Question about Cars & Trucks

1 Answer

2016 Heartland Wilderness 3175RE frozen up. suggestions on how to fix this? like to find a full diagram of the trailer pipe , water system. Thanks.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.


    An expert who has answered 20 questions.

  • Contributor
  • 20 Answers

Int ro batid dede

Posted on Dec 19, 2016


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 2015 2650 Heartland wilderness travel trailer.

new tank or remove the tank for a proper fix

Jul 30, 2017 | Cars & Trucks

1 Answer

Are there any owners manuals for a 1978 (14 foot) Wilderness trailers?

This site here, has basic rv info.
You could try to contact distributor for your rv, see if they can help with owners manual.
You can do a web search for your owners manual, see if anything comes up?

Mar 14, 2017 | Cars & Trucks

2 Answers

Utility trailer electric brake are not working when connected to my truck

the wires to the electric brakes at wheels , I had this problem on my travel trailer and it turned out due to corrosion at connectors at wheels the power wasn't getting to wheels one other thing to ck is trailer plug , it turns out not all mfg wire there plugs the same , try to obtain a diagram from mfg for both trailer and truck , compare them for any differences

Sep 29, 2016 | Cars & Trucks

1 Answer

Where are controls for draining holding tanks. Also where are gauges to see how full?

There are many campers and you gave so little information but I will try underneath where the 3 inch black pipe is it should have a cap take off the cap hook up a drain hose and put it in a sewer pipe right next to the drain are 2 handles a 2 inch foe gray water and 3 inch for black water pull on the handle it opens the drain tip dump the black first toilet the dump the gray to flush out the drain hose on the wall by the sink is a power panel it should say gray water fresh water and black water push the one you want to see the marks show how full hope this helps

Mar 15, 2016 | Cars & Trucks

1 Answer

Cold water pipe is frozen but hot water pipe is not frozen. do we unfreze cold water pipe?

I am assuming this is a house and not a car or truck.
You would need to apply heat SLOWLY to the frozen pipe at or before the freeze spot.

Jan 25, 2014 | Cars & Trucks

1 Answer

My pipes may be frozen; cabin in the mountaines use infrequently but temperature set on 60 degrees...only a little water tricked out of the faucets upon arrival...turned on heato 70 degrees; is it likely...

in the water in the pipes is frozen it will be frozen all the way back to the tank or your water supply
one way to prevent freezing is to insulate the pipes properly with a quality pipe insulation product

Jun 16, 2017 | Cars & Trucks

1 Answer

My water pump was frozen. so i replaced that and the thermostat. The cars stalls every few minutes, sounds like hard vacuum by the air filter, filter is also new, any suggestions?

iwas the air filter piping removed ?- loose piping or unplugged sensor in plastic pipe could cause problem - water pump is on other end of motor - was air bled from water system - bleed screw on thermostat housing

Sep 24, 2009 | 2001 Pontiac Bonneville

1 Answer

Factory 99 dodge trailer plug wiring

You'll need to disconnect the wires from either the truck connector or the trailer connector...
I highly suggest purchasing a voltage checker- it looks like a screwdriver with a pigtail of wire with an alligator clip on the end. The tip of the 'screwdriver' has a point for probing. The light in the probe will light up...makes it easy to trouble shoot without a helper behind the trailer.
Hook the aligator clip to a good positive grounding point on the bumper or frame(not painted).
then pin by pin on the truck connection, stick the probe on each terminal tab.. and write a simple diagram where you find brake, tail, backup, etc...
Then i'd suggest, taking the connector off of your trailer, exposing the wire ends.
Run again thru your diagram and turn on each light of the truck. As you do, touch the wires from the trailer to that specific terminal. (make sure your ground wire is attached on the trailer) you can mark each wire with a piece of tape and label it which is which.
then simply attach your trailer wires according to your diagram to the terminals in the connector... that should get you in business..
hope that makes sense...
That way if the factory wiring harness remains the same, you'll be able to use it with other trailers if the need arises..

May 28, 2009 | 1999 Dodge Ram

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

14398 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides