Question about Acura RSX

1 Answer

My 04 rsx base type wont change gears and the letter D is blinkng.but my car start right up miles are 117,000 can you help ?

My car was crashed from the front and ever since i repaired it. it started doing that. also i havent drove it in about a year

Posted by Anonymous on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 46 Answers

Ensure you have enough transmission fluid, let vehicle run to warm up oil, block wheel and put transmission in neutral and verify oil while engine running, adjust as needed, if that doesnt work, possible torque converter mal function or shift solenoid, also check engine goes with a scan to verify possible transmission codes

Posted on Feb 01, 2017

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: My audi80 cabriolet wont start.

Hi anilroop,
Your problem seems to be related to the power connections to the management computer system system..... Get yourself a multi meter and check the battery voltage first....have you replaced the battery?

Sometimes when a vehicle has stood for a long time, oxidization can build up between the battery towers and the terminals....this can cause intermittent faults, such as you're describing....but it's unlikely!....If you find that thats all ok, trace through the cables that connect to the computer....

......There will be an ignition connection....
......A battery connection, which should always have power, even with ignition off.....
.....There will be starter signal and ignition signal.....

.......Check the ground connections and then, and this is going to take time....trace through all the cables from each of the sensors and the controlled units....Make sure that the pump is getting power and that power is getting through to the ignition....

This is a very lengthy topic and I believe it may be a lot easier to do it in stages.....

This is the end of the first stage.....keep in touch and I'll give all the help that I can.....

Best regards Johngee10

Posted on Sep 22, 2008

  • 21 Answers

SOURCE: Car stuck in Park, wont switch gears

check to see if the brake lights come on it may be a problem with a brake switch under the dash not letting the shift lock release. there may be a seperate switch just for it so check and see it there is two switches touching the brake pedal lever if the brake lights come on.

Posted on Jun 09, 2009

  • 63 Answers

SOURCE: 2007 mercury milan V6 Car wont start. Jumped it

Remove the lugs at the battery. Clean the posts and the lugs - then reconnect. Your battery won't charge (and the jumpers won't work) largely because of a film on the + post and lug. If you live in a hot summer area, (Arizona) the problem is especially troublesome.

Posted on Jul 15, 2009

emissionwiz
  • 75822 Answers

SOURCE: 4.0L Northstar Engine Overheating

the useual problem with this engine is the head gasket leaking, that sounds like what is going on with your Northstar.

Posted on Aug 16, 2009

  • 509 Answers

SOURCE: changed fuel filter now car wont start

Just checking, but did you install it with the arrow pointing to the engine? Take it off and try blowing through it, if you can't then it's plugged up and you need to get another. If you can blow through it, then it's something else.

Posted on Jan 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wont shift gears


Dodge Neon Questions - 04 neon will not go into high gear ...

www.cargurus.com > Questions > Dodge > Neon

CarGurusNov 3, 2012 - 04 neon will not go into high gear - 04 neon won't go into high gear. changed transmission fluid. (it tried to change after fluid was changed) gas cap ... ... Car: 2003 Dodge Neon SXT, automatic transmission. As of today, I have ...

Dodge Neon Questions - 2005 Dodge neon does not shift ...

www.cargurus.com > Questions > Dodge > Neon

CarGurusApr 6, 2014 - Your cars computer gathers info on speed in order to shift gears properly.... then you won't have a speedo and the ECM will not tell the TCM to shift gears in the trans. .... Car: 2003 Dodge Neon SXT, automatic transmission.

Neon wont shift out of first gear auto. - DodgeTalk : Dodge Car ...

www.dodgetalk.com > ... > Dodge Neon - General Talk
Jul 30, 2011 - I have a 2003 dodge neon se and it will run and drive. The transmissonwill not shift out of first gear. Where do I start? Compare to Toyota Tundra. Get Tundra on ... 2000 Stratus won't shift out of First Gear
Mar 14, 2007
Not shifting out of Second Gear???
Jan 15, 2007
46RE wont shift out of first at full throttle.
Nov 17, 2006
Transmission wont shift
Nov 3, 2005
More results from www.dodgetalk.com

Jan 06, 2016 | 2003 Dodge Neon

1 Answer

2000 Toyota Celica GT with 117,000 miles making revving noise


IS THIS A MANUAL TRANSMISSION VEHICLE? IT SOUNDS LIKE A CLUTCH DISC IS WORN STARTING TO SLIP.

Jul 21, 2013 | 2000 Toyota Celica

1 Answer

My 2007 Town and Country touring 3.8L is making a noise and gets louder when put into gear at a idle but cannot hear while I'm driving just stopped and idling?


if the noise started after the belt replacement, check the belt tensioner. They are notorious for seizing at the pivot, especially after belt replacement. Hope this helps.

Oct 03, 2012 | 2007 Chrysler Town & Country LX New Cars

1 Answer

2004 acura rsx type s grinds shifting into 5th gear


Check the oil level in the transmission. More than likely you will need the 5th gear syncro and gear replaced at a minimum.

Oct 07, 2010 | 2004 Acura RSX

1 Answer

Low beam light bulb issue rsx type s acura 05-06


The three prong base is just the bulb holder.

Here is an excellent tutorial on how to change the build:
http://forums.clubrsx.com/showthread.php?t=303640&highlight=change+bulb

Jan 22, 2010 | 2005 Acura RSX

2 Answers

The 2006 acura rsx starts, but manual doesn't work


sounds like your clutch has gone out. the same thing happend to me. sorry to say but its not a cheap fix. first get it looked at to double check but im almost positive this is what has happened. this cost me around $1200. but my RSX is a Type-S and is more expensive. if you own the base model you are looking at around 750-1000

May 16, 2009 | 2003 Acura RSX

1 Answer

Not going into gear


may be an entire tranny fix but mine did the same thing and only needed a new clutch and fly wheel. cost me about 1200 for the type s and will be about 750-1000 for the base rsx.

Aug 03, 2008 | 2004 Acura RSX

Not finding what you are looking for?

Open Questions:

Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...