Question about Cars & Trucks

Open Question

How to reset TPMS on a 2015 Foton Finland. Have changed out the stock 17"wheels for 20" wheels and I need to run higher pressures.The one dealer in Tasmania not really helpful.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: resetting TPMS (Tire Pressure Monitoring System)

http://forum.chryslerminivan.net/printthread.php?t=113 visit yhis site it may help you

Posted on Oct 23, 2008

Ad
  • 3 Answers

SOURCE: 2003 Cadillac seville sts TPMS reset

From 2005 STS Owners manual:
Each TPM sensor has a unique identification code. Any
time you replace one or more of the TPM sensors,
the identification codes will need to be matched to the
new tire/wheel position. Each tire/wheel position is
matched, to a sensor, by increasing or decreasing the
tire’s air pressure. The sensors are matched, to the
tire/wheel positions, in the following order: left front (LF),
right front (RF), right rear (RR), and left rear (LR).
You will have one minute to match the first tire/wheel
position, and five minutes overall, to match all four
tire/wheel positions. If it takes longer than one minute,
to match the first tire and wheel, or more than five
minutes to match all four tire/wheel positions the
matching process stops and you will need to start over.
The TPM matching process is outlined below:
1. Set the parking brake.
2. Press the push-button ignition switch to OFF/ACC.
3. Using the Keyless Access transmitter, lock and
unlock the vehicle’s doors.
4. Press the lock and unlock buttons, at the same
time, on the Keyless Access transmitter. A single
horn chirp will sound, indicating that the TPM
system is ready, and the sensor matching process
can begin.
5. Start with the left (driver’s side) front tire.
6. Remove the valve cap from the valve stem.
Activate the TPM sensor by increasing or
decreasing the tire’s air pressure for five seconds,
or until a horn chirp sounds. The horn chirp,
which may take up to 30 seconds, confirms that the
sensor identification code has been matched to
this tire position. To decrease the tire’s air-pressure
use the pointy end of the valve cap, a pencil-style
air pressure gage or a key.
7. Proceed to the right (passenger’s side) front tire,
and repeat the procedure in Step 6.
8. Proceed to the right (passenger’s side) rear tire,
and repeat the procedure in Step 6.
9. Proceed to the left (driver’s side) rear tire, and
repeat the procedure in Step 6.
10. After hearing the confirming double horn chirp, for
the left rear tire, exit the matching process by
turning the ignition switch to OFF/ACC.
11. Set all four tires to the recommended air
pressure level as indicated on the tire and loading
information label.
12. Put the valve caps back on the valve stems.

Posted on Mar 06, 2009

  • 150 Answers

SOURCE: TPMS PROBLEMS ON 2009 JK AFTER SWITCHING TO 17" WHEELS

It won't hurt you vehicle at all to not have the sensors. You will not be able to make the TPMS light go off with no sensors.

Posted on Jul 01, 2009

outdoorsman5
  • 631 Answers

SOURCE: 2007 yukon tpms keeps blinking to check tire pressure

The TPMS is a pain in the you know what. Have you changed tire sizes? There could be a bad sensor and may need replaced. We continually get problems all the time with the TPMS. We have reset then they reset again.

Posted on Sep 11, 2009

jrock1094
  • 158 Answers

SOURCE: how to change the nissan sentra b13 stock wheels

you may be able to use a 17 in rim but will need a smaller tire(sidewall)
formula: 185/65/15(maybe stock size)-195/55/16-205/45/17
if your rim size goes up-the first number(circumfrence)goes up 10/second number(sidewall size)goes down 10
you may look at a 205(or 215)/35(or 40)/17
i had a 205/45/16 on my b13 and still had room
either that or you shve the fender wells to make room

Posted on Feb 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Reset tire pressure on 2005 Cadillac deville


If it is not in your owners manual

Then you will need a factory service manual
or go to a tire store to learn about the TPMS

Dec 05, 2014 | 2005 Cadillac Deville

1 Answer

Tire Pressure Warning is on and yet the tires are full of air


Hello,
Maybe we can help.

Set your tire pressure to the recommended factory air pressures. (to find this look at the placard that is located in your driver side door jam.) After setting all 4 tires to the correct pressure drive normally. If the TPMS (Tire Pressure Monitoring System) light doesn't turn off within 24 hours have the TPMS sensors checked at a local wheel and tire retailer or at the dealer. TPMS sensors have batteries in them that last an average of 5-7 years. If one of the batteries is dead it will trigger the system.

FYI, all of our stores can quickly troubleshoot your TPMS system and we stock most replacement TPMS sensors if you end up needing a new one. To find a local Discount Tire near you please visit www.discounttire.com/.

Nov 26, 2013 | 2008 Mercury Mariner

2 Answers

Tire pressure light does not go off. how do i reset? also on the hatchback lift the button doesn't work. i can remove the inside cover and manually open it by manually sliding the switch. how do i...


All you have to do to reset the TPMS light is make sure all your tires are set around 35-38 psi then drive it a a couple miles and the light will turn off. If it is blinking then you have a sensor issue and you will have to take it to the dealer. The tire pressure warning light is yellow not red."Your vehicle has also been equipped with a TPMS malfunction indicator to indicate when the system is not operating properly. The TPMS malfunction indicator is combined with the low tire pressure telltale. When the system detects a malfunction, the telltale will flash for approximately one minute and then remain continuously illuminated. This sequence will continue upon subsequent vehicle start-ups as long as the malfunction exists. When the malfunction indicator is illuminated, the system may not be able to detect or signal low tire pressure as intended. TPMS malfunctions may occur for a variety of reasons, including the installation of replacement or alternate tires or wheels on the vehicle that prevent the TPMS from functioning properly. Always check the TPMS malfunction telltale after replacing one or more tires or wheels on your vehicle to ensure that the replacement or alternate tires and wheels allow"

Jun 23, 2011 | 2007 Nissan Versa 1.8 Sl Hatchback

1 Answer

How do you clear "check


1. inflate your tires to the correct pressure (not just visually, but use a gauge)
2. your wheels have TPMS (tire pressure monitoring system) sensor attached to the rim on the filler stem, inside the tire. if that sensor has gone bad, your dash will register as having low tire pressure. replace that TPMS (little black box in the wheel. you have to remove the tire to get to it). If you have aftermarket wheels, you need to transfer the TPMS sensor from the stock wheel to the new wheel.

Mar 02, 2011 | 2002 Buick LeSabre

3 Answers

I HAVE A 2008 CHEVY COBALT, THE CHECK TIRE PRESSURE LIGHT IS STAYING ON. HOW DO I GET IT SHUT OFF?


All you should need to do is check and set all tire pressures and make sure to check the spare also, after all tires are set with air you then drive a few blocks and the light should reset if the light does not reset then you will need to find out which wheel has a bad air pressure sensor, this is done with a tool that is put on the valve stem or a scan tool to see which tire is showing the wrong pressure, hope this helps.

Oct 27, 2010 | 2008 Chevrolet Cobalt

1 Answer

I replaced my 08 accord wheels with an 09 accord wheels


thank your gorvernment. they required auto makers to implement some sort of tire pressure monitoring system in all vehicles. More than likely what needs to be done is a re-initialization of the sensors. it will most likely need to be performed by a dealer.

Jan 12, 2010 | 2008 Honda Accord

2 Answers

TPMS light will not go off. Tires were just


Check the owner's manual for directions on how to reset the TPMS. You may have to deflate to a certain pressure before filling to proper pressure. There may also be a tire learning mode tied into the odometer's trip meter button. Hope this helps.

Nov 11, 2009 | 2006 Honda Ridgeline

3 Answers

How do i reset my TPMS in my Kia Spectra?


after you fix the low pressure problem, it should reset itself.

Oct 07, 2009 | 2007 Kia Spectra LX Sedan

3 Answers

Where is the low tire reset button located on 2005 ford freestar?


It is on the same button as the Trip Odometer. Cycle through until you see Tire Reset and hold the button down.

Mar 28, 2009 | 2005 Ford Freestar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...