Question about GMC Cars & Trucks

Open Question

Turned the ignition on this morning and some engine blower ran hard and still ran even after turning off the truck. this is a 2014 GMC sierra 1500

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 59 Answers

SOURCE: 1997 GMC Sierra Ignition Switch Replacement

take off the cover on the top and bottom of the steering column just behind the wheel. pop the tilt lever out simply just by grabbing it and give it a good tug. then once you have the new switch and you get in there your going to need an inverted torx socket to remove the small bolts that hold the switch to the column. do not move the gear on the new switch make sure it lines up exactly as the old one did!!!!!!!!!!!!

Posted on Mar 15, 2009

cshubart
  • 146 Answers

SOURCE: My Power window on my 2003 GMC Sierra 1500 Truck

if your main switch panel still works the passenger window and if door locks still work probaly bad window motor

Posted on Oct 21, 2009

ZJLimited
  • 17970 Answers

SOURCE: how do i change the blower motor on a 1994 gmc

GM Full-Size Trucks 1988-1998 Repair Information
Blower Motor - REMOVAL & INSTALLATION

Front
Without Air Conditioning
(see Figure 1)

  1. Disconnect the negative battery terminal.
  2. Mark the position of the blower motor in relation to its case.
  3. Unplug the electrical connection at the motor.
  4. Remove the blower attaching screws and remove the assembly. Pry gently on the flange if the sealer sticks.

d506667.jpg


Fig. 1: Blower motor wiring
  1. The blower wheel can be removed from the motor shaft by unfastening the nut at the center.
To install:
  1. Install the blower wheel to the motor shaft and tighten the nut at the center.
  2. Apply a bead of sealer to the blower mounting flange. Position the blower so that the marks are aligned and install the screws.
  3. Attach the electrical connection at the motor.
  4. Connect the negative battery terminal.


1991-98 C/K With Air Conditioning
  1. Disconnect the negative battery cable.
  2. Remove the instrument panel compartment.
  3. Unfasten the forward-most screw in the right side door sill plate. Remove the trim panel from the right hinge pillar.
  4. If necessary for access, unplug the ECM wiring and remove the ECM.
  5. Unplug the electrical lead at the blower motor and if equipped, remove the underdash courtesy lamp.
  6. Remove the bolt from the right side lower instrument panel support. Remove the blower cover and the cooling tube.
  7. Unfasten the flange screws and pull out the blower motor. You may have to pry back the right side of the instrument panel slightly. Be careful!
To install:
  1. Position the blower motor and install the mounting screws. Be careful not to catch the blower on anything when sliding it in.
  2. Install the cooling tube and the blower shield.
  3. Install the bolt into the instrument panel support.
  4. Attach the courtesy lamp and the blower electrical lead.
  5. If removed, install the ECM. Attach the wiring harness.
  6. Install the trim panel on the pillar. Don't forget the screw in the sill plate!
  7. Install the instrument panel compartment and connect the battery cable.


Rear
1992-98 Models
(see Figure 4)
  1. Disconnect the negative battery cable.
  2. Remove the right rear quarter panel trim.
  3. Disconnect the electrical lead at the fan.
  4. Remove the screws and if equipped, the cooling tube.
  5. If necessary, remove the fan retaining nut and lift out the blower fan.
  6. Remove the blower motor.
To install:
  1. Install the blower motor and then position the fan.
  2. Install the retaining nut and then tighten the mounting screws to 12 inch lbs. (2 Nm).
  3. If removed, install the cooling tube.
  4. Connect the electrical lead. Install the quarter panel trim cover.
  5. Connect the battery cable.
6911e6e.jpg

Fig. 4: Auxiliary heating and A/C system




Hope this help (remember comment and rated this).



Posted on Mar 31, 2010

  • 1608 Answers

SOURCE: 2004 gmc sierra 1500 blower motor location

The blower motor is on the passengers side under the dash.You might have to remove the a lower panel.This is the insulator panel.If the blower works at all just turn it on and follow the noise.Hope this helps.Good luck.

Posted on Apr 08, 2010

weekspena
  • 375 Answers

SOURCE: 2006 gmc sierra 2500 duramax, Heater blower motor

could be the blower motor relay orthe blower motor resistor

Posted on Jan 11, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Truck runs fine then dies while driving then will start back up and run ok.


About 56,700 results (0.76 seconds) Search Results

    GMC Sierra 1500 Questions - Truck suddenly stops running ...

    www.cargurus.com > Questions > GMC > Sierra 1500

    CarGurusJul 11, 2013 - Truck suddenly stops running, acting like it's out of fuel. ... start it and let it run until it dies then check the pressure and shut the key off. ... Was running fine and then turned off as if the ignition was turned of. .... Well mine was a loose battery connection that just shut down the vehicle completely while driving.

    1998 1500 5.2 Shuts Off Randomly - CarGurus

    www.cargurus.com > Questions > Dodge > Ram 1500

    CarGurusAug 29, 2011 - I let it sit for a second then tried to start it back up and it wouldn't start.... 2006 ram 1500 randomly dies while driving 13 answers ... truck started outrunning fine but would randomly die. wait a few ... Used GMC Sierra 1500".

    GMC Sierra 1500 Questions - started stalling and dying ...

    www.cargurus.com > Questions > GMC > Sierra 1500

    CarGurusJul 28, 2008 - The truck starts and dies. Have to give a little gas to keep running.While driving have to 2 foot it so it won't die. Wants to die when I come to a ...

    Engine Dies and Then Starts Right Back Up

    www.justautorepair.com/chevrolet/blazer/stalls-starts-up

Feb 04, 2016 | 1997 GMC Sierra

1 Answer

My2002 sierra with a4.8 with a good battery, all my dash lights and cd player come on but the truck doesnt turn over right away sometimes it takes 5-10 minutes 2 start of repetitively turning key over


battrey is good but truck makes no sound and wont even click

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusbattrey is good but truck makes no sound and wont even click ... Asked by Jennifer May 15, 2013 at 03:21 PM about the 2002 ... quite obviously the amps aren't getting through~ how do you know the battery is "good". the date ... If it turns over your power and starter are good but the ignition circuit ... Used GMC Sierra 1500".Missing: a4

Intermittant Failure to Start : Chevrolet Silverado 1500 ...

repairpal.com > Problems > Chevrolet > Silverado 1500
first start engine turns over alot. 2000 Chevrolet Silverado 1500. Hard start. When starting my truck it often takes two or three attempts. It kicks over but does not ...Missing: a4

Chevy Silverado and GMC Sierra Starting Problems - Car Forums at ...

forums.edmunds.com > Chevrolet > Chevrolet Silverado 1500

Oct 20, 2008 - 30 posts - ‎19 authors
i got a 2001 silverado 1500 and it wont start it turns over and fires and .... Put the key in and the truck barely starts due to the battery being weak. .... If it was really 8, the lights would be dim? .... I have a 2002 GMC Sierra 4.3L 2WD. ... I bled the fuel filter looking for air, but good fuel came out the top bleede ...Missing: a4

Jan 01, 2016 | 2002 GMC Sierra 1500

1 Answer

Why won't blower shut off?


03 - 06 Silverado/Sierra blower stays on with key off (how to ...

? 1:32
https://www.youtube.com/watch?v=PkltkvLDhIg
Apr 7, 2014 - Uploaded by MAY03LT
The HVAC blower in this 2003 Silverado stays on speed 5 even with the key off. Here's how to turn speed 5 of the blower off(while keeping speeds 1-4) and ho. ... How to replace blowermotor resistor in Chevrolet Silverado - Duration: 5:06. ... 2004Tahoe rear brake service (replace pads, clean/lube slides, ...

Blower motor won't shut off. - Diesel Place : Chevrolet and GMC ...

www.dieselplace.com/.../76.../208669-blower-motor-wont-shut-off.html

Jan 10, 2008 - 11 posts - ‎7 authors
I have read through many posts on blower motor issues but no one had the same issue I have. ... If I shut the truck off, it still won't shut off and runs until the battery is dead.... 2002 GMC Sierra RCLB 1500 4X4 SLE, 7 1/2' Fisher plow.

Question - Blower Motor Won't shut off ' Chevy Truck Forum ' GMC ...

www.gmfullsize.com > General > Maintenance

Dec 11, 2015 | 2004 Chevrolet Silverado 3500

1 Answer

I have a 2008 gmc sierra 1500 series and it turns on but i can't get it to shut off?


I think I would try a new ignition switch or at least unplug the switch after the engine is running and see if it stops running. When you initiate a start, a series of relays turn on in the powerbox. If the ignition relay is melted inside itself, it will not break connection. You can research and get diagrams, videos, and photos on the Web. Just be specific and enter the year, make, and model and ask for a wiring diagram or fusebox or powerbox for that truck. Then chose from the results.

You should be able to identify the correct relay from the diagrams. Relays are not terribly expensive.

Nov 29, 2014 | 2008 GMC Sierra 1500 2WD

2 Answers

This morning tried to start my 03 sierra 1500, i opened the driver door cab lights came on, put key into the ignition turned the key and the lights went out and the truck would not even crank nothing....


Try jump starting it. I suspect your battery is dead. After time they don't hold a charge as deep as they once did. Have it load tested to verify. Your lights and other options don't draw nearly what your starter needs.

Mar 10, 2011 | 2003 GMC Sierra 1500

1 Answer

2004 gmc sierra 1500 blower motor location


The blower motor is on the passengers side under the dash.You might have to remove the a lower panel.This is the insulator panel.If the blower works at all just turn it on and follow the noise.Hope this helps.Good luck.

Apr 08, 2010 | 2004 GMC Sierra 1500 Crew Cab

2 Answers

The blower motor in my 2005 GMC Sierra won't turn


bad actuator in dash very common on gm the dash may have to come out depending on which one is bad

Oct 24, 2009 | 2003 GMC Sierra 1500

2 Answers

Heat will stay on high until turn engine off and back on


check dial switch, check valve that lets water run through heater core

Aug 23, 2009 | 2000 GMC New Sierra 1500

2 Answers

96 gmc sierra hard to crank after 12-14 hours


that has a votec engine in it the fuel pressure is droping at knight and it takes 60 psi before the injectors will fire most likely cause fuel pump ,leaking injector ,or a feul pressure regulator

Jul 13, 2009 | GMC Sierra 1500 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...