Question about 2001 Toyota Highlander

Open Question

2001 Toyota Highlander wipers turn on automatically

Turn on whenever not in any pattern

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1861 Answers

SOURCE: driver side wiper wont work

One side does not work? Can you move the arm with your hands? If so, look for a loose nut that holds the wiper arm on. Remove the plastic trim on the wiper arm base, and tighten the 12 millimeter bolt. Please advise if this helps.

Posted on Dec 22, 2008

Ad
  • 31 Answers

SOURCE: steering wheel squeels when I make turns mainly in cold weather

It is probably a power steering belt or the power steering pump. Check the pump fluid, if it's okay get someone else to sit in the car and turn the wheel while you look under the hood. Listen to locate the sound.

Posted on Apr 23, 2009

  • 1861 Answers

SOURCE: Heater/AC control no longer allows change in temperature

You have one of two possible problems.

1) The temperature shaft retention nut is loose behind the knob

2.) The wires to the potentiometer part of the temperature may be broken.

Either one is common to this vehicle. The replacement of the AC controller is about 900 dollars. If the wires are broken, they can easily be reattached to the circuit board via soldering. What you would have to do is remove the control box from the dash, and disassemble it. Once the unit is apart, there are 3 wires from the temp knob to the circuit board that need to be re-soldered. The unit CAN be repaired, as opposed to the expense of replacing it.

Posted on Apr 23, 2009

ourhowse
  • 2007 Answers

SOURCE: 2001 Toyota Highlander Windsheld wiper assebly problem

First check to see if the nut that holds your wiper to the shaft came loose. If it did, just tighten it. If it didn't , you'll have to look in through the access cover. Usually just a screen like cover at the bottom of your windshield. I'm not sure what the setup is on them, but most vehicles, this cover is just held on by screws. Remove your wiper/ wipers if necessary, remove the cover, and look inside. There should be a linkage bar that connects to your wiper motor. It may have come off, or be stripped. I'm sure you'll figure it out once you get that far. Good luck.

Posted on May 02, 2009

  • 318 Answers

SOURCE: oil burning in my 2001 toyota highlander 84000 miles. bad rings.

You need to talk to a dealer.

Posted on Oct 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Whenever the radio is on it has static noise in it


Did you connect the antennae properly and get a good contact? Also check the aerial connection on the back window.

May 26, 2016 | Toyota Cars & Trucks

1 Answer

After we flushed tranny and cleaned out gunk, it ran good for a few weeks. now it will run good for about ten minutes, then it will not pull in Drive. is there a solution better than a new tranny?


When you say flushed out the tranny, was this done by flowing fluid through or by removing the transmission pan and draining the oil. has the filter been changed? Is the transmission fluid up to the right level?

Aug 04, 2015 | 2001 Toyota Highlander

2 Answers

I AM EXPERIENCING PROBLEM WITH MY 2001 TOYOTA HIGHLANDER. WHENEVER I STEP ON THE AKCELRATOR IT PULSATES AND VIBRATES AT SPEED 70 KM


Firstly, make sure your tires are in good shape, no rounded edges or balding. Secondly, have your tires balanced and checked by a tire shop.
Len

Jun 08, 2014 | 2001 Toyota Highlander

1 Answer

How to remove windshield wiper arms on a 2008 toyota highlander


Front are standard clipon 26 inch and 20 inch. rear needs to be replaced by dealer.

May 20, 2010 | 2008 Toyota Highlander

1 Answer

2001 Toyota Highlander Windsheld wiper assebly problem


First check to see if the nut that holds your wiper to the shaft came loose. If it did, just tighten it. If it didn't , you'll have to look in through the access cover. Usually just a screen like cover at the bottom of your windshield. I'm not sure what the setup is on them, but most vehicles, this cover is just held on by screws. Remove your wiper/ wipers if necessary, remove the cover, and look inside. There should be a linkage bar that connects to your wiper motor. It may have come off, or be stripped. I'm sure you'll figure it out once you get that far. Good luck.

May 02, 2009 | 2001 Toyota Highlander

2 Answers

Driver side wiper wont work


One side does not work? Can you move the arm with your hands? If so, look for a loose nut that holds the wiper arm on. Remove the plastic trim on the wiper arm base, and tighten the 12 millimeter bolt. Please advise if this helps.

Dec 22, 2008 | 2003 Toyota Highlander

Not finding what you are looking for?
2001 Toyota Highlander Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...