Question about 1995 Ford Aerostar

1 Answer


Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 20 Answers

Under the hood very easy to clean

Posted on Jul 22, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is iat sensor located on 2006 tpyota tacoma 4,ol ?

Intake Air Temperature (IAT) sensor and Manifold Absolute Pressure (MAP) sensor are combined into a single assembly which is called Mass Air Flow (MAF) sensor. This MAF sensor is located on the air filter box near air filter hose, and is connected with a five wire connector. You cannot replace the IAT sensor alone. Instead a MAF sensor is replaced altogether.


Thank you for visiting Fixya.

Apr 14, 2015 | 2006 Toyota Tacoma

1 Answer

99 cherokee 4.ol stalls when coming to stop with ac on

but if you hold your foot on the throttle i t dont
that means the ISC idle speed controls are failing
or vacuum air leaks. (lean)
or too lean for any reasons.

there are 50 ways to get a stall
even the classic and simple do a tuneup.

Aug 31, 2014 | Jeep Cherokee Cars & Trucks

1 Answer

How to locate AC condenser bolts and brackets

A/C Compressor Mounting
1. Discharge the refrigerant. Refer to MTC-111, "HFC-134a (R-134a) Service Procedure" .
2. Remove the front right wheel and tire assembly. Refer to WT-6, "
Rotation" .
3. Remove the engine under cover and the splash shield using power tool.
4. Remove the engine air cleaner and air ducts. Refer to EM-14, "
Removal and Installation" .
5. Remove the drive belt. Refer to EM-12, "
Removal and Installation" .
6. Disconnect the compressor electrical connector.
7. Disconnect the high-pressure flexible hose and low-pressure flexible hose from the compressor.

Jun 13, 2014 | 2004 Nissan Titan

1 Answer

Where is the ac filter and how do i change it on my lincoln LS 2000 V8

The "AC Filter" refers to the Air Cleaner Filter. That is in the engine compartment in the air cleaner assembly. The cover is held on by a couple of clips. Undo the clips and remove the cover. Then you can remove the Air Filter and replace it with a fresh one. (Can be purchased at Walmart even.)

Jan 04, 2011 | 2000 Lincoln LS

1 Answer

When i turn on ac i get nothing but hot air in the front but the rear vents give out cold air

Hey! The ol' Exped. Ok these things have two ac systems. One for the rear and the front. You will need an ac preformance test ont eh front to be more diagnostic.

Sep 05, 2010 | 1999 Ford Expedition

1 Answer

Where can i locate the starter

Remove the air intake hose from the air cleaner assembly. Remove the clamp and then pull the hose straight off the assembly. Remove the wing nut securing the air cleaner by turning it counterclockwise by hand. Remove the air cleaner.

You will Locate the starter motor directly below the air cleaner assembly. Disconnect the wiring connection on the starter motor. The plug should pull straight out from the connection. Remove the nut securing the starter wire using 13-millimeter socket and ratchet and remove the wire.

Have a nice day

Aug 03, 2010 | 1994 Nissan Sentra 4-Door

1 Answer

Where is the low side ac port on a 1997 lumina 3.1 ????

You might have to remove the air cleaner to find it. It's on the left side of the engine compartment under the air cleaner assembly.

Jul 17, 2010 | 1997 Chevrolet Lumina

3 Answers

MAF sensor

HI, MAF is located right between the Intake duct assembly and the seal assembly. check the visual aid below to help with the location.


Jun 21, 2009 | 1995 Oldsmobile Cutlass Supreme

2 Answers

2003 hyundia accent 1.6

The MAF is mounted in the intake air hose of the air cleaner assembly.
The MAF is mounted in the intake air hose of the air cleaner assembly.
The MAF is mounted in the intake air hose of the air cleaner assembly. On some vehicles this sensor is combined wit the ATS sensor.
The MAF is mounted in the intake air hose of the air cleaner assembly.
This sensor is located in the air intake plenum assembly. It is combined with the IAT sensor.
The MAF is mounted in the intake air hose of the air cleaner assembly. On some vehicles it is combined with the IAT sensor.

Oct 08, 2008 | 2000 Hyundai Accent

Not finding what you are looking for?
1995 Ford Aerostar Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers


Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides