Question about 2009 Saturn VUE

Open Question

2009 saturn vue trunk release plate snapped off

The part that is on the back of the lift gate snapped off in my hand and is hanging on my just the wires. Can the clips be replaced or does the entire plate need replaced

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

SOURCE: spark plugs on 2002 Saturn vue

just completed a plug removal and install on my '02 awd v6. if you have the time and patience it's straight forward; common sense was most helpful. to gain access to the plugs, both fore and aft, you must remove, in short, everything near to, associated with, the air intake system. common tools plus a 1/4 socket, with 8 inch extension to hold a #10 star bit. these star bolts are under the rectangular plastic plate atop the intake. once you have those out, disconnect all the wiring, carefully. lift the intake out, look for plug covers, fore and aft, ignition assembly lays atop each row of three plugs. with the hands of a surgeon, remove the ignition assembly, and by golly ye shall see your reward. easy from then on.
replaced my plugs with the iridium 'honeys'; marked improvement in starting, acceleration, smoothnes, noise, and gas mileage to the value of + 3.0%. changed out the oil with mobile1 extended performance, changed transmission fluid. took a shower. time involved, 7.0 hrs. dealer be damned,,priceless!

Posted on Jun 28, 2008

Ad
  • 1 Answer

SOURCE: location of fuse for trunk release

look in the owner's manual - the fuses are by the drivers pedals in the console. there's a chart in the manual of which fuses operate what; then when you take the fuse panel cover off it shows which fuse is where.

Posted on May 02, 2009

WV6Z
  • 7 Answers

SOURCE: 2003 saturn ion-release does not work for trunk release

If only the trunk release is not working, did you check to see if the little lever arm switch on the trunk lid at the latch assembly is switched to enable the release? Mine came switched to the 'Off' position when I bought it and it took me a few days to figure that one out.

Posted on Jun 26, 2009

  • 13 Answers

SOURCE: replace headlight bulb 2005 Saturn Vue

This operation is well descibed in the user manual that comes with your car.

Posted on Feb 25, 2010

  • 1 Answer

SOURCE: My 2003 Saturn Ion remote trunk release won't

Check to make sure the button on the trunk latch is turned from manual unlock...they made that feature so only the key will work to open the trunk that way if someone breaks in the front of your car they can't hit the trunk release and get into the trunk...may be the same thing for your remote. Hope that helps.

Posted on Jun 20, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the fuel door release button on a 2009 Saturn Vue?


There is no fuel door release button in 2009 Saturn Vue. When the vehicle is locked the fuel door is also locked. You can only open the fuel door by pulling it from outside when the vehicle is unlocked.

Dec 29, 2017 | Saturn Cars & Trucks

1 Answer

My 2009 saturn vue won't start and key is stuck in ignition. I tried moving the steering wheel and checked the shifter but nothing.


Jump the battery. If it gets to low, the solenoid for the key won't work and release the key. Just a note. If it is that low replace the battery. Have it checked first, but most likely dead.

Jan 07, 2017 | 2009 Saturn VUE

1 Answer

How do I replace a burned out rear backup light


Open the liftgate. Remove the liftgate applique. Refer to Liftgate Applique Replacement in Body Rear End. Remove the back up lamp socket (1) from the liftgate applique by turning the socket (1) counterclockwise. Remove the back up lamp bulb from the socket.
Lift gate Applique Replacement
Remove the lift gate trim panel. Refer to Lift gate Trim Panel Replacement .
1
Lift gate Applique Nuts (Qty: 5)
Tip
Disconnect the electrical connector.
Tighten
10 N?·m (89 lb in)
2
Lift gate Applique

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

May 10, 2016 | 2004 Cadillac SRX

2 Answers

Where is the emergency trunk release on 2007 saturn aura


http://www.manualslib.com/manual/762902/Saturn-2009-Saturn-Aura.html?page=92

Remote Trunk Release The trunk can only be opened while the vehicle is in P (Park). To close the trunk use the pullstrap located on the trunk lid. 2-14 Press the button located on the driver's door near the map pocket to open the trunk

And the manual for the 2008 model

http://www.vadengmpp.com/owners-manual/saturn/2008-Saturn-Aura.pdf
http://www.vadengmpp.com/owners-manual/saturn/2008-Saturn-Aura.pdf

Mar 29, 2016 | Saturn Cars & Trucks

1 Answer

How to access rear wiper motor


Most panels are held in place with clips attached to the underside of the panel. There may be screws as well attached to any handles used to lower the gate. If all screws are removed, pull on panel and the clips will release

Dec 06, 2015 | 2005 Saturn VUE

1 Answer

Hydrolic lift for back gate on 2003 Saturn Vue


Saturn parts are hard to get if the vehicle is more than 10 years old.

Aug 29, 2014 | 2003 Saturn VUE

1 Answer

Looking for instructions on replacing the rear gate support struts on a 2008 Chevy Equinox


It is very simple. All you need to do the job is a small screwdriver or pick. Open the lift gate. (it may be helpful to get someone to help you hold it open while you are working.) Use the screwdriver or pick to lift the spring clip from the ball end of the lift strut and pull the lift strut off of the ball mount. Repeat this for the other end of the lift strut. The new struts should have new clips already in place. Simply push the ball ends of the new lift strut onto the ball mounts until they "click" into place.

Repeat the proceedure for the other lift strut if you are replacing both of them.

Sep 03, 2011 | Chevrolet Equinox Cars & Trucks

1 Answer

Lift gate wont unlatch on left side


Just repaired the same problem on 97 astro. Get in the back and look for the rear handle on the lift gate and remove it. Mine had two cover pieces over two 10mm bolts. Under the handle and handle plate you can access the push rod for the left side latch. Mine snapped back into place with the plastic holder still in place. You can also get a new plastic piece or wire to hold it into place. I think mine was shut to hard over just wiggled out over the years.

Jul 04, 2011 | 2002 Chevrolet Astro

1 Answer

How to replace gas lift for back gate


depends on what model you are asking about . some of the rear lifte gate struts are bolted on . just remove the bolts while supporting the real glass or lift gate .And some struts use a little push clip at each end of the strut . these you can use a pick or a small flat blade screw driver to pop out of place . the new struts should have them already installed on them . so they just snap back on . just remeber to support the gate while changing the struts

Mar 06, 2011 | GMC Envoy Cars & Trucks

Not finding what you are looking for?
2009 Saturn VUE Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...