Question about Cars & Trucks

Open Question

Interruption in the car's dash at the beginning of the starting.

Some times when I start to move forward the car did not response delay to response then back to normal.

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 5 Answers

SOURCE: 1999 Pontiac Firebird 3800 V6 engine

replace fuel pump and fuel filter

Posted on Jun 07, 2009

  • 867 Answers


well, its not shifting into gear, mechanically or electronicaly, but by the blinking on your dashboard i would think your mechanic is right

Posted on Jul 17, 2009

  • 436 Answers

SOURCE: seat will not move forward or backward...

if motor seemed to slowly get worse over time then there is a great chance that the motor is gone. You will have to unplug the motor and test for power at the motors connector. if the power is good when switch is activated then the motor is dead, but if no power is found then you either have a bad switch or connector or a wiring harness problem. It will not be the fuses since the driver and passenger seats are the same. also one more thing to check is if your vehicle has memory seats then if no power is found at motor, this memory module mounted to seat could be the problem..

Posted on Aug 22, 2009

  • 3006 Answers

SOURCE: Car locking up and wont move back or forward while accelorating

Sorry but there's too much going on here for anything other than guesses, and at the irresponsibly selfish speed you drive at any faulty advice could well be fatal.

Something may have locked up in your transmission (or possibly braking system), and you've then used a bit of guesswork and uneducated brute force to overcome the problem for now. Without any further symptoms this has now become impossible to diagnose remotely and an accurate diagnosis requires a thorough examination of the vehicle anyway.

The question you now need to ask yourself is whether you're prepared to risk the fault occurring again at speed. If that's when it next happens then at best you'll do some very expensive damage but it's most likely to also cause a total loss of control with potential fatalities.

For the safety of any poor unfortunates who pull out in front of you in future and for yourself stop wasting time here and get the vehicle looked at by either Toyota or a 4x4 specialist garage.

I know this isn't the solution you were looking for and you may not like the way I've phrased it, but it is the only correct answer to your question.

Posted on Oct 07, 2009

  • 1 Answer

SOURCE: 2001 Volvo S60 2.4T starting problem

This car won't start unless the gear is in the P position. Some times the sensor that tells the computer that the gear is in the P position doesn't make a good contact and the car won't start. Move the gear backwards and forwards until it makes a good contact and the car will start again.

Posted on Dec 22, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Struggle to pick up speed, jerks and jumps

With the milage your vehicle has , I would assume the timing chain is stretched. To check timing chain, take off the distributor cap, turn engine by hand clockwise till the distributor rotor begins turning. When you stop turning it start to turn back the opposite direction while watching the rotor, there should be no delay between the time you start to turn engine,and the time the rotor begins to turn. If there is any delay, then the timing chain needs to be replaced.

Mar 17, 2014 | Chevrolet Astro Cars & Trucks

2 Answers

Starting issue on hyundai verna

replace the battery new battery whit out carer you burn out on less time keep the post tide and clean and aboid drain all the power or juice of the battery to many times.that kill the battery.

Sep 11, 2012 | Hyundai Veracruz Cars & Trucks

1 Answer

I have a 92 lesaber and it wil not start . Replaced stearing coluom;starter ,alternater

When replacing the steering, I bet you interrupted the antitheft system. I'm sure when you turn the key forward you'll see a light on the dash that says SECURITY or ANTITHEFT. If you see this light, this link will show you how to get around it.

May 16, 2012 | 1992 Buick LeSabre

1 Answer

I have an 2000 audi a4 1.8 sometimes it wont start and even has shutdown while driving a few times. When I try to start the car and it doesn't start i notice an EPC light on dash. A friend told me it...

You need to scan the car. The fault light will be logging a fault and is the place to begin diagnosis.
The crankshaft position sensor can cause hot start issues when they start failing and is a good suggestion (and a relatively inexpensive part), but you should see what the computer thinks is wrong first and move forward from there

Oct 01, 2017 | 2000 Audi A4

1 Answer

Have to turn the ignition on and off several times to get the fuel pump working

Your Jeep ecu is in need of repair. Your jeep is having a common problem known as the "Delayed check engine light" starting problem. Next time you try starting the jeep and it the fuel pump won't prime, look at the dash.....the check engine light is not on and the fuel pump will not come on until the check engine light eventually come on, on the dash. Have it repaired and it will eliminate the delayed check engine light start problem.

Aug 15, 2011 | 1995 Jeep Grand Cherokee

1 Answer

Sunroof won't move back in response to the back button

faulty reverse switch or dirty running tracks

Mar 01, 2017 | 2005 Saturn VUE

1 Answer

2001 Volvo S60 2.4T starting problem

This car won't start unless the gear is in the P position. Some times the sensor that tells the computer that the gear is in the P position doesn't make a good contact and the car won't start. Move the gear backwards and forwards until it makes a good contact and the car will start again.

Aug 23, 2009 | 2001 Volvo S60

1 Answer

HVAC performs normally until the car begins to move forward

Not roadmaster but should be quite similar, if not same. (schematics) just in case this helps.

Feb 13, 2009 | 1993 Buick Roadmaster

1 Answer

1992 Volvo 240 nearly overall electrical failure


Dec 01, 2008 | 1991 Volvo 240

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

14512 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides