SOURCE: Jeep Commander Rear Brake Pad Installation
Per Chilton Auto repair manual:
Removal & Installation
To install:
WARNING
Support the brake caliper with mechanics wire. Do not let the caliper hang by the brake hose.
SOURCE: where is map sensor located on 1999 jeep grand
MAP is usually on the firewall...it's about 1/2" thick by about three inches long, has a vacuum hose and several wires plugged into it.
SOURCE: where is the map sensor located? 1994 jeep grand cherokee
Go half way between the air cleaner box and the "carburetor". Up the 4" black air pipe, a wire harness plug plugs into the MAP sensor there. Also called MAS air flow sensor.
SOURCE: ac/heater fan switch problem on a 2006 jeep commander
next to the fan motor there should be a connector that has three or four wires that attached to the blower resistor. it should have two screws holding it to heater case, just pull it out and replace.
Testimonial: "This info was very helpful but need a little more info of where the fan motor is located. I will post another question to find that info."
SOURCE: install a altenator for a 2006 jeep commander
I would rate this a 5 in difficulty. If you have a metric socket set, basic hand tools and a supertine belt tool it's fairly easy repair. You can rent a surpentine belt tool at Autozone.
Disconnect the battery
remove the cowling
remove the supertine belt from the altenator pully
disconnect the red wire on the back of the altenator
disconnect the harness plug from the altenator
remove the bolts holding the altenator to the mounting brackets.
Reverse the process with the new altenator and it it's done.
Make sure your battery is charged before you start the engine a low battery can cause damage to your new altenator.
406 views
Usually answered in minutes!
×