My odometer light is out ? do you know what number fuse to replace?

There is no fuse for just the odometer, has main fuses for the whole instrument cluster . Odometer not working? instrument cluster problem. Have it checked by a professional repair shop.

Odometers
Each instrument panel cluster (IPC) is equipped with a season odometer and 2 trip odometers. The IPC uses the odometer rolling count message from the powertrain control module (PCM). The rolling count value is determined by counting the speed pulses from the vehicle speed signal (VSS). The IPC uses the rolling count data from the PCM and a software program to determine vehicle mileage. The odometers can be displayed in miles or kilometers. The units displayed is switched between English and metric by pressing the menu button on the driver information center (DIC) until the units mode is displayed. Pressing the set/reset button will select between English or Metric. . When the set/reset button is pressed to show the odometer in metric, km and the number will be displayed. When the odometer is in English, MI and the number will be displayed.


Season Odometer
The season odometer displays the total accumulated miles or kilometers of the vehicle. This value is permanently stored in the IPC. If an odometer malfunction occurs or if the IPC must be replaced, an authorized Delco service center must be contacted to program proper vehicle specifics, including mileage, for the IPC. The season odometer is capable of displaying 999,999 kilometers or 999,999 miles depending on units selected. Leading zeros are not displayed. The display will not roll-over to 000,000 if the maximum displayed miles or kilometers are reached. If the display limit is exceeded, the maximum value (999,999) is displayed. If the mileage is above 621,503 miles and metric units are selected the odometer shall display 999,999 km.


Circuit/System Testing
Ignition OFF, raise the vehicles drive wheels.
Engine ON, transmission in drive, verify the scan tool Vehicle Speed Sensor parameter matches the speedometer display.
? If the Vehicle Speed Sensor parameter does not match the speedometer display, replace the IPC.
Verify that the odometer is operating properly.
? If the odometer is not operating properly, replace the IPC.

Hi, I will double check the connector in back of dash board to assure is properly inserted also perform visual inspection and connector, check fuse box 1st to see if is any fuse for odometer thats also could be you problem i will star with fuse box , i know some times it may required to installed or programmed with scanner tool in order to ecm to recognize it ,. I hope any of these tips helping you thanks have good day.

if its just the light not working means one of the light fuse to your odometer got burnt or died out or even just being loose however you will need to visit a garage to replace the IGN 0 fuse. if you want to do it yourself check on the fuses with label 15 but would advise you visit a garage lighting specialist.

Do you have a interior light dimmer/switch next to the head light switch? rotate it until interior light comes on,then back just enough to them off. Now turn on headlights; Can You see me now? Hope thats IT, Good Luck

my truck did that and it was a PEC fuse

You did not mention what type of car you are asking about. (This is really MUST KNOW information if you want help with your vehicle. However, your description seems to indicate that you are describing a digital odometer. If some of the segments in a digital odometer are not lighting, then the odometer (or instrument cluster) will have to be replaced to fix it.

Here is the owners manual ...
http://cdn.dealereprocess.com/cdn/servicemanuals/chevrolet/2006-equinox.pdf

On page 5-85 there is this diagram of the fuse box inside the cabin....IGN 1 is the instrument cluster fuse
The the odometer light was the ONLY one to go out ... odds are it is not the fuse .... but now you know how to check that fuse

Helpful?

Good luck on your troubleshooting

I have a 1994 chevy caprice classic LS. 4.3lLMy odometer meter works off and on...why does it do that? Sometimes I cans see how fast I'm going.. Other times the numberes don't light up. Same problem happen with my signal lights.. They both occur at the same time.. my signal light indicater and my MPH odometer.

Thanks Johnyboyy & Sam35edm! I checked my fuse (10amp) and it looked ok. I replaced it and the lights for the odometer and gear shift indicator both lighted up. I then inspected the old fuse and it looked a little tarnished on the contacts. I then cleaned the contacts on both sides of the original fuse with a razor blade to remove the tarnish. The light lit brighter than ever! Looks like the fuse wasn't making good contact in its socket because of the tarnish.

You will need to pull out the instrument cluster and replace the bad bulb.