Question about Mazda MAZDA6

1 Answer

The heater runs hot in all positions even with ac on its.a 2007mazda6

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mazda Master
  • 1,335 Answers

Have you checked all your fuses ? Then you might want to verify that you don't have a leak of refrigerant from your vehicle A/C system.

Posted on Dec 18, 2016

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2010 jeep liberty heat not working. I have replaced the blend door actuator, coolant level is good, and hoses to and from heater core are hot when vehicle is running and try to run heat. When changing the...


Try disconnecting the hoses going to the heater core at the firewall, then use a garden hose to flush out the system. Do one side first, then the other..reconnect hoses when completed..

Jan 07, 2018 | Jeep Cars & Trucks

2 Answers

Ac/Heater hot code 024 and 051 came up on diagnostic what are these codes


You apparently have a problem with the vacuum doors in the heater/ac unit under the dash. When one of these vac motors fails (won't open and close various flaps), the unit will default to either a defrost setting or floor heat setting. Fixing these is not a do-it yourself job as usually the entire dash has to be pulled to get to the failed parts. Sorry
BTW P024 is exhaust camshaft position timing and 051 is an oxygen sensor error....neither have anything to do with the heater.

Nov 25, 2014 | 2004 Ford Crown Victoria

1 Answer

Kia sedona heater


Is the compressor running when the ac is switched on ? Have you checked the freon charge with a gauge ?

May 20, 2013 | Cars & Trucks

1 Answer

My heater is blowing hot air even on cold setting or with ac on


you have a leak in the vaccum line,or the heater control switch is suck.

Dec 21, 2012 | Cars & Trucks

1 Answer

Heater runs too hot


Blend door in heater box has to be adjusted, Or your temperture control switch is not working (Properly)

Oct 31, 2012 | Cars & Trucks

1 Answer

2002 saturn sl1 blows hot air when ac is on heater works idles and coolant leeks out just bought a new radiator still not working


Not sure where to start with this - - if you are saying the engine is running hot could be a thermostat or low coolant or other issues.
The hot air with the ac on could be the ac not being charged or a blend door stuck in one position.
Where is the coolant leaking from ?

Oct 06, 2012 | Cars & Trucks

2 Answers

The heater blows hot air when in cool position on a 98 olds bravada


AC not working?

on a hot day it will blow warm/hot air if the AC is turned off or not working

If its hot air and AC is working then i would start by checking the fuse or relay. if its not the fuse/relay then i would look into the heater box there is a door that blocks the hot air

Jul 14, 2011 | 1998 Oldsmobile Bravada

2 Answers

AC dont work and heater door seems stuck in the heating position


You seem to be on the right track. You can manually jump the compressor clutch, to come on and see if she blows cold air. Follow
the compressor clutch wiring back to the evaporator. There should be
a 2 wire harness there with a connector. Take the wiring connector off
and install a small jumper wire between the 2 terminals. this should
automatically make your compressor clutch engage , regardless of
freon level or head pressure switch condition. You may also have a
vacumm leak, which controls your heater damper actuator. Check all
the vacumm hose in the engine bay and try to locate the damper in
the dash, so you can manually pull the damper open, to see how it
helps your situation.Good luck.

Mar 29, 2010 | 1999 GMC Sierra

1 Answer

Ac compressor goes on an off,even when the a/c is off... The heater works fine ..... The a/c works occaiconally....The system has been filled 2 months ago.... No leakage...... The compressor always stops...


Most cars and trucks are set for the A/C to run in defrost. Even if you have the temp at hot. The air will pass through the evaporator core first witch draws moisture out of the air. That is why you see water dripping out of a car with the air on and sitting at one place.

The dry air makes the defroster work faster. It is a safety feature.

Aug 27, 2009 | 1998 Chevrolet Tahoe

1 Answer

Have a 2000 ford expedition and the ac in the front blows hot but the rear ac works fine. what could it be


Listen and see if the vent flap is moving from the hot position, to the cold position. If that's working then the evaporator may be clogged. It sits inside the same box that the heater core is inside of and if it becomes clogged with hair or dust, then it wont allow the blower to blow through it. But it would then bring hot air through the vents because the heater core is there too.

Jun 15, 2009 | 1998 Ford Expedition

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...