Question about 1998 Chevrolet Malibu

3 Answers

Front wheel drive shaft is not all the way in from passenger side

Because transmission fluid was leaking from there and I took it to be repaired at an auto shop and he replaced the seal on the drive shaft but for some reason drive shaft didnt go all the way in and he said its fine but I dont think so.

Posted by on

  • Anonymous Mar 23, 2014

    transmission seal that leads to the drive shaft

×

Ad

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 186 Answers

It's not fine if that is truelly the case, However some after mrket seal do not look the same as factory seal. If the axe i not in all the way you may hear a chatteringon corners or have alarger leak.

Posted on Jul 21, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 65 Answers

Well its possible but that appens only if he didnt replace with a original part !! hard to say without seeing-it!
original part got to fit perfectlly in place

Posted on Jul 21, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 199 Answers

Take it back and have them put it all the way in. you should not be leaking fluid from there.

Posted on Jul 21, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Leaking transmission fluid on passenger side


damaged drive shaft seal in the transmission

Sep 10, 2017 | Cadillac Cars & Trucks

1 Answer

Fluid looks like transmission fluid leaking from front passenger side in front of the tire


Check your brake lines sounds like a brake issue is it a 4x4 check your axle seals also.

Feb 15, 2013 | 2004 Dodge Durango

1 Answer

I NEED THE STEPS OF TAKING OUT A TRANSMISSION OUT OF MY 1994 HONDA ACCORD


  1. Remove the hub cap and bolt the wheel back in.
  2. Punch out the spindle nut lock and loosen the spindle nut.
  3. Raise and support the vehicle and block the rear tires.
  4. Remove the wheel.
  5. Drain the transmission.
  6. Remove the all the damper fork nuts and all the brake hose nuts on the damper fork and on the shock absorber.
  7. Remove the damper fork.
  8. Remove the driver side and passenger side front suspension flange nut inside the engine bay and slide the upper arm out
  9. Turn the steering wheel all the way to the passenger side and remove the passenger drive shaft spline from the hub.
  10. Separate the inner driveshaft from the transmission with a large screw driver (or crow bar).
  11. Remove the passenger side drive shaft. Do not pull.
  12. Remove the front radius rod.

Under the car.

  1. Remove the center beam.
  2. Remove the torque converter cover, the control cable holder and remove shift control cable.
  3. Remove the drive plate bolts and four transmission housing bolts.

Inside the engine bay.

  1. Place a transmission jack or several small jacks under the transmission.
  2. Disconnect all the electrical connectors.
  3. Remove the speed sensor gear shaft but leave the hoses on.
  4. Remove the distributor and mark the distributor shaft with a razor or a diamond etcher, usually on the head side or both.
  5. Remove the throttle control lever cable.
  6. Remove the transmission cooler hoses mounting bolts and their 4 washers.
  7. Remove the starter.
  8. Remove the all the transmission housing bolts.
  9. If the transmission won't come out remove a horizontal side engine mounting bolt and raise oil pan (with a wooden block between the oil pan and jack) until the transmission clears.
  10. Lower the transmission into the transmission jack.
  11. With the driver side front suspension flange out of the way, turn the steering towards the right then remove the driver side inner drive shaft with a large flathead screw driver.
  12. Lower the low profile transmission jack and slide the transmission and the jack from under the car. Don't loose the two dowel pins.
  13. Block all transmission fluid ports from leakage and dust and dirt.
  14. If repairs are being done repair the transmission in a dust, sand free environment.

Jul 30, 2011 | Honda Accord Cars & Trucks

1 Answer

How can you plug the rear driveline on 1991 blazer so that i can drive it in front wheel drie only


You could remove the rear drive shaft but transmission fluid would leak out if you started to drive it on the road you could do this for a test olny . And would not recomend driveing the vehicle off the front wheels olny they are not designed to run on dry pavement the front carrier wouldn't last vary long if you could stop the oil from leaking out of the back of the transmission with out the drive shaft What you need to do is pick up a rear carrier from a junk yard and fix the rear wheels Good luck with it

Apr 01, 2011 | 1991 Chevrolet S-10 Blazer

1 Answer

Where do I put the transmission fluid? The car does not accelerate at all when pressing on the gas pedal. Help, please!


Hello: If this is a rear wheel drive, you will find a dip stick under the hood towards the passenger side rear of the engine compartment remove the dip stick (should have a red handle) with a proper size funnel add transmission fluid through the tube for the dipstick. If it is a front wheel drive the procedure is the same except on the front wheel drive the dipstick is on the driver side toward the rear of the engine compartment. Check the fluid with the engine running. Do not overfill. Does the engine speed up when you press the accelerator? If so if the car moves after you put fluid in the transmission the you need to find out where the leak is and repair it. Use dextron3 transmission fluid

Nov 16, 2010 | 1989 Cadillac Brougham

1 Answer

2004 Dodge Neon SXT Red Fluid near Front-Passenger side Tire


SOUND LIKE YOU DAMAGE PUNCTURE TRANSMISSION OIL COOLER LINES LEAKING RED FLUID IS TRANSMISSION FLUID.

Jul 22, 2010 | 2004 Dodge Neon

1 Answer

Leaking fluid from rear end


hello, fluid leaking out of rear end is probably the pinion shaft seal, its were the drive shaft hooks to the rearend, you have to drop drive shaft, take yoke off rearend, or if it is,more further towards the back,were wheels are, then you need axle shaft seal, you have one on both sides on the rearend, behind the drums, where the back brakes are, also look and see if its coming from back of transmission, where drive shaft goes into the transmission, see if you can tell what color fluid is, if its red, its probably rear transmission seal, where drive shaft goes into the transmission.

Apr 08, 2010 | 2003 Kia Sedona

2 Answers

Brownish fluid leaking from the small mannifold on the passenger side of the car in front of the radiator...is this transmission fluid?


Good chance it's the transmission fluid. The passenger side of the radiator is the transmission cooler side and the coolant is leaking from the transmission lines. There should be two lines, one on top which is the inlet and the bottom one which is the return line. Check to make sure there is no corrosion along the lines or that the line has not come loose at the radiator. Locate the leak and repair or replace the lines. Good luck and take care not to run low on transmission fluid, low fluid in the system will cause the transmission to burn out.

Oct 28, 2009 | 2004 Ford Expedition

1 Answer

Replaced motor,car run fine.Lost transmission fluid replaced it with to much fluid.Took it for a drive woked fine & shifed as it should,stoped at a stop sign went to pull away and had no gears.There...


Sometimes the axel shaft backs out of the transmission on front wheel drives when not seated correctly. This usually occures in new transmission or engine swaps. I would take a look at the driver side shaft for fluid residue and shaft placement.

Oct 24, 2009 | Toyota Camry Cars & Trucks

1 Answer

2000 DODGE CARAVAN TRANSMISSION LEAK


A good mechanic should replace the seal with in 2-3 hours, mainly tearing apart your drive wheel on that side along with the drive shaft. This is a good time to replace the drive shaft if any of your CV joints are leaking.
Good Luck!! PHX

Oct 30, 2008 | 2000 Dodge Caravan

Not finding what you are looking for?
1998 Chevrolet Malibu Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...