Question about 1991 Toyota Celica
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Make sure battery connectios are clean and tight. Positive battery wire goes to starter and negative battery wire goes to engine/body. Connections must be clean and tight. Car must be cold; have someone cranks while you listen where the clicking sound is coming from. You can put your hand on the stater solenoid(smaller part on top of starter) and feel the click. If it's there, the starter is acting up. Remove battery ground, put aside and start removing starter. Mark wires if you need to. Use proper jackstands if you must go underneath. I do believe you should be able to get at it from the top. Let me know.
Posted on Jun 14, 2009
SOURCE: 1991 Toyota Previa won't start
low voltage to starter. Check battery for proper charge (must be 12.5+ volts), clean and tighten battery terminals. If below 12.5 volts, charging or battery replacement is needed. Hopefully this helpd
Posted on Sep 03, 2009
SOURCE: 1992 Toyota Camry won't crank
Check the ground cable going from the battery to
alternator, then to chassis. Make sure there is no
rust at the chassis ground wire terminal, and that it
is very tight. The fusible link will be off the alternator
red power cable,usually, but not 100% on that car.
Posted on Mar 30, 2010
When the bushes in a starter get worn, it can cause the armature to rub on the magnetic poles (poleing) This can cause the starter turn slow or not at all
The sintered metal bushes are like bearings. Not to be confused with carbon brushes which are the electrical connectors.
When a starter clicks, it is the solenoid you can hear.supplying power through the brushes.
A starter that is poleing,often stops in a place where it isnt rubbing, and works fine the next start.
There can be other problems with a starter , perhaps one of the brushes is sticking, or the solenoid.
When it happens a tap with a hammer on the starter or solenoid, while a friend turns the key, is enough to get it working( this isnt a fix but might get you started in an emergency)
There is also the possibility of a loose or dirty cable connection, from when the new battery was installed
Posted on May 09, 2010
Tips for a great answer:
Mar 03, 2013 | 1991 Toyota Pickup
can be the issue with weak battery or faulty battery or if battery is ok,then
its faulty starter causing the issue.
start to end troubleshooting these problem i suggest you to click the link
below and follow its procedure:-----
What to Do When Car Turns Over But
Car starting issues?
Car Starting Problems
1991 Toyota Trecel: Engine Starts fine but dies when gets Warm?
1994 Toyota Pickup: Starts fine but dies in few seconds?
1999 Chrysler Cirrus: 8 IGN Fuel Starter Fuse Blows?
2001 Toyota Camry: No start After replacing Battery?
1989 Toyota Pickup Truck: Turns over but not start? http://whatisbyme.blogspot.in/2012/05/1989-toyota-pickup-truck-turns-over-but.html
Car dead and will not Start? http://whatisbyme.blogspot.in/2012/05/car-dead-and-will-not-start.html
1995 Lexus LS400: Running Hot?
2001 Toyota Prius will not start? http://whatisbyme.blogspot.in/2012/05/2001-toyota-prius-will-not-start.html
1996 Jeep Grand Cherokee: Engine will not start? http://repairhelpcenter.blogspot.in/2012/06/1996-jeep-grand-cherokee-engine-will.html ------------- Mitsubishi will not start
These will help.
Nov 26, 2012 | 2005 Subaru Forester
Oct 19, 2012 | 1989 Toyota Camry
Dec 21, 2011 | 1991 Chevrolet Camaro
Oct 21, 2011 | 1991 Toyota Pickup
Oct 13, 2009 | 1991 Toyota Pickup
Jun 13, 2009 | 1991 Toyota Camry
24 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: