Question about Cars & Trucks

Open Question

My car maruthi 5 speed not starting when i check no current in spark plug

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Ford bantam 2008 1600 Rocam,in the mornings it does not want to start,there is fuel and spark,if you push it it starts,and if started once it start all the time,what can be the problem?


Could be a low battery voltage causing the cranking speed to be low or a tired starter motor sucking up excessive current and leaving the ignition system too deprived to deliver a strong enough spark.

Certainly you should check the spark plugs and the spark power and quality, the battery voltage and perhaps service the starter motor if it is consuming too much current.

If these things make little or no difference it would then be wise to check the fuel pressure and injector spray patterns.
The positive crankcase ventilation system should be checked - if a valve is fitted that is defective the intake manifold vacuum can be affected at cranking speed.

Sometimes imperfect intake valve seats can affect starting. As combustion begins enough gas leaks past the valve seat to corrupt the next incoming charge, effectively weakening the mixture. Another possibility is the coolant or air temperature sensors.

Mar 10, 2017 | Ford Cars & Trucks

1 Answer

I have a 1999 mercury cougar v6 2.5l and says that #5 cylinder misfires. When you go above 30mph to highway speed it starts to buck and kick. Check engine light also flashes and then stays on completely....


Sounds like its the #5 cylinder injector. But if you have to change it you better change 1-5 also. Because it will happen to the rest of them.

Mar 04, 2015 | 1999 Mercury Cougar

1 Answer

Low Fuel Pressure


that whole post can be reduced to
my M13 suzuki engine misfires.,
but Id need to drive it to say so,..,
asking the blind why your car jerks,is near
impossible, ask the living, person in your service shop this and win.


this is usa forum, we are not INDIA
nor do we have "wiki"
:The Maruti Suzuki Swift was launched in India in May 2005 with a 1.3-litre petrol engine:"

Gross engine misfiring , petrol engines.

get a tuneup, spark, filters?
m13 engine needs good spark to burn all fuel.
try at least spark plugs, they do not last life of any engine.

btw,
misfire has over 50 causes
in a shop there are 1 to 10 tests
to discover true cause
they dont guess, they test.
or go broke (after doing a tuneup, gee)

Mar 17, 2017 | 2007 Suzuki Swift 1.3

1 Answer

I have a f250 supper duty ford that starts but will stop after it is running have put a new fuel pump and filter on and it does the same speed has nothing to dowith it .


An ignition coil that is completely dead will prevent the engine from starting or will stop the engine if the car is running at the time of failure. This is because no current will reach the spark plugs. An ignition coil that is failing will still provide current to the plugs, but it might not be enough for a full spark and the car will run sluggishly. If the current being provided by the coil isn't consistent, the car will run rough. good-day !



Dec 14, 2011 | Cars & Trucks

1 Answer

Hello, I am having Maruthi Omni LPG, for the past 3 months I am facing vehicle jerking problem due to misfire. I changed the Ignition coil ,but now also the problem arises


Th engine must be prroperly tuned for the LPG if this was fitted externally . If this was factory fitted please get a proper fuel setting done on the gas , check the spark plugs , the intensity , and also the timing.

May 12, 2011 | 1998 Suzuki Esteem

2 Answers

2002 ford escape 3.0L DTC P0305and P0306 what would you ck


P0305 - Cylinder 5 Misfire Detected
P0306 - Cylinder 6 Misfire Detected

When a misfire occurs, engine speed will fluctuate. If the engine speed fluctuates enough to cause the Crankshaft Position (CKP) sensor signal to vary, The Powertrain Control Module (PCM) or Electronic Control Module (ECM) can determine that a misfire is occurring.

When is the code detected?
- Engine Cylinder #5 and #6 is Misfiring.

Symptoms:
- Engine Light ON (or Service Engine Soon Warning Light)
- Lack/loss of power
- Hard start
- Engine hesitation

Possible Causes:
- Improper spark plug at cylinder #5 and #6
- Insufficient compression at cylinder #5 and #6
- Incorrect fuel pressure
- The injector circuit is open or shorted at cylinder #5 and #6
- Fuel injector #5 and #6 may be faulty
- Intake air leak at cyli

Possible Solution:
- Perform Injector Service
- Replaced Spark Plug #5 and #6
- Replaced Injector #5 and #6
- Replaced Ignition Coil #5 and #6

Hope helps.

Jan 02, 2011 | Ford Escape Cars & Trucks

1 Answer

I have a wv microbus 2.3i 1998,it just went of while i'm at a speed of 120km/h since than it doesn't want to start.the coil is get current its not sparking,what might be the...


Dear Sir,
As you said coil is getting currant but not sparking further to spark plug , then check few things.

1 Check the connector is proper fitted on ignition coil.

2. No lose connection with pin of connector or pin should not be lose.

3. All pins are clean of connector and no rust is there.

4. Check High Tension cable (cablle black couler which run from ignition coil to spark plug) if found ok then try with new cable if it wont start.

5. It is problem with ignition coil replace it problem will solve.

Problem can solve at any step from 1 to 5 i did arrange all steps by easy to check and less expanses, final step will more expansive than earlier step.if any issue let me know. thanks

Yogesh

Nov 16, 2010 | 2005 Volkswagen Microbus

2 Answers

95 jeep grand charokee laredo hard to start,


Check your spark plug, wires, distributor cap and finger. If you spark plugs older than 15000ml, replace them. To check your spark plug wires, use a tester (U can buy at any auto store) you hold direct on the wire and a small sparkling will show you if the wire works or not. You can check the wires also with this: use a single spark plug (don't remove one out your engine!), remove the wire from first SP, connect it with the single SP, hold it to ground, let someone start your engine...you need to see regular sparks.. do this step by step with all 6 wires. If all wires are fine, check the SP's, If you miss on one wire, replace the wire, if you miss on more than one, chekc the distributor cap and finger. If this items are older than 20000ml or 5 years, replace them.

Oct 27, 2009 | 1995 Jeep Grand Cherokee

2 Answers

Wont start


Either your belt broke to your alternator, or your alternator went out.

Mar 21, 2009 | 1993 Mazda MX-3

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...