Question about Cars & Trucks

2 Answers

2009 stabilitytrack comes on for a couple days unplugged abs and parking assist for a day or so plugged back in and drove for 1 1/2 hours will this reset any thing or not

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 14,585 Answers

No it won't. Newer vehicles will shut down ABS and/or stabilitrack for steering, engine, and transmission problems also. Best to have codes read. Or diagnostics done.

Posted on Dec 20, 2016

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 40,738 Answers

Run the fault codes to see if there is a sensor problem.
resetting without finding a problem really fixes nothing

Posted on Dec 20, 2016

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rear back wheel brakes locking


Try taking the caliper off of the bracket and cleaning all of the moving surfaces, and then relubricating them with disk brake caliper grease. normal grease will wash off. if that is of no help, replace the caliper.

Nov 01, 2013 | Chevrolet Tahoe Cars & Trucks

1 Answer

Won t start


run the fault codes and look for faulty cam/ crank position sensor as this is indicated by the backfire/hard start and lower idle RPM. Check that battery terminals are clean and tight..

Sep 22, 2013 | Pontiac Montana Cars & Trucks

1 Answer

I'm having same problem on my 2000 model rodeo 4wd 3.2L V6. Other day check engine light came on. I checked engine bay nothing abnormal, or power loss. Next day light was gone. 2 days later drivin


Where I live there is a Schuck's auto parts...and they have a hand held diagnostic tester that plugs right in to your harness. This will tell you whats is wrong.It only takes about 2 min and they don't charge you.On my car it was the mass air flow censor.If you can't find a Auto parts store that does this...take it to a shop soon. Good Luck

Mar 27, 2013 | 2000 Isuzu Rodeo

1 Answer

98 Ford F150 w/4.6l Wont start. Hear fuel pump click. Have pressure on fuel rail. Pulled #1 plug from head and plugged back into wire. Grounded plug and cranked. No spark. Changed wires 4 and 7 four days...


have diagnostic codes checked to see if you have a cam or crank sensor fault. make sure fuel pressure is at the required pressure, just testing to see if you have fuel at the valve is not enough. replace all spark plug wires. if you replaced two then all are just as old and even when they "look good" does not qualify as "they are good". Replace coil pack. start up drive away happy

Sep 05, 2011 | 1998 Ford F150 Regular Cab

1 Answer

The 12 volt battery(LUCAS 065/3) on my FORD FIESTA 1100cc is 4 years old, in that time i have only driven 1,600 miles as my journeys are usually very local. I make sure i use the car twice a week to keep...


Running so few miles has accelerated the aging of the battery - the battery never had a chance to fully recharge in such small trips -  so now you have to replace it a year sooner than usual.
Just replace it.

Aug 28, 2010 | Ford Escort Cars & Trucks

1 Answer

Check Coolant Light Came on.


i would first make sure the coolant is somewhat filled and boroow/lend a coolant pressure tester and hopefully a leak will show up externally...if coolant is going missing under coolant test i would strat to suspect a posssible headgasket failure....or water pump plugged rad, plugged heater core....you must investigate it thoroughly!!

Oct 09, 2009 | 1997 Cadillac Seville

1 Answer

Bmw 325i 2003 stall


Sounds like you have a small bit of dirt or grit in the fuel system when accelerating it is drawn with enough force to cut off the fuel supply then is released when engine at Idle.
1 run liquid fuel line/injector cleaner in 1 tank
2 check fuel lines for debris
3 change fuel filters
4 have fuel tank flushed
here is trouble shooting order less expense to greater.

Aug 19, 2009 | 1996 BMW 318

2 Answers

Holden Rodeo 2001, check engine light keeps coming on!?


I'm having same problem on my 2000 model rodeo 4wd 3.2L V6. Other day check engine light came on. I checked engine bay nothing abnormal, or power loss. Next day light was gone. 2 days later driving, a sudden loss of power and light came up. After idling for a couple of minutes, drove off with light still on but all power back. 1 hour later of faultless driving loss of power for a minute or so. Engine temp normal. Had break for 1/2 hour and set off for last hour of journey without fault except check engine light still on. Following dayon startup light went out???
Seeking help from experts.

Feb 09, 2009 | 2000 Isuzu Rodeo

1 Answer

ABS light on (on dashboard)


If While Installing CV Joint you Failed to Disconnect Wheel Speed Sensor FOR ABS System, It is Possible The wire got stretched and broke off INSIDE Outer Wire Insulter. OR Just Totally UNKNOWINGLY Broke it or Disconnected it. OUTER CV Joint? Match up PERFECTLY? Sense Light came on After Repair to THAT Particular side Concentrate on INSPECTING That side, for A 2 Wire Wrapped as 1 May be a Plug Just inside the Engine Compartment, Coming FROM Wheel well with a 2nd Plug There 1st Plug Being AT The SAID Wheel Backing Plate. Upon Discovery of Problem Reset Light at A Service Center OR Just Disconnect NEGATIVE Battery Cable for 1 minute. Again no doubt that WhEEL's Part Of the ABS Circuitry was Disrupted
I'm in Great Hopes you Find this as Helpfull Information and it assists you in Correcting your Problem. Have a Great Day,
RejakWilson

Jan 15, 2009 | Hyundai Motor 2000 Tiburon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...