Question about 2005 Kia Sedona
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Sounds like the dealer has more work to do on the EVAP System. Smoke test the system and check Tech Service Bulletins. You could go to a local garage,it would be cheaper.
Posted on Mar 11, 2010
what code are u getting have the vehicle scanned for the trouble code most auto stores offer this service for fee such as auto zone / advanced auto check ur local area the trouble code will gie u a start point towards fixing ur problem
Posted on Apr 14, 2010
The only thingI can say is that there is a problem that is affecting the entire bank on one side of the engine. This automatcally eliminates things like Mass Air Flow (MAF) sensor, Manifold Absolute Pressure (MAP) sensor, Throttle Position Sensor (TPS), Crankshaft Position Sensor (CKP) etc. because failure of these things will affect BOTH banks, not one.
I have seen things like a totally skewed upstream Oxygen sensor on one side cause misfire codes for all cylinders on one bank. It is pretty rare, but it CAN happen. This can usually be verified by graphing the O2 Sensor PIDs for both sensors and comparing the graphs.
If the scaner data should be showing SOMETHING that is not right on one side - i.e. fuel trims, injector pulse width, etc.
I would also be looking into the possibility of one of the cams on that side to be 1 tooth off of the correct timing. This can cause problems while the engine is running and will not necessarily show up on a cranking compression test. One way to verify this is to perform a RUNNING compression test. With a warmed-up engine, pull one spark plug out at a time and check the compression with the engine running. Do BOTH sides, so you can compare the readings. If the entire 1-3-5 bank is lower than the 2-4-6 bank, then valve timing is most likely the cause.
Posted on Oct 15, 2011
SOURCE: 2005 kia sedona ECU replacement
2005 kia sedona ecu is located on passenger floor under carpet. After you remove the carpet half way, there is a silver plate you have to remove with 10mm deep well socket. there are 4 connector plugs.
Posted on Sep 30, 2013
Tips for a great answer:
Sep 17, 2016 | 2005 Kia Sedona
Jan 05, 2016 | Kia Cars & Trucks
Aug 19, 2015 | 2005 Kia Sedona LX
Dec 03, 2014 | 2005 Kia Sedona LX
Feb 07, 2014 | 2005 Kia Sedona
Nov 30, 2013 | 2005 Kia Sedona
May 17, 2011 | 2005 Kia Sedona
Oct 27, 2010 | 2005 Kia Sedona
Mar 11, 2010 | 2005 Kia Sedona
Mar 17, 2009 | 2005 Kia Sedona
17 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: