Question about Toyota Cars & Trucks

1 Answer

86 toyota 4x4 22r boggs on primary side secondary side does fine

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Toyota Master
  • 77,202 Answers

The carburetor may have dirt in the main jet, rebuild it.

Posted on Dec 20, 2016

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is primary/secondary ignition coil on 2007 toyota sienna van


What is the actual code ?
The primary circuit is what powers the coil and the secondary is what goes to the plugs.

Sep 05, 2014 | Cars & Trucks

1 Answer

Conventional power pack


A primary and secondary usually refers to a transformer. The primary side being the input side 110 AC Volt or 220 Volt AC side. Also called Source.
The Secondary being the "output to load" side 12 Volts "for example". And also called Tap (Secondary Tap)

The voltage is changed by conduction, magnetic flux, neither side touching one another. And the number of turns of wire, per side, determine the voltage. The voltage may either be a step-down or Step-up depending on its use.
An unconventional method is to have both the primary & secondary combined into a single tapped winding - which arrangement is called an autotransformer. The autotransformer does not provide isolation between primary and secondary circuits but its simplicity makes it economical and space-saving.
Imagine a single wire wrapped from the top to the bottom being the primary, and tapping in. in the middle and bottom for the secondary, so the output becomes 1/2. That would be a step-down transformer.

The actual measurement of a transformer is measured by its efficiency (Faraday Law) which is defined as a ratio of power. I hope that's sufficient, but if you want more I would buy for $2 bucks an Electricity Made Simple Book, because there are pages after pages to write about transformers, and to understand electricity in general it is helpful to understand the difference between alternating current and direct current and its magnetic field of induction and magnitude of emf.

May 10, 2014 | Cars & Trucks

1 Answer

Primary/secondary ignition coil failure


Cylinder 1 is the first one on the passenger side of the engine (nearest to the crank pulley,belts etc.) the next one over is #2 etc.

Jun 01, 2013 | 2009 Toyota Corolla

1 Answer

What is code po351 primary coil A /secondary b on a 08 avalon


Follow spark plugs wire,coils and module could be problem.

Feb 19, 2013 | 2008 Toyota Avalon

1 Answer

86 ford 460 cu. in. Ford w/ Holly four barrle carborator secondary


On most models, the secondary barrels would only work if the primary are in wide open position, and even then the range of opening is small.
The engine should run past 3000 RPM on just the front barrels, so you may have something else going on.

Aug 23, 2012 | Cars & Trucks

1 Answer

Acceleration is too slow from 0 to 25 mph


i would assume that your engine still runs on carburetor. have your primary jets(in the carb) replaced. normal carb primary/secondary jetting for 1.6cc engine is 105/135. primary jets basically is responsible to acceleration, secondary jets are for speeding.

Aug 06, 2011 | 1987 Toyota 4Runner

1 Answer

HOW I CAN KNOW WHICH PUMP GOES ON MY SATURN VUE PRIMARY OR SECONDARY IS 3.0 ENGINE


The primary fuel pump is located in the left side of the tank. If you fill the tank up and it still does not start then it is the primary tank. Problem is that now you will have to drop the tank with a full tank of gas. The primary pump is used to pump the fuel to the fuel rail, while the secondary pump is used to pump fuel from the right side of the tank to the left side. I usually replace both primary and secondary so I don't have to pull the tank again if the secondary is also bad.

Are you sure you have a fuel pump problem? What are your symptoms?

May 28, 2010 | 2002 Saturn VUE

2 Answers

There is no spark at the plug when pulled from the engine and engine is cranked.


If there is spark with a jumper battery connected, you need a new battery. If no spark with a jumper battery connected, you need a new ignition module.

Jul 18, 2009 | 1994 Toyota Paseo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8755 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...