Question about 2002 Lincoln Blackwood

1 Answer

Vehicle wont stay running

The truck was running great but needed an oil change. oil was changed and vehicle started a couple of minutes later the vehicle died. it was restarted but barely. i checked the oil and it is overfilled, oil up the the start of the twist on the dipstick. could this be the cause of the vehicle not running? and if so what kind of damage could this have caused.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 43 Answers

This could cause it to not want to start. Highly unlikely but there is always that chance, it causes a resistance at start up on the crankshaft and higher pressure under the rods. It most likely didn't do any damage, but it could cause a problem if you were driving and not just starting. I would just do another oil change and see what happens.

Posted on Jul 21, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ck engine light on again..


Have your dealer look up this service bulletin.
NUMBER: 18-037-11
GROUP: Vehicle Performance
DATE: August 02, 2011
It states your PCM needs reprogrammed with the error code you are receiving P06DE. Was a pretty common problem back then.

Mar 24, 2015 | 2011 Dodge Avenger Heat

1 Answer

Why does the Change Oil light stay on 15 seconds after starting car?


Try re-setting the oil change light and see if it quits. Should re-set itself. Not oil sending unit, that tells computer and light when there is a problem like no oil pressure.

Sep 02, 2014 | 2003 Chevrolet TrailBlazer

1 Answer

Wont stay running.


There is no thinking & throwing parts at any vehicle

The only fix is knowledge & the ability to do some testing

Lets go with a failed fuel pump & at least check pressure
at the motor on a gauge or see if that data is on a scan tool

Explain what test told you a cylinder wasn't firing !

Mar 04, 2014 | 1996 Buick Park Avenue

1 Answer

04 jaguar xj6 misses and no power after a couple miles


You are equipt with a ignition control module,located near the A/C pump when this fails the vehicle stays running and wont accelerate, but will stay at idle,

Mar 17, 2012 | 1994 Jaguar XJ6

2 Answers

Oil change light comes on when car first started. It goes out after vehicle running for a few minutes. Happens even immediately after oil change.


Keith, it might just need reset. You can go to Autozone and ask for a OBll test and they will check it for free.

Feb 28, 2011 | 2003 Chevrolet Impala

1 Answer

2004 Buick Rendezvous For a couple of weeks the


The oil system reminder needs to be reset so the computer knows you had the oil changed. The procedure is in the owners manual but can be tough to find so you might have to do a little searching for it. Many of the GM vehicles can be reset by turning the ignition key to "run" [but don't crank or start the engine] and then fully depressing and releasing the accellerator pedal smothly three times within 5 seconds. Turn the key off, wait about 10 seconds and restart the engine to see if the reset was successful. Check your manual first as not all GM's can be reset this way and yours may be different.

Jun 16, 2010 | 2004 Buick Rendezvous

1 Answer

Jeep starts but wont stay running. changed fuel filter O2 sensor and cleaned injectors. When running it runs great. after it warms up if you can get it to run that long it runs great.


Possible electrical problem. If the module in the distibutor gets hot it will shut the vehicle down, let it cool down for about 10 min. and it starts again ?

Feb 04, 2010 | 1996 Jeep Grand Cherokee

2 Answers

My dodge durango will not stay running


Will not idle unless gas is applied?
Will stay idle after a bit of running?

First i'd recomend starting off with a new battery if yours is older, durangos have a quirk with voltages and sometimes wont play with 12v.
Also the TPS could be an issue.

Dec 29, 2009 | 2000 Dodge Durango

1 Answer

Engine starts, but won't stay started unless I step on the gas.


It sounds like to me your mechanic recommened you change your timing belt and water pump due to a maintance issue. If vehicle still runs good with old timing belt new belt wont change running. Cold weather and low cranking amps (poor battery) will cause starting problems.

Dec 04, 2008 | 1996 Toyota RAV4

Not finding what you are looking for?
2002 Lincoln Blackwood Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

fordexpert

Level 3 Expert

5501 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...