Question about DAF Cars & Trucks

Open Question

My daf xf 95 5 gears speed is rejecting when i driving the truck whats the problem

Posted by on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 432 Answers

SOURCE: how much gear oil does the 5 speed manual hold in

Well for starters it is no longer gear oil.A 95 uses synthetic.I have a Getrag M5 95 C1500 5 speed and Think when fully drained it held about 2 1/2 quarts.I buy the trans fluid from GM dealer,not sure if Mobil 1 synthetic 80/90 would be the same.The fluid from the dealer is realy thin.Well hope this helps and good luck.

Posted on May 24, 2010

  • 1212 Answers

SOURCE: need a diagram for for heater fan in leyland daf 45 120

Blower motor resistor or heater fan resistor. It should be located in the plenum air flow to keep it relatively cool. Also check the wiring harness for any melted wires, or corroded connections on the resistor block. Any deformities in the plastic warrant replacement of that part of harness connector since I do not think your local vehicle inspection laws would allow it to be soldered to the harness.

Posted on Feb 13, 2012

  • 42190 Answers

SOURCE: DAF CF 85

check the wiring to the retarder and retarder controls ( accelerator sensor --brake sensor etc ) finally have the unit inspected by a service centre dealer.

Posted on Apr 12, 2014

Testimonial: "By chance do you , have you a wiring diagram , so I can trace the items back,"

  • 42190 Answers

SOURCE: xf 95 430 hose power truck. wont start until I use quickstart after it wont idle on its own it needs constsnt revs for the engine to run what can I do

using quick start on a diesel engine is a sure fire way of blowing it up
compression ignition engine with explosive mixture in the air when the piston is coming up on compression spontaneous detonates and can bend con rods , break crankshafts
there is a problem in the fuel pump governor of if electronic controlled, in the engine management system
the safest and quickest way to decide where the fault lies is from the fault codes so have you service center read the codes and go from there

Posted on Nov 27, 2015

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My daf xf 480 an error in speed engine, it maximum 2000 rpm, what i have to do?


take it to a DAF service center or have a technician come out to inspect the fault
with limited engine rpms it is possibly in limp mode where the ECM restricts the engine speed and vehicle speed because it has registered a fault that is detrimental to the engine or transmission
LImp mode is only available to allow the vehicle to get to a safe place to stop so that the codes can be read and repairs effected

Jul 03, 2016 | DAF Cars & Trucks

1 Answer

Xf 95 430 hose power truck. wont start until I use quickstart after it wont idle on its own it needs constsnt revs for the engine to run what can I do


using quick start on a diesel engine is a sure fire way of blowing it up
compression ignition engine with explosive mixture in the air when the piston is coming up on compression spontaneous detonates and can bend con rods , break crankshafts
there is a problem in the fuel pump governor of if electronic controlled, in the engine management system
the safest and quickest way to decide where the fault lies is from the fault codes so have you service center read the codes and go from there

Nov 26, 2015 | DAF Cars & Trucks

1 Answer

Why my daf xf 430 wont start without quickstart


Battery faulty or corded terminals , clean inner terminals with emery paper.

Nov 03, 2014 | Cars & Trucks

1 Answer

Daf truck not start but it make on,what is the problem?


If you turn the key, what happens? If you hear a clicking noise then it might be the starter other wise it the battery.

Oct 22, 2014 | Cars & Trucks

1 Answer

Daf truck problems


need more info bud

Jun 02, 2014 | DAF 44 Cars & Trucks

1 Answer

My 2009 XF Jaguar just popped up a gear box error and is stuck in Drive


Switch off engine and it will reset as mine has done. Also my XF, got stuck in park and would not move with engine on. Remembered what I did with my first car ( Austin seven ruby) and got out and rocked the car front and back and the control knob just popped up. Am in Spain with my XF so am still worried about the sticking of the control knob problem.Have to get home at end of the month to UK and will wait until my return before contacting the garage.annekenward@sky.com

Jan 11, 2011 | 2009 Jaguar XF

1 Answer

Jaguar XF Electrical Problems Doors will not


gas tank door will not openon 2009 xf

Feb 26, 2010 | 2009 Jaguar XF

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top DAF Experts

David Harrelson
David Harrelson

Level 3 Expert

5316 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Ralph Koozer

Level 2 Expert

166 Answers

Are you a DAF Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...