucks or any parts store and ask for the removal tool it cost $20.00 tops. Trust me you don't want to undo the dash as the air bag could detonate if you shorted the two wires that can control it and it could kill you.

Posted on Sep 22, 2009

Testimonial: "Thank you! I didn't even think about the safety aspect of removing the dash. Better leave this to the pros!"

  • 106 Answers

SOURCE: 1999-chevy astro van,rear end clunks when you go

driveshaft ends or a loose break caliper. take to mechanic they will usualy point it out. without charge.

Posted on Feb 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

98 chevy astro van p0172


code is to rich, will need scan tool to figure out how rich its running sorry.can be alot of things , must go thru test procedure its to long to fit in this space

Mar 18, 2011 | 1998 Chevrolet Astro

2 Answers

Where is the fuel filter on a 2005 chevy malibu, 4 cylinder


  • Remove the gas cap to relieve pressure in the tank. Lift the hood and locate the fuse panel on the driver's side. Remove the fuel pump fuse. Turn the ignition and attempt to start the car; if it runs, allow it to stall. Turn off the ignition. Remove the negative terminal from the battery.
  • 2 Locate the fuel filter beneath the car between the rear axle and the gas tank. Remove the protective plastic cover with a screwdriver.
  • 3 Remove the carriage bolt securing the filter to the frame. Detach the inlet and outlet fuel line fittings with an open-end wrench. Fuel may spill as you turn the nuts, so have rags or a small container ready.
  • 4 Insert the new filter and secure the fuel lines and carriage bolt. Reattach the plastic cover.
  • 5 Replace the fuel filter fuse, negative battery terminal and gas cap. Close the hood and turn the ignition on. Allow the car to idle for a few minutes while the new filter fills with gasoline.



  • Dec 13, 2010 | 2005 Chevrolet Malibu

    1 Answer

    Where is fuel filter located on 2005 pontiac grand am?


    Removing the Fuel Filter
  • 1 Unscrew the fuel cap. This will relieve the pressure in the fuel lines.
  • 2 Crawl under the vehicle and locate the fuel filter. The filter is located by the cross member in front of the fuel tank.
  • 3 Separate the tabs on the quick connect fitting and pull off from the fuel line. This is the inlet line.
  • 4 Unscrew the outlet line with a crescent wrench. Pull the outlet line off the filter.
  • 5 Unbolt the mounting bracket with a socket wrench. Pull the filter off.
  • Installing the Fuel Filter
  • 1 Bolt the new filter to the mounting bracket with a socket wrench. Ensure the arrow points toward the front of the vehicle. The arrow indicates fuel flow.
  • 2 Push the quick connect fitting on the inlet line of the filter. The fitting will click in place when the line is properly installed.
  • 3 Bolt the outlet line to the filter with a crescent wrench. Ensure the line is snug.
  • 4 Screw the gas cap back on to the fuel nozzle. Close the gas door.
  • 5 Start the car to allow the fuel to circulate through the fuel lines. Listen for any stalling or hesitation
  • Oct 29, 2010 | 2005 Pontiac Grand Am

    2 Answers

    Replace 2005 chevy venture air filter


    Use a flat screwdriver under the hose where the clamp was, try to get it loose from the plastic housing, they are in a tight space and very difficult sometimes. Use lots of force and it will give up.

    Jan 10, 2010 | 2005 Chevrolet Venture

    1 Answer

    Whe ere is the fuel filter located on 2001 chevy astro van and how do ou change it c cxdee3


    it is located under body on frame rail almost directly under drivers seat a 16mm and a 20mm wrench and a screwdriver for the retaining clamp

    Jan 01, 2010 | 2001 Chevrolet Astro

    1 Answer

    2005 Chevy astro van, 4.3L A/c, Blower motor,


    It could be a bad blower motor - tap on the blower motor with the end of a hammer when you have the switch in the on position - if it comes on then it is a bad blower motor. If it doesn't come on I would check to make sure you are getting power and ground to the HVAC control head.

    Aug 04, 2009 | 2005 Chevrolet Astro

    3 Answers

    Fuel filter replacement removing old filter


    An inline filter can be found in the fuel feed line attached to the rear crossmember of the vehicle.

    1. Properly relieve the fuel system pressure.
    2. Raise and safely support the vehicle with jackstands.
    3. Grasp the filter and nylon fuel line fitting on the tank-to-filter line. Twist the "quick-connect'' fitting 1⁄4 or a turn in each direction to loosen any dirt within the fitting. Use compressed air to blow out the dirt from the fittings at the end of the fuel filter.
    4. Detach the quick-connect fitting by pushing inward toward the filter and grasping the plastic tab around the connector and pull apart. If additional assistance is required to disconnect the fitting, tool J 38778 or equivalent can be placed between the filter and the fitting release mechanism to carefully force the two apart. Be careful not to bend the special tool. NOTE: Always use a back-up wrench anytime the fuel filter is removed or installed.
    5. Using a backup wrench (where possible) to prevent overtorquing the lines or fittings, loosen and disconnect the feed line from the filter. Be sure to position a rag in order to catch any remaining fuel which may escape when the fittings are loosened.
    6. Remove the fuel filter from the retaining bracket. To install:
    7. Before installing a new filter, apply a few drops of clean engine oil to the male tube end of the filter. This will ensure proper attachment and prevent a fuel leak.
    8. Position the filter into the retaining bracket with the directional arrow facing away from the fuel tank, towards the throttle body. NOTE: The filter has an arrow (fuel flow direction) on the side of the case, be sure to install it correctly in the system, with the arrow facing away from the fuel tank.
    9. Push the connectors on the quick-connect fitting together to cause the retaining tabs/fingers to snap into place. Pull on both ends of the connection to be sure they are secure.
    10. Connect the fuel feed line to the filter, then tighten, using a backup wrench to prevent damage, to 20–22 ft. lbs. (27–30 Nm).
    11. Carefully lower the vehicle.
    12. Connect the negative battery cable and tighten the fuel filler cap, then start the engine and check for leaks.

    Jun 28, 2009 | 1997 Pontiac Sunfire

    1 Answer

    1996 astro van stopped running


    Sounds like dirty gas and the fuel filter is clogged...try changing the fuel filter...some are under the car, but most are mounted against the firewall in the engine compartment.

    Apr 19, 2009 | 2005 Chevrolet Astro

    1 Answer

    Were is the fuel Filter


    LOCATION OF FILTER IS DRIVER SIDE FRAME RAIL ABOUT AT DRIVER DOOR HARD TO SEE BUT FALLOW FUEL LINE ITS THERE. hOPE THIS HELPS PLEASE RATE ME !! THANK YOU AND GOOD LUCK

    TOOLS Are Simple and inexpensive local Parts Store like AutoZone will Have it

    FUEL FILTER REPLACEMENT

    TOOLS REQUIRED
    J-46363 Fuel Line Release Tool

    REMOVAL PROCEDURE

    1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
    2. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
    3. Remove the fuel composition sensor bracket nuts.Reposition the fuel composition sensor/bracket off to the side
      1. Using a flare nut wrench and backup wrench disconnect the fuel line fitting from the fuel filter.
      2. Pull the quick connect fitting back until the internal retainers hit the filter stop.
      3. Twist one end of J-46363 and insert it between the fitting and the filter.
      4. Twist the opposite end of J-46363 and insert it between the fitting and filter.
      5. Once J-46363 is inserted, ensure that J-46363 is parallel to the filter and fitting.
        1. While holding the filter, push the fitting towards the filter in order to disconnect the quick connect fitting.
        2. Remove the fitting from the filter.
        3. Remove J-46363 from the filter.
          1. Remove the fuel filter from the bracket.
          INSTALLATION PROCEDURE
        4. Install the NEW fuel filter to the bracket.While holding the filter, push the fitting towards the filter in order to connect the quick connect fitting
        5. Using a flare nut wrench and backup wrench connect the fuel line fitting to the fuel filter.
          1. Position the fuel composition sensor/bracket into place. NOTE: Refer to Fastener Notice in Service Precautions.
          2. Install the fuel composition sensor bracket nuts. Tighten the nuts to 17 N.m (13 lb ft) .
          3. Lower the vehicle.

    Apr 07, 2009 | 2005 Chevrolet Avalanche

    1 Answer

    Chevy astro van turns over but wont start when


    Check to see if the fuel pump is kicking in,
    when you turn the key on without starting the van you should hear it kick on for about 2 seconds,

    It could be...
    A clogged fuel filter...
    Blown fuse for the pump..or bad pump relay..
    No gas
    Bad fuel pump

    Mar 07, 2009 | 2000 Chevrolet Astro

    Not finding what you are looking for?
    2005 Chevrolet Astro Logo

    Related Topics:

    18 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts

    yadayada
    yadayada

    Level 3 Expert

    75822 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8210 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...