Question about Cars & Trucks

Open Question

At the end of a ride. rpms decreased then stalled. tried restarting, wouldnt restart. engine turns over and begins to run but with throttle use stalls

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 148 Answers

SOURCE: vehicle stalls with low rpms

egr valve

Posted on Jul 07, 2008

leetamara
  • 702 Answers

SOURCE: Stalls when engne warms up

Your ECT (Engine Coolant Temp) sensor is bad. What's happening is at cold start it richens up the fuel mixture and as it warms up the ECM thinks it's still cold and essentially the "choke" is still on. Also check your coolant level. If you don't have enough coolant in you engine/radiator, the ECT doesn't know what to do so it thinks it's cold.

Posted on Jul 13, 2008

  • 1 Answer

SOURCE: ROUGH RUNNING AND STALLING

Try changing your idle speed control motor

Posted on Jul 21, 2008

preciousluv
  • 3 Answers

SOURCE: 2000 Hyundai Accent will suddenly stall and wont restart

Have someone check the idle sensor. I had to have mine replaced along with another that I don't remember which one is was.

Posted on Jan 08, 2009

  • 4044 Answers

SOURCE: 2001 chevy s10 loses power, will not stall, restart runs better.

Sounds like your timing belt is stretched or stretching when it's under stress. Check your timing and start thinking about needing to get that or the Timing belt adjuster changed. Also run a bottle of injector cleaner through your system.

Posted on Jul 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I'd like to get step to step instructions on how to clean the throttle body in my 2010 Jeep Patriot


  1. Purchase "02 Sensor Safe" throttle body cleaner spray;
  2. Drive the vehicle a few miles, bringing it to full operating temperature, then park it in your driveway with the engine still running;
  3. Gain access to the throttle body, and hold your thumb on the butterfly linkage so that you can open the throttle butterfly when the engine begins to load;
  4. Begin by spraying throttle body cleaner spray on all linkages around the throttle body. If the engine begins to bog because it is aspirating throttle body cleaner, quickly open the throttle butterfly to keep the engine running.
  5. Once you have cleaned all around the throttle body, spray cleaner DIRECTLY INTO THE THROTTLE BODY, opening the throttle sufficiently to keep the engine running. It will run rough during this process but try not to let the engine stall.
  6. If the engine stalls, restart it, and continue cleaning the throttle throat until you see clean metal.
  7. Pour some fuel system cleaner into the gas tank and drive the car a little more before parking it. Try to find an excuse to accelerate hard, WIDE OPEN THROTTLE momentarily if safely possible (as when accelerating to merge into traffic on a highway).
  8. Drive back home.
  9. Done.

Jul 19, 2014 | Jeep Patriot Cars & Trucks

1 Answer

Bronco stalls in reverse


This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control. If the above cleaning doesn't cure your issues you need to have the computer controlled automatic idle speed control system diagnosed and repaired by a dealer or electronic engine control repair shop.

Nov 07, 2012 | Cars & Trucks

1 Answer

1989 chevy cavalier z24 strats but stalls rapidly


This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Jul 26, 2012 | Cars & Trucks

1 Answer

89 chevy celebrity stalls when turning


Do the following service it should help the stall out.

Engine stalling and rough run issue at low speeds

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Jul 17, 2012 | Cars & Trucks

2 Answers

Low idle stalls out


Here is the most common cause of surges and stalls at stops and low erratic idle speed and rough idle, it is the idle speed control air-bypass valve and throttle valve (IAC for short), they get full of gunk over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Mar 13, 2009 | 1989 Audi 200

1 Answer

93 s10 2.8 wants to stall out after restart


You probably have a clogged fuel filter. There should be an inline fuel filter between the gas tank and motor, replace that and your good to go. I have the same problem with my c10 pick up.

Dec 28, 2008 | 1985 Chevrolet Chevy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...