Question about Dodge Cars & Trucks
If the heater core is getting hot (check hoses under the hood for being hot that go to the core) then you have a failed air temperature control door (referred to as a "blend door") issue, in most cases the door warps and this causes the little motor drive that operates the door to fail due to the stress of the warped door being difficult to move. To remove the these parts for service/replacement you must remove the dash assembly form the vehicle.
Posted on Dec 22, 2016
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
impeller is made of plastic on teh water pump and its slipping and spinning on the shaft renew before weather warms up as engine will overheat
Posted on Jan 01, 2009
SOURCE: Front Blower
ok, missed the part about the rear ac working, the part that causes this is called the air temperature control blend door actuator motor, it is an electric motor driven gear drive that moves the plastic door inside the air ducking to mix or shut off the hot or cold air from the ac evaporator core or the heater core, you will need to replace it.
Posted on Sep 03, 2009
Testimonial: "Great thanks that could be my problem. Is the motor by the inside coil"
That is usually the first symptom of low coolant. Not enough water in the system to circulate through the heater core. Has it been running hot?
Check the coolant level in the radiator
Posted on Sep 23, 2009
Tips for a great answer:
Feb 05, 2011 | 1998 Dodge Durango
Dec 16, 2010 | 2001 Dodge Durango
Aug 23, 2010 | 2001 Dodge Durango
Dec 15, 2009 | 1999 Dodge Durango
Sep 03, 2009 | 2002 Dodge Durango
May 10, 2009 | 2003 Dodge Durango
Feb 22, 2009 | 2001 Dodge Durango
18 people viewed this question
Usually answered in minutes!