Question about Hyundai Cars & Trucks

1 Answer

I pulled the ign1 fuse out inside my hyundai now it will not start plz help

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Hyundai Master
  • 1,373 Answers

Check the fuse you put back in maybe that has blown

Posted on Dec 24, 2016

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ign1 30amp fuse blows. getz where do i look for a short


Just think for a moment, what becomes live at position one ... cigar lighter and all the trinkets like car radio, etc. I would start there.

Mar 16, 2017 | Cars & Trucks

1 Answer

What is the fuse number for driver cluster, temp, fuel, sensors, and radio on 2002 Pontiac Montanna


Do you know where the Instrument panel fuse block is ? Open the right front door, end of the I/P or dash. End panel comes off . just grab an pull. Fuses under panel and are marked on inside of panel. There are four fuses. Cluster /Batt 10 amp fuse , PCM/PASSKEY/ CLUSTER 10amp , IGN1 10amp , and MALL/CLUSTER 10amp fuse .

Jan 11, 2015 | 2002 Pontiac Montana

1 Answer

Blower motor runs ignition off


bad news. that.
if the key is off, i check that IGN1 and IG2 and Accessory
pins on the key switch to be SURE they are at 0volts

if not i pull the Ignition switch connector, 0v now is bad switch.
12v is a major short in the cars electrical system.
shorting hot all time feed, to IGN1/2/Acc as it is.

the key switch kills all power to to the main fuse box. not marked
"hot all time" on the schematics.
free here
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

in this car , id look under dash and under hood for wiring hacks
I have this super accurate wiring Hack radar, can see it 25feet away.
the hands of the devil , are crystal clear.....

Jan 23, 2014 | Jeep Cars & Trucks

1 Answer

Radio display not working


sure inside, radio.
check all fuses first.
make sure all 3 power wires are in fact at 12v.
if not , fix that first.
power ( goes to IGN1.
Dial (goes to dash park dimmer ckt)
memory (hot all the time)

Dec 26, 2013 | 2004 Jeep Grand Cherokee

1 Answer

No power to the instrument cluster 1996 aurora


Hello! Lets check fuses first...If all prove to be good the ignition switch may be defective and needs to be replaced...(all inside front fuse box)...IP3 (10A)...IGN1 (10A)...PCM (10A)...(Rear fuse box)...IP1 (10A)...Lets hope it'sa fuse and not the ignition switch, they are rather expensive...If the fuses are OK. We could save some money for you if you have a multimeter and a wee bit of experience using one...I'll facilitate and we'll troubleshoot it down to a component....Guru..Saailer

Ignition switch for two door:

saailer_194.jpgACDELCO Part # D1482D...Cost=$150



Ignition switch four door...

saailer_195.jpg
ACDELCO Part # D1438F Cost $ 270

Sep 27, 2011 | 1996 Oldsmobile Aurora

1 Answer

I have a 2003 Astro and it will not start. I turns over but no spark.


Check for any blown ignition fuses(may be marked IGN1, 2, etc). check the ignition module located under the distributor rotor...check the coil(you can check it for continuity)

Jan 08, 2011 | 2003 Chevrolet Astro

1 Answer

Computer display on intrumental panel is off


http://mrfixit.webnode.com/step-by-step-instruction/

Most probably a weak solder joint. Also check IGN1 fuse in inside fuse block (left of dash).

Apr 20, 2010 | 2003 Chevrolet Silverado 1500

1 Answer

Where is the dash light fuse in a 97 saturn sl2


The junction block is located in the front of the center
console. The dash light is fuse#4 ign1 10amp.
Hope this helps.

Feb 28, 2010 | 1997 Saturn SL

1 Answer

My 2000 Hyundai Tiburon turns over but won't start.The car turns over but will not kick in. I've been told its either the fuel pump...the fuel pump fuse or the spark plugs...please help...I have to do the...


first turn the ignition on but not all the way to start it. listen to see if you hear a whining noise. your trying to listen for your fuel pump. if you dont hear it then open the hood and locate your fuse box. inside the box there will be a label remember your looking for the fuel pump fuse. when you found the fuse pull it out and hold it to the light. inside the fuse you can see the contact. look to see if its one piece or you can see a burned spot on the fuse. start there then well move on to the next thing

Nov 03, 2009 | Hyundai Motor 2000 Tiburon

1 Answer

2005 Saturn Vue Fog Lights and Instrument Panel do not illuminate


Try pulling the fuse for the DRL (daytime running lights.)

Jun 19, 2009 | 2005 Saturn VUE

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...