Question about Nissan Cars & Trucks

Open Question

2000 nisan sterling will not turn

Car won't start and sterling will not turn and security light blicking

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

pal03246
  • 705 Answers

SOURCE: 1998 Nisan Maxima

Your issue may be the switch inside the drivers door handle, where the security switch is located. It's mounted to the back of the lock cylinder inside the door. It most likely fell off the lock and it is stuck in ARMED position, not allowing the car to start. Remove door panel and look at the lock on the back and check it. The alarm switch is a small white plastic piece right at the back of the lock and it has wires coming out of it. Check it and let me know what you have found.

Posted on Sep 30, 2008

  • 141 Answers

SOURCE: replaced multiswitch in 2000 chevy s10 blazer and now the car won

at the base of the steering column there a orange and white wires these two wires come from the ing switch, you will see the connector that they go to disconnect that take a ohm meter, take the leads one lead to one wire the other lead to the other there should be res, if there is not, try a different setting . take your ing key on the the key you will see a chip take two leads from your meter and either side of the chip place the leads you will see a res reading, you should see the same at the orange and white wires . if you do not replace the ing switch the switch will come with these wires. replacing the switch takes a couple specail tools good luck and let me know how it gose

Posted on Dec 22, 2008

  • 1 Answer

SOURCE: SL2 ? 2000 starting problem

I had the same problem at one time and what the problem was is a short or an exposed wire connected to the starter which causes the voltage to fluctuate which in turn activates a security feature that stops the flow of fuel to the injectors. The car actually senses the possibility of a spark which could possibly ignite the fuel and be a fire hazard. If you turn the ignition on and off repeatedly after a certain amount of time the car will start and run fine. It is a very intermittent problem.

Posted on Mar 13, 2009

  • 1 Answer

SOURCE: 1993 pontiac bonneville won't start when security light is on

had same problem new key stillsame. Eventualy traced to 1 broken wire in ignition cyliner Steering wheel has to come out. cylinder taken oot and resolder wire. Smart locksmith repaired under 2 hours.

Posted on Jan 05, 2010

redds55
  • 2620 Answers

SOURCE: car won't start, security light

The ignition switch and ignition lock cylinder need replaced

Posted on May 13, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I got a 2000 sterling fuel trk with no brake lights


Usually there is a switch that the brake pedal linkage activates the brake lights .

Feb 01, 2016 | Sterling Cars & Trucks

1 Answer

Won start


Well it could be several different things. The security system, the neutral safety switch, the starter, a bad connection, and so on.

May 28, 2013 | 2000 Lincoln LS

1 Answer

1991 Sterling 827 SL engine turns over, won't start, no spark. Any ideas?


Dear Sir:
1) You mus do ignition system to the specification manufacturer!
2) Recalibrate GAP Spark Plug for specification manufacturer.
3) See the diagrams attached, and proceed according with logic.
God bless you

5_25_2012_8_03_11_am.jpg5_25_2012_8_03_31_am.jpg5_25_2012_8_03_58_am.jpg5_25_2012_8_04_22_am.jpg5_25_2012_8_04_39_am.jpg

May 24, 2012 | 1989 Sterling 827

1 Answer

Anti theft light won't go out


There are 2 things to try:
1) Use your key to manually unlock the driver's side door - sometimes this alone is enough to reset your security system.
2) Put your key in the ignition and turn to ON position (do not try to start the car, just turn to ON)- after 30 seconds, attempt to start the car and see if the security light goes out.

Dec 08, 2011 | 2000 Mercury Sable

1 Answer

My 2000 corvette won't crank up---no lights will come on-----nothing works in dash, not even the radio


I would take the battery cables loose and actually verify battery is not leaking. If "security" is causing no start then you can tell by watching the security lamp on dash. It should be on solid when key is turned to run if it is part of your concern. also sounds like you could have a body control module problem it controls the interior lamps which may explain clicking you heard and also controls the security.

Keep us updated.

Oct 10, 2011 | 2000 Chevrolet Corvette

1 Answer

2000 Yukon XL wouldn't start. We replaced the battery and it still won't start. The lights come on but when you turn the key it does nothing. The security light flashes could this have something...


Those has every thing to do with it. You'll find the answer you need though this link. Comment back if you have questions http://vatspasslockpasskeysecurityhelp.yolasite.com/

Jul 25, 2011 | 2000 GMC Yukon Denali

1 Answer

When i turn the key the truck does not start i changed the cluch swich and still nothing


1. does the security light blick when key is put into ignition.
2. does it go off when you turn the truck over.
3. have you had an aftermarket alarm keyless entry or remote starter installed recently.

sounds to me like your truck is not reading your key.

Dec 13, 2010 | 1995 GMC Sonoma

1 Answer

SL2 ? 2000 starting problem


I had the same problem at one time and what the problem was is a short or an exposed wire connected to the starter which causes the voltage to fluctuate which in turn activates a security feature that stops the flow of fuel to the injectors. The car actually senses the possibility of a spark which could possibly ignite the fuel and be a fire hazard. If you turn the ignition on and off repeatedly after a certain amount of time the car will start and run fine. It is a very intermittent problem.

Jan 02, 2009 | 2000 Saturn SL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...