Question about Cars & Trucks

Open Question

My decoder reboots every 30 minutes. Is there a self fix solution or must I take the decoder in to M C Agency for checking Stays in Simon's Town, W Cape if so where is the nearest M C Service branch?

Posted by on


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 6 Answers

SOURCE: postal code for Cape Town, South Africa Looks like there are several- based on suburb

Posted on Feb 28, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

The van is a automation and will not shift pass second gear.

A scanner will show you. Codes will tell you. Or pull them and test them with am Ohm meter. Could be the solenoid pack also. If you transmission leaks. When it gets to low, it will suck air. This will also cause your van to go into limp mode. Start the van and check transmission fluid first. Fill as necessary. Turn it off and disconnect the battery for 30 minutes. This will clear the computer. Drive it. If it stays out of limp mode. Fix the leaks and/or keep it filled. Those sensors run around $20 a piece. The solenoid pack can be around $200+ Don't buy a good used one.

Nov 22, 2015 | 1994 Chrysler Town & Country

1 Answer

After taking some fuses outon my daughters seat ibiza to check them because the window had stpped working because there is plooming labels to say which fuse is for what. I had to take out one at a ti

The problem is usually that the dash cluster itself is failing. You can try rebooting it... disconnect the car battery, leave it disconnected for 30 minutes, than reconnect. If that doesn't work, than you need to find a company that repairs that kind of thing.

Nov 30, 2014 | Seat Cars & Trucks

1 Answer

Engine light on 1988 dodge caravan

Take it to Autozone and let them check it to see what code shows up. They wont clear it for you, but you can do it your self by disconnecting the negitive battery cable and reconnect it after 30 minutes.

Mar 09, 2012 | 1988 Dodge Caravan

1 Answer

Air bag lite stays on. 2003 town car

Any MIL Lamp or Check Lamp,on any
vehicle made in the last 30 years is going
to stay on ,until you check for codes,diagnose
the system with the malfunction & repair it

Jun 27, 2011 | 2003 Lincoln Town Car

1 Answer

My 1998 Dodge Grand Caravan will crank perfectly and then immediately stall, it does this like 4 times then it will not even turn over at all. After it sits for a while (a day or so) you can go out and it...

Sounds like low voltage check voltage at the alternator with engine running it should be 13.5-14.6 if its anything less than 13 volts replace alternator.

May 09, 2011 | 1998 Dodge Caravan

2 Answers

Check engine light comes on. odb2 code P2096 What does it mean


Apr 24, 2010 | 2005 Chrysler Town & Country

1 Answer

1990 town car A/C

GET it regassed as your out of R12 or Freon Just go to the AirCon service centre and it 30 minutes it could be done

Sep 23, 2009 | 1990 Lincoln Town Car

1 Answer

2001 grand prix v6 check engine light stays on

Have you tried disconnecting the battery for at least 30 minutes? This is sometimes the case and the computer just needs to reboot. If that doesn't work, your o2 sensor has probably gone bad. Its not an expensive fix. Leaving the check engine light on puts the computer into a setting called "limp mode". Limp mode is a safety to prevent damage to your vehicle. In this case the computer thinks there is something wrong and by going into limp mode tends to give you less gas mileage and less power performance as well.

Mar 31, 2009 | 1997 GMC Jimmy

2 Answers

1999 chrysler town and country

Start with the simple fixes first; Try a new fuel filter. Then a new pcv valve. Both are very cheap & you can probably install them yourself.

Mar 31, 2009 | 1999 Chrysler Town & Country

1 Answer

Abs light stays on

No need to untill you fix it. Bad abs senser or sencers. And you need the decoding tool to reset.

Mar 08, 2009 | 2005 Chrysler Town & Country

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14398 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides