Question about Cars & Trucks

1 Answer

How do you reset timing belt warning light on 1992 Hi Ace diesel

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Look at the dashboard just below the reset km black (plastic ) button look closely at the lower centre part of the clear dashboard you should find a small rubber plug remove the plug and below the plug on the dash there is a small reset button you will need to push this reset button and the light will go out . You will need a piece of wire the size of about a coat hanger with a square end and a length of approximately 75mm after pressing reset you should feel - hear slight click after reset replace plug hope this helps you good luck Rob

Posted on Dec 19, 2016

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Reset timing belt warning light on 2004 diesel 3.0lt


dealer only software ,just remove the bulb

Nov 06, 2014 | Cars & Trucks

1 Answer

Yellow oil light with exclamation mark


time for a service. or oil to low. time to top up.

Apr 01, 2014 | 2007 Toyota Hi-Ace 220

1 Answer

HYUNDAI H100 2.6 DIESEL TIMING DIAGRAM


I have a Toyota Town Ace diesel van, the timing belt broke and I need step by step help how to install new timing belt - timing marks diagram.

Jun 24, 2012 | Cars & Trucks

1 Answer

Does the 1992 dodge dakota automatic trans have a fuse to overdrive button


The fuse number is

#16 - 5 Amp (Tan)

Gauges & Indicator Lights: Low Oil Light, Low Washer Light, Service Reminder Light, Transmission Oil Light, Brake Warning Light, Anti-Lock Brake Warning Light, Fuel Pacer Light, 4WD Indicator Light, Malfunction Indicator Light, Warning Buzzer, Overdrive Switch (1992-93); Transmission Oil Temperature Lamp, 4WD Lamp, Overdrive Module Seat Belt Warning Buzzer
(1994-95).

Jan 25, 2010 | 1992 Dodge Dakota

1 Answer

Toyota Town ace Diesel turbo pump continuously


is it the primming pump? if so replace it if its the the injection pump it may have to be removed and send to a service centre for repair. to save time and money you can look for a junk town ace with engine intact and take the pump from that once its ok

Sep 27, 2009 | 1992 Toyota Corolla

2 Answers

How do I reset the timing belt warning light in a 2004 toyota prado 120 diesel


how to reset timing belt warning light in a toyota hilux model LN 145

Aug 29, 2009 | 2004 Toyota Land Cruiser

1 Answer

T-BELT light always on in Toyota 1992 Surf diesel model


Timing Belt? It should be replaced at 60,000 miles.

Jun 21, 2009 | 1994 Toyota 4Runner

1 Answer

Don't know how to reset timing belt warning light after belt repl


You must remove the dash panel and you'll find a screw just behind the warning light. You have to swap the screw place...it's written at the back "timing belt reset".

Feb 08, 2009 | 1996 Toyota 4Runner

1 Answer

Toyota Land Cruiser check timimg Belt


Hi,

I am assuming that you have a series 80 diesel engine and that it has run for about 100,000 kms hence the warning light and the changing of the timing belt. Based on the instructions of its repair manual you need to "remove the grommet off from the speedometer and turn off the lamp by pushing the warning light reset switch, then replace the grommet." Alternately, you can try to reset the entire computer of the vehicle by removing the battery cables for a couple of minutes. Pls note that some car radios/head units would revert to security default (ask for a code) when power is completely removed.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Jun 24, 2008 | 1997 Toyota Land Cruiser

1 Answer

Mitsi 1992 diesel galant


belts are usually directional so try 2 put it on in the rite direction otherwise will just disintergrate. and never retighten a belt esepecially if its hot

May 19, 2008 | 1992 Mitsubishi Galant

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...