Question about Nissan Altima

Open Question

Trying to locate transmission control module in 1994 Nissan Altima so I can reset it?

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: car won't start and i'm

there is a security switch around the brakes but at d side of d car (inside d car) you might need to reset it

Posted on Jan 08, 2009

  • 15 Answers

SOURCE: 1995 Nissan Altima Heater contorl valve location


Posted on Mar 02, 2009

  • 80417 Answers

SOURCE: Changing my 1994 nissan altima Transmission

yes it will bolt up.

Posted on Jul 23, 2010

Testimonial: "Great and quick response"

  • 5081 Answers

SOURCE: where is the transmission control module tcm

Underneath the center console, in between the two front seats..

Posted on Jul 30, 2010

  • 1 Answer

SOURCE: where is the transmission control module located i...

where is the transmition control module in galant 2000

Posted on Oct 29, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Trying to locate the electronic control module on 2002 nissan altima 2.5 liter

My info says behind right side instrument panel.
Sometimes you can look under hood, passenger side firewall, see a bunch of wires, usually that is it.

Apr 05, 2018 | Nissan Cars & Trucks

1 Answer

Transmission vacuum modulator valve 03 nissan altima where is it located

As far as I know, they stopped using vacuum modulators when they started using electronically controlled shift points. Transmissions with electronic controls don't need the modulators.

Feb 18, 2017 | 2003 Nissan Altima

1 Answer

When disconnecting transmission control module in 1994 Nissan Altima how long do I have to leave it unplugged to be reset and should I disconnect battery terminals before starting this process?

Just disconnecting the battery cables and touching the cable ends is all you need to do . And 10 min. is all the longer you need . How To Clear Your PCM Memory On Fords After Repairs This works for all vehicles with control modules .

Dec 22, 2016 | Nissan Altima Cars & Trucks

1 Answer

Where's the body control module located on a 2013 Nissan altima

Nelson, not positive but on a bit older models it was above drivers right knee under dash. You could call the Nissan service dept. which can verify.
Check the attached link,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

2013 Nissan altima body control module location Google Search

Apr 14, 2016 | Nissan Cars & Trucks

2 Answers

What is an ECM

emissions control module

Jun 17, 2012 | 1994 Nissan Altima

1 Answer

My 94 Nissan is stalling at Stops, & then take a while to start up again?

remove the ignition control module on top of mass air flow sensor,apply heat sink to transistor,and reinstall then change spark plugs, wires,distributor cap,and rotor,remove air intake,and clean out throttle body port with carbon cleaner,check ignition coil for lump(defective) and check pcv valve to see if it's stuck wich is located on a breather seperator on top of the idle air control valve......also,check 75 amp fusible link for battery under hood on drivers the same compartment,look for the 10 amp fuse to the alternator..........follow these instructions,and your car will run altima master 1993-1997 10 years owning a 1994 altima............been there done does not get any better than that trust money to spend should be about $120.00 dollars...........peace..........

May 24, 2012 | 1994 Nissan Altima

1 Answer

The RPM of 2007 Nissan Altima stays high when drive over 65 MPH.

It sounds like the trans is not reaching Overdrive final gear, this is controlled by the computer that shifts the transmission. What needs to be done now to see what is keeping it from shifting into OD is have the Transmission control module (TCM) scanned for fault codes by the dealer or a shop that has the correct electronic scanner for reading the TCM.

Feb 12, 2012 | 2007 Nissan Altima 3.5 Sedan

1 Answer

I have a nissan altima 3.5 V6 and I'm trying 2 locate the starter on the car

The starter is located on the transmission. It is near the fire wall mounted in the transmission. You will have to remove the air cleaner housing to get to it. It is held in with two bolts.

Dec 19, 2009 | 2005 Nissan Altima

1 Answer

Car won't start and i'm trying to locate the starter on a 1994 nissan altima

there is a security switch around the brakes but at d side of d car (inside d car) you might need to reset it

Jan 02, 2009 | 1996 Nissan Altima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

80407 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides