Question about Cars & Trucks

Open Question

Has any body tried to fit a harness for the steering wheel control for a double din radio

Posted by on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 10 Answers

SOURCE: double din radio doesn't fit in dash

i have a 2002 ford escape and i bought a double din radio and it did not fit and found out it is actually a din and 3/4 with out serious mods (cutting a bigger hole in dash) double din wont fit i bought a single din stereo and a din a 3/4 dash kit works fine

Posted on Jun 17, 2009

  • 3679 Answers

SOURCE: My 06 nissan altima has the steering wheel radio

the steering controls are made for that specific make of radio so look for the same make touch screen , then check it is compliant with the steering controls

Posted on Nov 18, 2014

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 06 nissan altima has the steering wheel radio controls, but I want to buy a new double din touch screen sterio. So my question is; if I install a new sterio, will it affect or cause my steering wheel...


the steering controls are made for that specific make of radio so look for the same make touch screen , then check it is compliant with the steering controls

Nov 18, 2014 | Cars & Trucks

1 Answer

Saab 9-5 radio replacement


Europarts .com columbus ohio very helpful with my 2000 turbo 93 radio pixels out bad easy fix after pullin unit out strips going tobboard dobthis quickly but not so long yu meltvthem back to board lightly with soldering iron press gently till they reseat to motherboard hot butter knife works to so yu can press flatter and control your heat so yu dont melt strips or make contact with anything else so no short outs all fixed pixels back!

May 30, 2014 | 1990 Saab 900 Hatchback

1 Answer

Steering wheel radio wires, i need a wire color diagram to steering wheel for the aftermarket radio i need to know the wire colors that controls what.


The wires that control the radio from the steering go to the Body Control Module (BCM), not directly to the radio. The BCM sends data over the serial bus to the radio.

Sep 18, 2011 | 2002 GMC Envoy

1 Answer

How do you take the radio out of a 1995 bonneville


You need to pull the plastic cover that runs all along your dashboard, a/c heater controls,and radio. You don't have to pull it out completely just enough where you can unscrew the 4 screws that hold the radio in its place. Just take a flat head screw driver and gently pry the plastic cover off around the radio area. You also might need to pull (with your fingers or flat head again) the cover by where the a/c vents are. Pull out as much as you need so you have room to stick a screw driver in. Once you unscrew the screws (bolts) pull the radio out slowly and begin to pull out the wire harnesses and antenna cable from the back of the radio and there you have!! If your going to replace your radio you will need a single din and you have to buy the adapter piece to put it in. A double din radio will not fit. Good luck.

Aug 31, 2009 | 1995 Pontiac Bonneville

1 Answer

Double din radio doesn't fit in dash


i have a 2002 ford escape and i bought a double din radio and it did not fit and found out it is actually a din and 3/4 with out serious mods (cutting a bigger hole in dash) double din wont fit i bought a single din stereo and a din a 3/4 dash kit works fine

Jun 10, 2009 | 2003 Ford Escape

1 Answer

Cd player in toyota paseo


Very simple. DIN size head units fit without any adapters (assuming your car has the DIN size factory radio with pocket underneath {I have '93 Paseo and this was the setup of mine, though Crutchfield.com shows option of factory stereo with pocket and without [guessing there was a double DIN size option]}). All you need is a wiring harness. I've seen these anywhere from $5 - $20. This will connect to the wires on the harness for your new radio, then instead of cutting any of the factory wiring, you simply plug the factory harness into this new socket.

The trim ring around the radio/climate control/ashtray area is held in with clips. It just pops out (may have to use a thin screw driver to get your fingers under one of the edges to start). Four screws hold the metal frame where the head unit, climate control, and ashtray are. Take those out and pull the metal frame out a bit, then disconnect the wires of the climate control, power lead to lighter, and stereo harness and antenna. Two screws per side hold the stereo in to the metal frame. Take those out, slide out the factory radio and put in your new head unit (You will not use the metal cage or any other mounting brackets the head unit may come with). The holes on the metal frame should line up with mounting holes on the side of your new radio.

Not to endorse one vendor over another, but Crutchfield.com supplies instruction sheets and any needed install accessories free with purchase of new head unit. Their prices are often slightly higher than you can find elsewhere (comparable to retail stores, usually more than online stores), but you get the wiring harness and instruction sheets for your vehicle. At the very least, you can use their site to see what fits your vehicle (Note: Many other stores do this as well.)

May 31, 2009 | 1993 Toyota Paseo

1 Answer

Steering Wheel Control


I installed a body lift and now none of my steering wheel controls dont work any ideas

May 07, 2009 | 2005 Nissan Altima

1 Answer

Want to install a new stereo in my 2001 ford expedition


Single din is smaller, double din will fit better in your truck.. What radio are you looking for ?? Not to step on anyones toe's but I can help you out, I can prolly get you a better deal.. hit me up if you want.. keith@infernoaudio.com

Jan 27, 2009 | 2001 Ford Expedition

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...