Question about Hyundai Santa Fe

Open Question

I have a 2003 Hyundai santa fe AWD and the front wheels are spinning but the back wheels are locking not allowing the vehicle to move. is it the axles or the differential causing this to happen?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

MrScary66613
  • 1990 Answers

SOURCE: The rear hatch on my 2003 Hyundai Santa Fe won't stay up.

Yes. Your Local Auto Parts Store should Carry these as Direct Replacements. If Not, Sears Carries them.

Posted on Jan 23, 2009

  • 187 Answers

SOURCE: Rear differential / axle noise and vibration.

A drive shaft that has lost a balancing weight will vibrate between 40 and 50 mph. If not corrected this could damage the input shaft bearing and seal on the differential causing oil leakage. Differentials are fairly indestructible but if run without oil will fail.
As for the front end you should never run the 4wd on dry pavement. The front differential is a posi traction unit that will turn both wheels at the same rate unlike the rear diff that will allow the inner wheel to turn slower than the outer on turns.

Posted on May 08, 2009

  • 148 Answers

SOURCE: 2003 Hyundai Santa Fe ABS light is on along with TCS light

you may have damaged the ABS sensor or wire to the sensor up front check the wire that runs from the inner finder well and make sure it connected to the ABS sensor on the spindle

Posted on Jul 15, 2009

  • 87 Answers

SOURCE: 2002 hyundai santa fe front transmission leak

swap w/rear radiator rear doesn't require fluid.

Posted on Jul 28, 2009

  • 850 Answers

SOURCE: front pass side cv axle removal on 2003 hyundai santa fe

pull swiftly !!! on the axle hub
as its got a big circlip in there & that is why it feels STUCK!
Cheers Rob

Posted on Aug 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Why are my brakes locking up on a 2003 Hyundai Santa Fe after replacing the master cylinder and brake booster


If your 2003 Santa Fe includes a four wheel anti-lock brake system the brakes should never, ABSOLUTELY NEVER, lock up.

There is a recall on the 3.5 liter 4wd model concerning the ABS.
ID Number Search Results Recalls do not expire, so make sure yours is safe.

Beyond that, one would need more information to diagnose the failure.

  1. Always include the model details (engine, transmission, model designation [GL, GLS, Limited, etc] and drive sysem [fwd,rwd,awd,4wd]) to allow someone to better answer you question.
  2. Describe when the problem occurs. Does it always, sometimes, or intermittently occur?
  3. Is it reproducible? Does it happen only at a specific speed? (over 35, over 50, fast, slow, forward, reverse, turning right, turning left, while you're on the phone)

Jan 29, 2015 | 2003 Hyundai Santa Fe

1 Answer

I hear a popping noise near my passenger side front wheel whenever I step on the brake? It's a 2003 Hyundai Santa Fe. Does someone know what it could be?


I would suggest checking the Brake pads make sure they are not too worn, if the brakes are okay then I would check the wheel bearing and if it is a FWD or AWD check the axle shaft Boots and knuckels.

Sep 17, 2014 | Cars & Trucks

1 Answer

2005 Hyundai Santa Fe AWD clunking noise when starting out in drive . Vibrtaion felt in the break peddle.


Take the vehicle to a tire shop that does front end work and have them checked your CV joints on the front drive axles, one may be worn out.

Nov 07, 2012 | Hyundai Cars & Trucks

1 Answer

How to change tone ring 2005 santa fe awd


don't think you can buy the ring but if so tap it on with a brass drift after cleaning the rust from the housing might be cheaper to get a remain axle

Aug 27, 2012 | 2005 Hyundai Santa Fe

1 Answer

The Hyundai Santa Fe is 4X2 or 4X4????? Please.


Hello! the 2002 Santa Fe has optional All Wheel Drive (AWD)...Which is permanent (can not be turned off)...If the option is not on your vehicle then it is Front Wheel Drive (FWD) only...The VIN # will tell you if the option is on your vehicle...

Guru...Saailer

Feb 09, 2011 | 2002 Hyundai Santa Fe

1 Answer

Am getting a hyundai fault code of po501 from check engine light anylysis


Hi. P0501 means there is a problem with the Vehicle Speed Sensor. VSS is not sending data to the ECU. The ECM receives vehicle speed information from the right front wheel speed sensor, presuming your Santa Fe isn't equipped with ABS. Check the tone wheel on the axle and check the wiring going to the sensor, especially for being chewed by rodentia. These are far more common
problems than problems with the sensor itself.

All the best!

Nov 10, 2010 | 2004 Hyundai Santa Fe

2 Answers

Clunking noise in reverse stops motion. Have to use accelerator.


have ya,ll checked the rear differetial fluid level.if u have an need more help feel free to email me at bertman285@hotmail.com

Oct 14, 2009 | 2003 Hyundai Santa Fe

1 Answer

2003 Hyundai Santa Fe. Driving about 10 minutes-stop at redlight and all dashboard lights come on and brakes feel locked. Have to restart ignition and then it's fine. Happened about a month ago as well....


Wiring harness runs along the left side of this vehicle between the engine compartment & the instrument panel junction box (left side under dash). damage may have occurred to this harness and no one found/noticed it.

Oct 08, 2009 | 2003 Hyundai Santa Fe

2 Answers

2003 Hyundai Santa Fe ABS light is on along with TCS light


you may have damaged the ABS sensor or wire to the sensor up front check the wire that runs from the inner finder well and make sure it connected to the ABS sensor on the spindle

Jul 14, 2009 | 2003 Hyundai Santa Fe

1 Answer

Lower ball joints and leaking boots on my 2004 2.7 AWD santa fe hyundai how much work


Labor Skill
Level
Mfg.
Warranty
Standard Axle Shaft Replace Front Axle Intermediate Shaft B 0.9 1.3 Notes NOTE To R&R Inner Shaft Bearing and/or Dust Seal, Add B 0.1 0.1 Notes Axle Assembly One Side B 0.6 1.0 Notes NOTE To R&R Outer Joint and/or Boot, Add Each B 0.0 0.5 Notes To R&R Inner Joint and/or Boot, Add Each B 0.0 0.5 Notes To R&R Axle Shaft Seals, Add Each B 0.0 0.2 Notes Rear Axle One Side B 1.2 1.7 Notes NOTE To R&R Outer Joint and/or Boot, Add Each B 0.0 0.5 Notes To R&R Inner Joint and/or Boot, Add Each B 0.0 0.5 Notes

Apr 20, 2009 | 2004 Hyundai Santa Fe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...