Question about 1995 GMC Sierra

Open Question

How do you get flasher out the dash of a 1995 GMC Sierra

Posted by on

  • Joe Acosta Dec 23, 2016

    But is it bolted in or a clip?

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 50 Answers

SOURCE: gmc sierra turn flasher location

The flasher on this vehicle looks nothing like the flasher's of yesteryear. It will be located behind the drivers side knee bolster(under the steering wheel). It will be a small black box that is about 3 inches wide, 2 inches deep, and 1 inch thick. It may be somewhat difficult to locate because on some of the GM trucks they actually hide it behind the guage cluster bezel but to the left of the guages. Let me know if I can help you any further.

Posted on Aug 21, 2008

motor1258
  • 6674 Answers

SOURCE: 2003 GMC Sierra Pickup

You've checked all your signal bulbs are working? have you tried another signal relay?

Posted on Aug 23, 2008

  • 47 Answers

SOURCE: low oil when engine warms up gmc sierra 1995

30-40 psi of oil pressure is fine for many vehicles including your GMC. I am assuming that the truck has more than 100,000 miles on it and still has the original engine in it. By rule of thumb you only need 10 psi per 1000 rpms in a typical street driven engine to give adequate oil pressure to keep the bearings from oil starvation. The oil pressure is typically higher when initial start up occurs because it is more viscous due to the temperature of the oil as the engines oil warms up the visconsity thins out and the oil flows more smoothly. The drop in oil pressure is a normal occurance. Above 45 is more than required for a daily driven street engine. I believe that the specs on that engine only list 30- 45 psi.

Posted on Dec 07, 2008

  • 1244 Answers

SOURCE: Dash lights flicker in a 2000 GMC Sierra

yep bad ground in the dash

Posted on Jan 14, 2010

  • 1 Answer

SOURCE: 1995 gmc sierra 4x4 shifter wont go in 4 wheel drive.

my name is michael. You said it will go into 4 low but not into 4 hi. Have you lifted the truck to see if it is operational? Does your 4x4 light come on? Does it grind into either 4 hi or low? And one thing, has anyone ever taken the axle out on the right hand side? Please feel free to email me at MOFRACKY1@hotmail.com.

Posted on Jan 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is flasher loction on 1990 gmc serria and what does it look like


The flasher for the signals and the flasher for the hazards should be mounted on the left side of the dash slightly below the headlight switch. They will be most likely round and made of plastic or glass. Turn on the 4 way flashers and follow the noise. The signal flasher will be close to the 4 way flasher and look similar

Nov 21, 2015 | 1990 GMC Sierra

1 Answer

No dash light and no park light.


Why does my 1995 gmc Sierra have no Dash lights

www.cargurus.com > Questions > GMC > Sierra 1500
CarGurusMay 19, 2013 - Why does my 1995 gmc Sierra have no Dash lights - was blowing fues right away found out had a after market deck problem rewired it now ...

Sep 27, 2015 | 1996 GMC Sierra

1 Answer

How to find and install the turn signal flasher on 1995 GMC Sierra truck


Look in the owners manual for the flasher location. Once you see its specifications, etc. you should be able to locate it. Should be up under dash on driver's side if I remember right.

Sep 15, 2014 | Cars & Trucks

1 Answer

Cant find 4 way hazard module 94 seirra


To find the FLASHER on 1994 GMC Truck C1500 1/2ton Sub 2WD 5.7L TBI 8cyl. the Flasher is located: Front seating area, driver side, under dash, driver side of steering column, mounted in relay bracket

Application: Hazard flasher


Turn SIgnal flasher is one independent unit.


Hope helps-

Sep 16, 2010 | 1994 GMC Sierra

1 Answer

My transmission felt like it was slipping, then my truck, a 1995 GMC Sierra C1500,lost all power and dies, would not restart, all dash lights came on and sounded like flashers were on also with the key OUT...


if there is any corrosion between your battery cables and terminals you need to clean them real well i have a 1995 chevrolet silverado and i just delt with a similar starting problem there should be 2 cables attached to the positive (+) side pull the 2 cables apart and clean in between them real well the next cheapest thing woul be the starter the ignition switch is exspensive

Jun 29, 2010 | 1995 GMC Sierra C1500

2 Answers

Where is the location of the turn signal flasher?


I have a 94 Sonoma and to locate the turn signal flasher, inside, under dash, on left side is a plastic sound protector, mine had 3 screws holding it up, drop this down and straight in you will see a 1" round thing - this is the flasher.

Jan 08, 2010 | 1995 GMC Sonoma

3 Answers

Where is the turn signal flasher on a 95 gmc 1500 pick up


There are 2 Flasher Relays. One for the turn signals and one for the hazard lights. Both flasher relays are located on the driver's side, under the dash, mounted in the fuse panel. Make sure you replace the correct one.

Nov 18, 2009 | 1995 GMC Sierra

1 Answer

Cant find my turn signal flasher on my 1995 gmc sierra


ITS GONNA BE A SMALL SLIVER OR CHROME LOOKING CANNISTER. IT MIGHT BE NEXT TO THE FUSE BLOCK OR UNDER THE DASH CLOSE TO THE STEERING WHEEL. GOOD LUCK!

Jun 10, 2009 | 1995 GMC Sierra

3 Answers

Gmc sierra turn flasher location


The flasher on this vehicle looks nothing like the flasher's of yesteryear. It will be located behind the drivers side knee bolster(under the steering wheel). It will be a small black box that is about 3 inches wide, 2 inches deep, and 1 inch thick. It may be somewhat difficult to locate because on some of the GM trucks they actually hide it behind the guage cluster bezel but to the left of the guages. Let me know if I can help you any further.

Aug 21, 2008 | 2001 GMC Jimmy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...