Question about Cars & Trucks

1 Answer

Hi l have an s type 2.4petrol when it starts in the morning. No probs go for about 3miles until the heat gauge gets to normal is has a slight misfire then ok

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 4,740 Answers

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Temperature gauge cold then back to normal


You have to make sure the thermostat is working properly and is the correct one. Idle the vehicle for about 20 minutes and then feel the upper radiator hose. It should be hot to the touch. Drive the vehicle and when the temp gauge falls to 'cold' stop and feel it again. If it is much cooler to the touch than before the thermostat is defective or wrong.

Mar 23, 2014 | 2000 Ford Ranger SuperCab

1 Answer

Temp gauge stays cold


If the thermostat is bad (i.e. stuck open at all times), this would allow coolant to circulate in the engine even when it is below the desired operating temperature. This leads to OVERcooling of the engine. You can either replace the thermostat as a first step or remove it and test it -- closed when cold, open when heated above 190-200F.

Jan 30, 2014 | Chevrolet Malibu Cars & Trucks

1 Answer

I recently changed the thermostat because it was overheating. It worked fine for a few weeks, now the temperature is fluctuating all over the place. What's strange is the engine will be hot and...


I'd start by checking the head gasket. Engine misfiring when first started in the morning or extra dirty coolant might be an indication too.

Jun 05, 2011 | 2005 Honda Civic

2 Answers

First thing in the (cold) mornings heater wont work. water gauge flux's up and down weird . then about 20 mins into driving its warms up


Your engine coolant is what your heater gets the heat from. You need to start your car and let it warm up for awhile before any heat will come. This is how most cars heaters work. Yours sounds like it is working fine; most cars take a little while to warm up.

Hope this helps!

Dec 07, 2009 | 1992 Toyota Paseo

1 Answer

Chevy S10 Stumbles really bad until temp gauge gets to 160 or more, error code said cylinder 3 misfire, Where do I start looking for solutions?


get u a heat gun and check ur temp on the exhaust manifold while truck is running bellow each plug the one misfiring will be considerably cooler then others,theres ur misfire

Oct 17, 2009 | 1991 Chevrolet S-10

3 Answers

AUDI A4.24 SLIGHT VEHICLE VIBRATION


If your engine is not misfiring but it vibrates too much while idling your motor mounts might be getting worn out. I had a Nissan with bad motor mounts. I was ok in park but when you put it in gear it vibrated a lot. It smoothed right out as soon as you started moving.

Jun 01, 2009 | 2000 Audi A4

2 Answers

Rough Idling, start-up early morning, until engine heats-up


HAVE THE COOLANT TEMP SENSOR CHECKED TO SEE IF IT IS FUNCTIONING PROPERLY.HOPE THIS HELPS. BEST OF LUCK. LET ME KNOW?

May 04, 2009 | 2001 Jaguar S-Type

1 Answer

Check gauges prob


Hello
Welcome to RY

Sounds like i would run a scan on the ecm
engine control Mogul
there could be a number of problems this scan will pin point it. most auto parts store can do this.
RD

Jan 11, 2009 | 1999 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...